Dakota Digital HDX-2070 User manual

Manual # 650670
HDX-2070
Dakota Digital Universal HDX Instrument Installation
Your new HDX-2070 kit includes:
Installation
Control Box
Main Harness
Universal Sender
Pack
Installation Manuals
HDX Display
Buzzer
Interconnect Harness
1. Use the provided template to mark out the 3 3/8” and 2 1/16” openings needed to fit the HDX
displays. Ensure there is adequate clearance behind the desired mounting location. The display units
need approximately two inches of depth behind the dash.
Mounting Cups
3X Large
4X Small
17X Thumb Nuts
Gaskets
3X Large
4X Small
3X Y Harnesses
2X Extension
Harnesses
2X Terminator
Harnesses

Manual # 650670
2. With the appropriate openings cut, place the HDX displays into the dash, then slide the gasket and
mounting cup over the back of the gauge. Use the supplied thumb nuts to secure each gauge.
3. A combination of harnesses is provided for added versatility. The gauges can be connected in
any order while using the extension harnesses if needed. If you wish to drop any gauges the
terminator harness is needed so there are no open ends for proper operation. The Display gauge
must be used for initial setup and be factored in for harness connections.

Manual # 650670
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
4. Refer to the main manual for wiring instructions to complete the HDX installation.
3. Connect the provided main harness and the buzzer (optional for audio feedback) to the back of
the HDX system.
Buzzer Connecter