DAVIS Calypso G2 Series User manual

Installation Instruction
Calypso G2 Series
PERFORMANCE:
Model
Luminous
Luminous
Power
Efficacy
Flux
CYS12%AG2xK
80
950
12W
CYS12%EG2xK
63
750
12W
CYL16%AG2xK
80
1300
16W
CYL16%EG2xK
63
1000
16W
% denotes casing colour; B: Black, G: Grey
x denotes CCT; 3:3000K, 4:4000K, 6:6000K
LUMINAIRE DIMENSION:
CAUTIONS:
•Installation is to be completed by a competent licensed electrician, in accordance with these instructions and relevant
local regulations.
•Electronic control equipment must not be subjected to high voltages, DO NOT MEGGER between Live and Neutral.
•All cable/conduit terminations must be installed in accordance with the designated IP rating of this product.
•Suitable installation fastening methods should be employed to ensure the mounting points are not damaged when sub-
jected to vibration and or movement.
•As is the case with all electronic components, it is advisable to fit appropriate surge protection to final sub circuits.
•Choose an installation place capable to withstand 10 times the weight of the product to ensure safety.
Model Dimension (mm)
CYS12%AG2xK
Ø265 x H90
CYS12%EG2xK
Ø265 x H96
CYL16%AG2xK
Ø360 x H105
CYL16%EG2xK
Ø360 x H112
Read all instructions to prevent injury, electric shock or damage due to
fire & mechanical hazard
Ø
H

INSTALLTION:
1. Remove the diffuser
2. Open the PCB by pushing the latch
3. Pull power cord through gasket and seal it to prevent water ingress
4. Fix the base to surface with screws provided
5. Connect supply cable to the terminal block
6. Close PCB
7. Replace the diffuser
MAINTENANCE:
The supply must be isolated before opening or accessing the luminaire. Product maintenance is critical to the product designed
performance. The product is to be maintained in accordance with the manufacturer’s instructions. For the latest product
maintenance guides please go to www.davislighting.com. Davis Lighting is not responsible for any product not maintained in
accordance with the recommended procedure or intervals. For recommended LAMP / LED maintenance guides, please refer to
the lamp installation guidelines supplied with the lamp product or the nominated lamp manufacturer’s website. Products
supplied with visors or covers must not be operate with a damaged visor or cover; it is recommended damaged visors or covers
be replaced by a competent person immediately.
Warning: Maximum loading of earth leakage and circuit protection device.
Note
•The maximum number of ballasts/drivers connected to earth leakage circuit protection device shall not be greater than 60
units for fixed output on MCB 16A or that as recommended by the protective device supplier/manufacturer whichever is the
smaller number.
•The maximum loading of automatic circuit breakers shall not be greater than those shown in the table supplied by the con-
trol gear manufacturer or that as recommended by the protective device supplied/manufacturer whichever is the smaller
number.
Ground
Neutral
Active
7
1
6
2
4
5
3