Daktronics ALL-SPORT 5000 Manual

SHOT CLOCK SET-UP INSTRUCTIONS
FOR DAKTRONICS ALL-SPORT 5000 CONSOLES
Before Turning On Scoreboard: Ensure
that the shot clock controller (the one with
two reset buttons) is attached to the back
of the console.
When Turning On Scoreboard: Make
sure that the console is in one of the
basketball modes indicated on the insert
(1101, 1102, 1103, 1104, 1105).
If you use the scoreboard in another mode
(such as volleyball), the shot clock will not
work.
Shot Clock Set-Up
1. Press the black MENU button, use the down arrow to go to Settings and press YES/ENTER.
2. Use the down arrow to scroll until the console display reads SHOT CLOCK –MODE –TENTH
SECOND? Make sure this is set to NO.
3. Use the down arrow to scroll until the console display reads SHOT CLOCK –TIME RESET 1. Set this to
35 seconds and then press YES/ENTER. This will set the Reset 1 button on the controller to reset the
shot clock to 35 seconds.
4. Use the down arrow to scroll until the console display reads SHOT CLOCK –TIME RESET 2. Set this to
20 seconds and then press YES/ENTER. This will set the Reset 2 button on the controller to reset the
shot clock to 20 seconds.
5. Use the down arrow to scroll until the console display reads SHOT CLOCK –MODE –SYNC W/MAIN?
Press YES/ENTER.
• This setting syncs the shot clock to start and stop with the game clock, allowing the shot clock
operator to focus only on having to reset after a change of possession.
6. Use the down arrow to scroll until the console display reads SHOT CLOCK –MODE –AUTO BLANK?
Press YES/ENTER.
• This setting will automatically allow the shot clock to shut off when reset with under 35 seconds
left in each quarter.
IN-GAME SHOT CLOCK OPERATION ON BACK SIDE >>>

SHOT CLOCK OPERATION DURING THE GAME
At The Opening Tip: Make sure that the rocker switch on the shot clock controller is on
STOP at the opening tip. Press the switch to CLOCK START once possession is gained
after the jump. NOTE: The shot clock DOES NOT START WHEN THE BALL IS TIPPED. The
shot clock starts when a team clearly gains possession of the ball.
Pro Tip: Consider labeling the buttons on the controller for the appropriate reset times.
The Reset 1 button should reset to 35 seconds. The Reset 2 button should reset to 20
seconds.
In The Event Of A Shot Clock Error: There are two ways to reset
the shot clock in the event of a timing error. Both buttons to reset are
located in the black section of the scoreboard insert between the home
and visiting team controls (highlighted in yellow in the picture).
Manually Setting The Shot Clock: Press SET SHOT TIME, key in
the time and press YES/ENTER.
Recall Shot Time: To recall the last time shown on the clock after a
reset, press RECALL SHOT TIME and then press YES/ENTER.
Prepared by Blake Timm, Pacific University/Forest Grove High School, September 2023