Dell CHC7229 User manual

14
Regulatory: DellTM Rackmount Flat Panel Color Monitor User’s Guide
Energy Efficiency
The proper operation of the function requires a computer with VESADPMS power
management capabilities. When used with a computer equipped with VESA DPMS,
the monitor is ENERGY STARcompliant.
As an ENERGY STARPartner, Dell Computer Corporation has determined that
this product meets the ENERGY STARguidelines for energy efficiency.
Federal Communications Commission (FCC) Notice (U.S. Only)
WARNING: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
lReorient or relocate receiving antenna.
lIncrease the separation between the equipment and receiver
lConnect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
l
Consult the dealer of an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following twoconditions:
lThis device may not cause harmful interference
lThis device must accept any interference received including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
FCC Declaration of Conformity
According to 47 CFR, Part 15 of the FCC Rules
*For the following named produce:
LCD MONITOR (Category Name)

15
Rackmount / DELL
(Model No / Brand Name) CHC7229 (Basic Model)
*Manufactured at: CompalElectronics,Inc.
We hereby declare th
at this device complies with Part 15 of the
FCC Rules.
Operation is subject to the following two conditions:
l
This device may not cause harmful interference, and
lThis device must accept any interference received,
including interference that may cause undesired
operation.
*FCC Rules: Tested to comply with FCC part 15, class B
*Test site at:
*Responsible Party for Produce:
Compliance: CompalElectronics,Inc. NO.581,Juikuang Rd.
Neihu ,Taipei, Taiwan, R.O.C. 114
Tel)+(886)-2-8797-8588
Fax)+(886)-2-2658-3168
*Manufacturer Information: CompalElectronics,Inc.Safety
Dept.
NO.581,Juikuang Rd.
Neihu ,Taipei, Taiwan, R.O.C. 114
Safety Dept.
Manager
Suppliersignature
Win Chen
EU Declaration of Conformity (LVD,EMC)
For the following product:
LCD MONITOR (category name)
Rackmount (model name)
Manufacturedat: CompalElectronics,Inc.
8, Nan-Tung Rd., Pin-Cheng City Taoyuan Hsien, Taiwan
R.O.C.
We hereby declare, that all major safety requirements, concerning to CE-Mark
Directive(93/68/EEC) and Low Voltage Directive (73/23/EEC), Electromagnetic
Compatibility Directives (89/336/EEC, 92/31/EEC) are fulfilled, as laid out in the
guidelines set down by the member states of the EEC Commission. This
declaration is valid for all samples that are part of this declaration, which are
manufactured according to the production charts appendix. The standards
relevant for the evaluation of electrical safety & EMC requirements are as follows:
LVD:EN60950:1992 +A1+A2+A3+A4
EMC:EN50082-1:1997, EN55022:1995, EN61000-3-2 & 3:1995
1. Certificate of conformity /Test report issued by:
LVD:TÜV
2. Technical documentation kept at:
Compal Electronics, Inc.
Which will be made available upon request.(Manufacturer)
Compal Electronics, Inc.
NO.581,Juikuang Rd.
Neihu ,Taipei, Taiwan, R.O.C. 114
Safety Dept.
Manager
Win Chen

16
Canadian Regulatory Information (Canada Only)
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of
Communications.
Note that Canadian Department of Communications (DOC) regulations provide, that changes or
modifications not expressly approved by Dell Computer Corporation could void your authority to
operate this equipment.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le
matériel brouilleur du Canada.
EN 55022 Compliance (Czech Republic Only)
VCCI Class 2 Notice (Japan Only)
This equipment complies with the limits for a Class 2 digital device (devices used in or adjacent to
a residential environment) and conforms to the standards for information technology equipment
that are set by the Voluntary Control Council for Interference for preventing radio frequency
interference in residential areas.
Class B ITE
MOC Notice (South Korea Only)
Class B Device
Please note that this device has been approved for nonbusiness purposes and may be used in
any environment, including residential areas.

17
Polish Center for Testing and Certification Notice
The equipment should draw power from a socket with an attached protection circuit (a
three-prong socket). All equipment that works together (computer, monitor, printer, and
so on) should have the same power supply source.
The phasing conductor of the room's electrical installation should have a reserve short-
circuit protection device in the form of a fuse with a nominal value no larger than 16
amperes (A).
To completely switch off the equipment, the power supply cable must be removed from
the power supply socket, which should be located near the equipment and easily
accessible.
A protection mark "B" confirms that the equipment is in compliance with the protection
usage requirements of standards PN-93/T-42107 and PN-89/E-06251.
NOM Information (Mexico Only)
The following information is provided on the device(s) described in this document in compliance
with the requirements of the official Mexican standards (NOM)
Exporter: Dell Computer Corporation One Dell Way
Round Rock, TX 78682
Importer: Dell Computer de México, S.A. de C.V. Rio Lerma No. 302 -4° Piso
Col. Cuauhtemoc 16500 México, D.F.
Ship to: S.A. de C.B. al Cuidado de Kudhne & Nagel de México S. de R.I., Avenida Soles No.55
Col. Peñon de los Baños, 15520 México, D.F.
Supply voltage:
Current consumption: 12VDC, 2A

18
Información para NOM (Únicamente para México)
La informaciónsiguiente se proporciona en el despositivo o en los dispositivos descritos en este
documento, en cumplimiento con los requisitos de la Norma Oficial Mexicana (NOM):
Exporter: Dell Computer Corporation One Dell Way
Round Rock, TX 78682
Importador: Dell Computer de México, S.A. de C.V. Rio Lerma No. 302 -4° Piso
Col. Cuauhtemoc 16500 México, D.F.
Embarcar a: S.A. de C.B. al Cuidado de Kudhne & Nagel de México S. de R.I., Avenida Soles No.55
Col. Peñon de los Baños, 15520 México, D.F.
Tensión alimentación:
Consumo de corriente: 12VDC, 2A
BCIQ Notice (Taiwan Only)
Ergonomics Notice (Germany Only)
Under the requirements of German ergonomics standard ISO09241-3/-7/-8, graphics or
characters:
lBlue graphics or characters in dark background are not recommended. (This
combination may increase eye fatigue due to poor visibility caused by low
contrast.)
lGraphics controller and monitor are recommended to be used in the following
conditions:
¡Vertical frequency: 56Hz or higher.
¡Display mode :Dark characters in bright abckground.
Ergonomie Hinweis (nur Deutschland)
Um den Anforderungen der deutschen Ergonomie-Norm ISO9241-3/-7/-8 zu
antsprechen.
l
Wird empfahlen, die Grunfarbe Blau nicht auf dunklem Hintergrund zu
verwenden (schiechte Erkennbarkeit. Augenbelastung bei zu geringem
Zeicheenkontrast).
lWird folgende Einstellung des Grafik-Comtrlooers und Monitors empfohlen.
¡Vertikalfrequenz: 56Hz oder hoher.
¡Ohne Zellensprung.

19
Dell Computer Corporation’s Environmental Program
Design for Recyclability
Your Dell equipment complies with the following principles of recclable design:
l
Avoidance of nonseparable connections, such as gluing and welding, between
different materials
lAvoidance of coatings and composite struncture materials
lUse of as few dirrerent materials as possible
lDesigned for ease of disassembly:
¡Subassemblies, cables, and components easily detachable by one person
working alone
¡Minimal use of screws
¡Most disassembly can be done by hand or with the aid of a standard 6-
millimeter (1/4-inch) nut driver only
Dell’s Blue Angel Disposal Program
Rapid technological advances lead to a high turnover in computer products, as
customers upgrade their systems at an ever-
increasing rate. To address the
mounting problem regarding the indiscrimina
te disposal of unwanted products, and in
anticipation of future legislation, Dell gas instituted a disposal program, called Green
Away, for the collection and disposal of these products.
Dell’s Green Away Program
Dell’s Green Away program is a free materia
l return and disposal service for Dell
customers, covering computer products sold by Dell under the environmental label
plans. The returned products are reused, recycled, or disposed or as appropriate,
in accordance with local environmental guidelines.
N
OTE: The Green Away program is designed to dispose of unwanted or
unusable products under the environmental label plans. For returned material
discount on recent purchases, or for recycling of equipment neither sold by Dell
nor covered by the environmental
label plans, contact your local Dell Asset
Management specialist.
In carrying out this proguam, Dell’s general responsibilities include the following:
lOrganizing the reuse/recycling/disposal of the equipment
lEnsuring that all disposal/recycling practices meet local environmental
regulations
lMonitoring the process to ensure compliance and facilitate process
improvement

20
How the Green Away Program Works
When you have one or more items of equipment that you would like to dispose of,
contact your local
Dell customer service department to request instructions. The returns
coordinator processes the request and advised you on the return of your material. Refer
to “Green Away Collection Sites” found later in this document for the telephone number
and collection point in your area.
Note:”Shells” (equipment from which integral components, such as
chips and power supplies, have been removed) are not accepted as part of this
free program. If a shell is discovered in your shipment, you will be asked to
either collect the system or pay for its disposal.
The equipment is transported to Dell’s Green Away partner, where it is assessed and
disposed of as follows:
l
If judged resell able, the Dell label is removed and the equipment is tested,
repaired, and resold.
l
If judged beyond repair, the equipment is dismantled, and usable pares are
offered for sale.
Unable parts are dispose of as follows:
lMetal cases are sold to metals recyclers.
lPrinted circuit boards and cases are sent to refiners.
lPlastic parts are sent to plastic recyclers.
lUnusable packaging is sent to paper recycles.
Monitors are sent to recycling companies to be disposed of as follows:
l
The tubes are washed and the luminescent powder is recovered, some
elements are extracted for reuse, and the remainder is disposed of via
controlled incineration.
lGlass is sorted and sent to the lead smelter or recycled for glass works.
lThe planar mask and the iron are sent for reuse to metals recyclers.
lItems that are not reusable are mainly incinerated. However, if certain residues
on the items are not allowed in hazardous waste incinerators, the Dell Green
Away partner transports the items to a secured (bundled) hazardous waste
landfill.
Spare Parts Policy
Dell commits to retaining stocks of s
pare parts (or reasonable alternatives) for a period of five
years from the termination of production of the Dell system component-
for example, the base
system, the keyboard, or the monitor.
Use of chlorine-free paper (Europe Only)
As part of Dell’s policy
to reduce the impact on the environment of obsolete item disposal and in
compliance with guidelines in many geographical locations, all Dell documentation supplied with
Dell equipment is printed on paper (fresh fiber from sustainable resources or recycled
waste
paper) bleached without the use of chlorine.
Green Away Collection Points
The table lists the country specific customer service telephone number along with the address for
the Green Away collection site. For Germany, the Green Away collection site
telephone number is
listed rather than the customer service number.
NOTE: Locations marked with an asterisk (*) are facilities approved for battery
disposal. As Dell expands the network of Green Away centers, additional addresses will
be available across
Europe. Contact your local Dell customer service department for
information about the availability of Green Away services in your location.

21
Country: Telephone Address
Belgium 02 481 91 00 R Frazier Ltd. Plantijnweg 15
4104 BC Culemgorg, Netherland
Denmark [phone] WMI Sellbergs AB
Box 1294
S-171 25 Solna, Sweden
Finland [phone] WMI Selbergs AB Box 1294
S-171 25 Solna, Sweden
Germany:
Northern Germany* 0130-86 12 51 Bockmann/Ohlig Tersteegenstrasse 21a
42653 Solingen
Southern Germany* 0130-86 12 51 Knab
Carl Benz Strasse 8-10
35440 Linden
Netherlands 02 481 91 00 R Frazier Europe Plantijnweg 15
4104 BC Culemborg, Netherland
Norway [phone] WMI Sellbergs AB
Box 1294
S-171 25 Solna, Sweden
Sweden [phone] WMI Sellbergs AB Box 1294
S-171 25 Solna, Sweden
United Kingdom* 0800 783-3124
R Frazier Ltd.
Irongray Business Park
Lochside Industrial Estate
Dumfries
DG2 0NR