Dell PowerConnect 2216 User manual

www.dell.com | support.dell.com
0K5672A00
Dell™ PowerConnect™ 2200/2300 Series Ethernet Switches
Introduction
This document describes changes to the technical specifications of the PowerConnect 2200/2300
series Ethernet switches. This information replaces and supercedes that found in the
Dell
PowerConnect 2216/2224/2324 Switches User’s Guide
. Where any differences exist in the
specifications or procedures between the two documents, the information in this document is
more accurate.
Product Specifications
• PowerConnect 2216
– Provides 16 ports supporting 10/100Base-T Ethernet.
– All ports support full- or half-duplex mode and PAUSE frames.
• PowerConnect 2224
– Provides 24 ports supporting 10/100Base-T Ethernet.
– All ports support full- or half-duplex mode and PAUSE frames.
• PowerConnect 2324
– Provides 24 ports supporting 10/100Base-T Ethernet and an additional 2 ports supporting
1000Base-T Ethernet.
– The 10/100Base-T ports support full- or half-duplex mode; the 1000Base-T ports support
full-duplex mode only.
– The 10/100Base-T ports support PAUSE frames; the 1000Base-T ports do not support
PAUSE frames.
Front-Panel Indicators
1000Base-T Ports Link/Activity (SPD/LNK/ACT) LED (PowerConnect 2324 only)
• Steady green — A 1000 Mbps link has been established, but no data is being transmitted
or received.
• Blinking green — A 1000 Mbps link has been established and data is being transmitted
or received.
• Off — No link has been established.
NOTE: No link will will be detected if a 10/100Base-T device is connected to a 1000Base-T port (ports 25
and 26) on the PowerConnect 2324 switch.
February 2004
K5672A00.fm Page 1 Friday, February 20, 2004 3:45 PM

www.dell.com | support.dell.com
Additional Troubleshooting Step
The following information is in addition to that found in Table 2-1 in the Dell PowerConnect
2216/2224/2324 Switches User’s Guide
.
____________________
Information in this document is subject to change without notice.
© 2004 Dell Inc. All rights reserved. Printed in China.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell, the DELL logo, and PowerConnect are trademarks of Dell Inc.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names
or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.
Problem Probable Cause Corrective Action
Link LED is not lighted A 10/100Base-T-capable device or
1000Base-T half-duplex device is
connected to a 1000Base-T port
(ports 25 and 26) on a
PowerConnect 2324 switch.
Connect only 1000Base-T full-
duplex capable devices to ports
25 or 26 on the PowerConnect
2324 switch.
K5672A00.fm Page 2 Friday, February 20, 2004 3:45 PM