dB Technologies SYA 15 Manual

www.dbtechnologies.com [e-mail]
SYA 15 Rev 1.1 cod. 420120310
Q ick start ser man al
Section 1
CHECK www.dbtechnologies.com FO THE LAST EVISION OF THIS DOCUMENT, FULL TECH SPECS, AND COMPLETE USE MANUAL
The warnings in this man al m st be observed together with the "USER MANUAL - Section 2"
Le avvertenze nel presente man ale devono essere osservate congi ntamente al “MANUALE D’USO - Sezione2”.
Die Warn ngen in diesem Handb ch müssen in Verbind ng mit der "BEDIENUNGSANLEITUNG - Abschnitt 2" beobachtet
werden”.
Les avertissements specifiés dans ce man el doivent être respectés ainsi q e les "CARACTERISTIQUES TECHNIQUES -
Section 2"
Las advertencias del presente man al se deben tener en c enta conj ntamente con las del “MANUAL DEL USUARIO” -
Sección 2”.
A E B Industriale Srl Via Brodolini, 8 Località Crespellano 40053 VALSAMOGGIA BOLOGNA (ITALIA)
Tel [phone] Fax [phone] www dbtechnologies com info@dbtechnologies-aeb com

www.dbtechnologies.com [e-mail]
SYA 15 Rev 1.1 cod. 420120310
Thank yo for choosing a dBTechnologies Prod ct!
The SYA 15 is a versatile active speaker It is equipped with one 1” compression driver (1 35” voice coil), and one 15”
woofer (2 5” voice coil) The multiple input pattern allows an easy and versatile use For example the user can
connect a dynamic microphone (CH1), an independent source from a mixer (CH2), a Bluetooth MP3 reader (CH3),
controlling each volume level The user can enhance lower and upper frequencies with the convenient DSP preset
function A balanced link output allows the audio connection to a second loudspeaker, choosing among “Mix” or
“Line” output type
Check the site www.dbtechnologies.com for the complete ser man al!
1) Unpacking
The box contains:
N°1 SYA 15
N°1 Rain cover
N°1 Mains cable (VDE)
This quick start and warranty documentation
2) Easy installation
SYA 15 is equipped with:
A –Upper integrated handle
B – Lateral integrated handles
C – Pole mo nt hole, with two tilt angles
selection (0°/ 7.5°)
Those mechanical particulars were thought for an easy
use and for different configuration needs SYA 15 is
perfect for gigging bands as well as small venues
installations The 36 mm pole-mount predisposition is
designed for the use on standard pole stand (like a
tripod)
The acoustical design allows to face different
environments The dispersion pattern is shown in the
upper picture
As described, the related pattern data are:
a) vertical coverage: 60°
b) horizontal coverage: 90°
The rear side inclination, symmetrical, as shown in the
upper picture, is 45° SYA15 can be used as a stage
monitor in small contexts, in this case please consider
the characteristic dispersion pattern presented above
IT IS MANDATORY TO READ AND
FULLY UNDERSTAND THE COMPLETE
USER MANUAL FOR THE ADMITTED
CONFIGURATIONS OF THE PRODUCT, SAFETY
INFORMATION, AND THE PROPER USE OF
ACCESSORIES (IF ANY).
NEVER USE THE HANDLES TO SUSPEND
THE SPEAKER!

www.dbtechnologies.com [e-mail]
SYA 15 Rev 1.1 cod. 420120310
3) Connections, controls, first t rn on
All the connections and controls are in the amplifier
panel side:
CH1:
1–Audio Combo Input (for XLR or TRS connectors)
2–Line/Mic selector
3–Mic/Line Volume Control
CH2:
4–Audio Input (Balanced / TRS)
5–Line Volume control
CH3 (Bluetooth ):
6–BT status sync LED
7–BT Volume Control
MASTER SECTION
8–DSP Preset switch
9–Balanced audio output
10–Link/Mix switch
11–Master Volume with control LEDs
MAINS SECTION
12–VDE MAINS INPUT (with fuse)
13–ON-OFF SWITCH
a) Connect the audio input (1) The combo connector
allows a TRS or XLR connection In case of a dynamic
microphone, plug it and select “Mic” in the Audio input
sensitivity switch (2) In the other cases check that the
switch is set on “Line” Adjust the level of Volume (3)
b) Connect a second input, depending on the kind of
connection (XLR/TRS), then adjust the related volume
level
c) If needed, enable with the switch (7) the Bluetooth
receiver Pair it with a visible device (ex a MP3 reader)
d) If you need to link SYA 15 to another one, please use
a cable with XLR connectors (not supplied) Connect
the Link output (9) of the first, to the balanced Input
(1) of the second one In the second loudspeaker,
please check that Selector (2) is set on “Line” position
and that Volume (3) is set to the correct value
e) Set properly the DSP preset switch (8), choosing
between “Playback”, ”Flat”, Bass Boost” or “Wedge”
configuration
e) Plug properly the mains VDE input cable (supplied)
in the related input (12) Check that the audio source is
set on the minimum level Then switch the POWER
switch (13) to “ON” position Increase gradually the
volume of the audio source to the desired level
Check the site www.dbtechnologies.com for f rther
information, for added accessories and for the
complete ser man al!

www.dbtechnologies.com [e-mail]
SYA 15 Rev 1.1 cod. 420120310
Technical Data
Speaker Type: 2-way active speaker
Acoustical data
Max SPL (1m): 128 dB
Freq ency response (-10 dB): 48 – 18000 Hz
Freq ency response (-6 dB): 52 – 17000 Hz
HF compression driver: 1 " Exit
HF voice coil: 1.35”
LF: 15”
LF Voice Coil: 2.5”
Horizontal dispersion: 90°
Vertical dispersion: 60°
Amplifier
Amp: C stom made, Class-D + A/B– Active Fan cooling
Peak Power: 800 W
Operating voltage ( factory set ):
220-240V~ (50-60Hz) or
110-120V~ (50-60 Hz)
Processor and user interface
Controller: 28/56 bit
AD/DA Conversion: 24 bit, 48 kHz
Advanced DSP f nctions: FIR
Limiter: Peak, RMS, Thermal
Controls: Line/mic, Channel Vol me, Link/Mix, Presets
Input / Output
Mains connections: VDE
Signal Inp ts: 3 channels (Combo, XLR+trs, Bluetooth )
Signal O t: (Balanced) 1x XLR OUT (LINK)
Mechanics
Ho sing: Polypropylene
Handles: 3 (2 on sides. 1 on the top)
Width: 430 mm (16.92 in)
Height: 722 mm (28.44 in)
Depth: 402 mm (15.82 in)
Weight: 19.3 kg (42.54 lbs)
EMI CLASSIFICATION
According to the standards EN 55032 and EN 55035 this eq ipment is designed and s itable to operate in class B electromagnetic environments
FCC ID: 2ADDV-TLSYA12
FCC CLASS B STATEMENT ACCORDING TO TITLE 47, PART 15, SUBPART B, §15.105
This eq ipment has been tested and fo nd to comply with the limits for a Class B digital device, p rs ant to part 15 of the FCC R les.
These limits are designed to provide reasonable protection against harmf l interference in a residential installation. This eq ipment
generates, ses and can radiate radio freq ency energy and, if not installed and sed in accordance with the instr ctions, may ca se
harmf l interference to radio comm nications. However, there is no g arantee that interference will not occ r in a partic lar
installation. If this eq ipment does ca se harmf l interference to radio or television reception, which can be determined by t rning the
eq ipment off and on, the ser is enco raged to try to correct the interference by one or more of the following meas res:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the eq ipment and receiver.
3. Connect the eq ipment into an o tlet on a circ it different from that to which the receiver is connected.
4. Cons lt the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance co ld void the ser’s a thority to operate the
eq ipment.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth® SIG, Inc. and any use of such marks by AEB
Industriale S L is under license. Other Trademarks and trade names are those of their respective owner.
RED CERTIFICATION
Hereby, AEB Ind striale declares that SYA lo dspeaker is in compliance with Directive 2015/53/EU, in reference to the following
harmonized standards:
Health & Safety EN 62479 / EN 62368-1+A11
EMC EN 301 489-1 V2.2.0, EN 301 489-9 V2.1.1, EN 55032, EN 55035
Spectr m EN 300 328 V2.1.1
SIMPLIFIED EU DECLARATION OF CONFORMITY
The full text of the EU declaration of conformity is available at the following internet address:
http://www.dbtechnologies.com/en/downloads
Features, specification and appearance of products are subject to change without notice. dBTechnologies reserves the right to make changes or
improvements in design or manufacturing without assuming any obligation to change or improve products previously manufactured.
Scan with your Q eader App to download
the complete User Manual
Download the complete user manual from the site:
www dbtechnologies com/EN/Downloads aspx