decakila KUEN004P User manual

KUEN004P
STEAM CLEANER

IMPORTANT SAFETY INSTRUCTIONS
TECHNICAL DATA
ELECTRICAL WIRING
DESCRIPTION OF THE APPLIANCE
CHARACTERISTICS
ACCESSORIES
HOW TO USE
MAINTENANCE
TROUBLESHOOTING
01
04
04
05
06
06
06
08
09
CONTENTS

01
IMPORTANT SAFETY INSTRUCTIONS
Warning! Beware that the nozzle gets very hot during operation.
Danger of scalding! Do not come into contact with withdrawing steam.
Always keep this appliance away from children! Children shall not use the product and shall not play with it.
Do not leave the appliance unattended while it is switched on. Unplug the appliance from the mains supply socket before each
cleaning/maintenance and before you ll/empty the water tank.
WARNING: This appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance.
Aer removing the packing materials, check the integrity of the appliance. The packing materials ( plastic bags, polystyrene foam,
etc.) must be kept out of the reach of children because they are potential source of danger; dispose them according to current
regulations, in dedicated containers for dierent disposal.
The manufacturer can not be held responsible for any damage caused by improper, incorrect and irresponsible and or repair by
unqualied personnel.
Keep the cord away from heating surfaces.
Do not use with wet feet or wet hands
If the supply cord is damaged, it must be replaced by the manufacturer, its service Authorized Service Center in order to avoid a
hazard.
Before connecting the appliance make sure that the mains voltage corresponds to the data specied on the label. The appliance
can be damaged if the voltage is not correct..
Never immerse the product in water or any other liquid.
Product can be damaged if it has fallen down or it is subjected to shocks. Don’t use it in case of falls or in case of leakage of water
Keep the product t out of reach of children.
The use of extension leads not recommended by the manufacturer may cause damage or accidents.

If the power cord is damaged, it must be replaced either by the manufacturer or by a Technical AssistanceCentre or similarly
qualied person, so as to prevent any risk.
Never place energised parts in contact with water: danger of short circuits!
Never use to clean up liquids.
Never touch the appliance with wet hands or feet.
Never use the appliance with bare feet.
Unplug the appliance from the mains power before carrying out any cleaning or maintenance.
Never place the appliance in water or other liquids.
Make sure that the power cord is not in contact with hot or sharp surfaces.
In case of breakdowns, failures or suspected faults aer a fall or being dropped, unplug the appliance from the mains immediately.
Never use a faulty appliance.
Repairs may be done by an authorised Assistance Centre only.
Don't leave the product unattended when it is plugged. Disconnet the plug any time product is not in use.
Do not place heavy objects on the cables or heat sources close to them . The cables may be damaged;
This product is intended solely for domestic use. Unplug the appliance when it is upside down or resting;
Before carrying out any cleaning or maintenance, disconnect the appliance from the mains by removing the plug.
In case of abnormal situations immediately turn o the power and contact your dealer or service center;
Do not use this unit connected to programmers, external timer , remote control system of separate timer or any other device that
can switch automatically;
Do not use power sockets ying or damaged cables;
When you connect or disconnect the power rmly pulls the plug to avoid electric shock, short circuit or re;
Avoid the contact of the product with water or any other liquid.
Do not expose to outdoor elements
Do not attach safety switches with tape, for re hazard;
It is absolutely prohibited to disassemble or repair the unit by the danger of electric shock if necessary contact your dealer or

03
service center;
Do not use the appliance near a bathtub, shower, swimming pool;
Do not use the product near ammable objects;
Before connecting to the mains supply, make sure the voltage is correct as reported on the label of the product and that the
installation complies with current regulations.
Do not touch the power connection with wet hands;
Do not use the product for purposes other than those for which it was built;
The appliance must be kept out of children’s reach and can’t be used by children.
In order to ensure safety, the appliance should only be assembled as set out in the instructions for use and connected and operated
in accordance with the model plate. Use only the accessories, which are recommended by manufacturer.
Examine the appliance before use in order to detect signs of damage. Do not operate if the appliance, its power cord or plug shows
any signs of damage. In order to comply with safety regulations and to avoid hazards out by qualied personnel. If repair is needed,
send the appliance to one of our customer service center.
The appliance can’t be operated, if the power cord or plug is damaged. Do not use the power cord to carry the appliance. Beware
that the power cord does not come into contact with hot surfaces.
Check the appliance and the mains wire before each use for perfect status.
Aer the use unplug the appliance from the mains supply socket. Never leave the product unattended when powered.
During the operation keep the openings and the air outlet always free for good air ventilation.
Make sure that the appliance does not be tilted over 45 during the operation. When the appliance is in operation the nozzles should
not be directed toward humans, animals or plants.
Fill only water in the appliance. Descaler, perfume. Detergent etc. should not be used with this appliance, in order to avoid damages
of the appliance.
Filling the water:
a.Unplug the appliance from the mains supply socket.
b.Press the steam button to release the residual pressure.

04
c.Let the appliance cool down.
d.Press the steam button again to release the residual pressure.
e.Release the safety lid and remove it in about 5 minutes.
Warning! The appliance heats up in the operation therefore
do not touch the hot surface; use only the grasps or buttons.
Always let the appliance cool down, before accessories are
removed or attached from it.
If the supply cord is damaged, it must be replaced by the
manufacture or its service agent or a similarly qualied person
in order to avoid a hazard.
Before each cleaning/maintenance unplug the appliance from
the mains supply socket and let it cool down enough time.
TECHNICAL DATA
Rated voltage 120V~ 50/60Hz
Power 1000W
Operating temperature -20°C a 50°C
Dimensions 25x13x22cm
Operating pressure 300Kpa
ELECTRICAL WIRING
This appliance must be attached to a mains supply socket with
grounding; therefore it is equipped with a mains cable with
ground wire.
Warning! Only a qualified person is allowed to check your
mains supply socket. Never try to modify or change the mains
plug of the appliance.
WARNING: HOT STEAM – BURN HAZARD

05
1. Housing
2. Handle
3. Steam button
4. Accessory connection
5. Safety lid
6. Power control lamp
7. Mains cable
8. Rubber scaling
9. Measuring nozzle
10. Funnel
11. Straight nozzle
12. Scrubbing brush
13. Cloth
14. Window wiper
15. Hose
16. Brush
17. Curved nozzle
DESCRIPTION OF THE APPLIANCE

06
CHARACTERISTICS
This appliance is everywhere applicable and very flexible; in
addition you need only ll water in it. It cleans, degreased and
disinfects completely without chemistry (over 100 ℃) and it
suitable for dierent materials and areas e.g. windows, clothing,
garden furniture, bicycles, tiles etc. Warning! Never direct this
appliance at humans or animals. This appliance is also ideal for
disinfecting of refrigerators, baths, smell distance of clothing and
mite ght in mattresses, pillows and carpets.
ACCESSORIES
Brush: for kitchen, tiles etc.
Window wiper: for window, mirror, glass, door etc.
Caution! Do not uses on cold glass directly.
Scrubbing brush: for curtains and clothing etc. be
used together with cloth and hose.
Curved nozzle: for toilets and the areas, this is
diiculty to reach.
Hose: Ideal to the extension of the accessories
HOW TO USE
Cautions! This appliance should not be used directly on so
plastics, non pre-treated wood and cold glass.
Caution! Steam could damage the furniture surface. For a safe
work please execute a test run before. Pay attention to the
appropriate maintaining notes of the manufacturer.
ASSEMBLY
(Do not attach the appliance to the power supply until point 7.)
Warning! After the use press the steam button to reduce the
internal pressure suiciently. Then you can release the safety lid.
1.Release the safety lid.
2.Fill appropriate water into the water tank. Please use the
provided measuring cup and the funnel. It is recommended that
you ll the tank to max 2/3 full. Note: Never ll descaler, perfume
Straight nozzle: for joints, shelf etc.

07
5.The brush and the curved nozzle:
The brush and the curved nozzle can be assembled on the
hosing, with the hose or the straight nozzle. (Figure)
6.Window wiper:
Warning! Do not operate this appliance directly on cold glass.
The window wiper must be rattached to the scrubbing brush.
Assemble the scrubbing brush in the appliance or the hose at
rst. Take o the cloth from the scrubbing brush and connect
with window wiper to the brush by the two hinges (gure). The
window wiper can be dismantles easily by loosening the hinges
again.
or detergent into the water tank, in order to avoid damages of
the appliance.
3.Close the safety lid again.
4.Put the desired accessory (nozzle, hose, scrubbing brush etc.)
on the appliance: set the accessory on the connection and press
it up to the rubber sealing. Turn the accessory in the clockwise
direction, until it locks into the position. (Figure)
OPERATION
7.Attach the appliance to the mains supply and the control
lamp lights up. As soon as the preheating (about 3-4 min) is
terminated, the control lamp goes out.
Make sure that you can not switch the appliance on during the
preheating process. Switch the appliance on and move it slowly
over the surface, which is to be cleaned. It is recommended that

08
the distance between the nozzle and the surface amount to 2-3
cm.
It is normal that the control lamp switched on and off during
the process, since the thermostat controls the heating element
automatically.
Warning! The appliance can not be tilted over 45℃during the
operation. Direct the appliance never toward humans, animals
or plants.
8.Relling the water tank:
Unplug the appliance from the mains supply socket. Press the
steam button and release the internal pressure completely. Wait
approx. 3 minutes and release the safety lid slowly. After the
appliance is cooled down, ll the water tank up to 2/3 full. You
can use the provided funnel and the measuring cup.
Close the safety lid and attach the appliance to the mains supply
again.
Warning! Before you release the safety lid, make sure that the
internal pressure is suiciently reduced.
9.After the operation unplug the appliance from the mains
supply socket and empty the water tank.
10.Descaling: In order to maintain the excellent quality of your
cleaner, we recommend you to descale the appliance at regular
intervals (once monthly). Make sure that not any vinegar or other
descaler should be used.
Fill the water tank only with water. Vibrate the appliance by hand
and empty the tank aerwards.
Warning! Never immerse the appliance into water.
MAINTENANCE
This appliance requires with normal operation conditions not
any special maintenance.
Do not try to repair the appliance. Repairs of electrical appliances
must be carried our by qualied personnel.