DeLonghi BAMBINO User manual

instructions
Bambino Oil Filled Radiators
BAMBINO 21-04-2004 9:58 Pagina 1

Oil Filled Radiator 2
Thermostat
Neon indicator on/off switch
Foot
BAMBINO 21-04-2004 9:58 Pagina 2

Thank you for choosing this oil filled radiator. To get the very
best out of your new radiator it is advisable to read these
instructions before using the appliance. This is the only way
to ensure optimum results and maximum safety.
General instructions
Remove the heater from the packaging.
Check that neither the heater nor the power cable has been dam-
aged in any way during transportation.
Do not operate the heater if damaged.
Using for the first time
On using the appliance for the first time, turn it on to the maxi-
mum power setting for at least 8 hours.This is to eliminate the
'new odour’, which is released by the appliance. During this time
ensure that the room is well ventilated.
Electrical connection
-Before plugging the radiator into the mains, check that your
supply voltage is the same as that shown on the rating plate of
the appliance.
- If using more than one appliance at a time, it is important to
ensure that the ring main is adequate to cope with the power
requirements.
- It is important to ensure that the socket is adequately earthed.
- This appliance complies with EEC Directive 89/336 relating to
electromagnetic compatibility.
How to use it
Switching on
Switching on
Plug into the mains socket.Turn the thermostat to maximum.
Switch the radiator on using the switch/switches following the pro-
cedures given in points a) - b).
a) Models with single switch (1 power level):
-button in position «I» = Total power on (indicator light on);
-button in position «O» = (indicator light off)
b) Models with double switch (3 power levels)
-button in position «l» = minimum power (indicator light on);
-button in position «ll» = intermediate power (indicator light
on);
-both buttons in position «l» «ll» = maximum power
(indicator lights on)
To turn appliance off, switch off both switches or remove plug
from wall socket.
Oil Filled Radiator
3
BAMBINO 21-04-2004 9:58 Pagina 3

Frost protection function
Turn the thermostat dial to the *position and press the switches.
The appliance will maintain a minimum room temperature of
approximately 5°C thus preventing freezing with a minimum
energy consumption.
Maintenance
Before carrying out any maintenance, unplug the heater from the
mains and wait for it to cool.
The oil-filled electric radiator requires no particular maintenance.
It is sufficient to remove the dust with a soft, dry cloth. Never use
abrasive powders or solvents. If necessary remove concentrated
areas of dirt with a vacuum cleaner (Fig. 1).
Warnings
-Do not make use of this heater in the immediate proximity of showers,
bathrubs, sinks, swimming pools etc.
-Never use the heater to dry laundry.
-Never place the power cable on top of the heater while it is hot.
-Only use the heater in an upright position.
-The heater must be positioned at least 50cm from furniture or other
objects.
-If the power cable is damaged, it must be replaced by the manufacturer
or an authorised technical service centre.
-It is normal for the heater to make 'crackling' noises during the first
time it is switched on (or in the case of infrequent use)
-The body of the heater is filled with an exact quantity of oil. If repairs
are necessary which call for the opening of the heater, they must be
done only by the manufacturer or by an authorised service centre. In
the unlikely event of oil leakage, contact the manufacturer or by an
authorised service centre.
-The heater must never be placed immediately under a fixed mains socket.
-When scrapping the appliance, respect legislation on the disposal of oil.
-IMPORTANT: Never for any reason cover the appliance during
operation as this could lead to dangerous overheating.
-The use of an extension lead is not recommended, however if it is
neccessary then follow carefully the extension lead’s instructions, and
most importantly ensure that the extension lead is correclty rated in
accordance with the heater being used and NEVER overloaded.
fig. 1
Oil Filled Radiator 4
Adjusting the thermostat
Leave the thermostat at its highest setting until the room has
reached the required temperature.Then slowly turn the thermo-
stat back until the indicator light goes off (or until you hear a
click).The temperature selected in this way will then be regulated
automatically and kept constant by the thermostat.
BAMBINO 21-04-2004 9:58 Pagina 4

Oil Filled Radiator
5
-As with any electrical appliance, whilst the instructions aim to cover as
many eventualities as possible, caution and common sense should be
applied when operating your appliance, particularly in the vicinity of
young children.
The appliance is fitted with a safety device which will switch off it in case of
accidental overheating.To reset, disconnect the plug from the power for 30
minutes, remove the cause of overheating then plug the appliance in again.
ATTENTION: in order to avoid any danger caused by an accidental
resetting of the safety system, this appliance must not be powered through
an external timer.
BAMBINO 21-04-2004 9:58 Pagina 5

Oil Filled Radiator 6
Electrical requirements
Before using this appliance ensure that the voltage indicated
on the product corresponds with the main voltage in your
home, if you are in any doubt about your supply contact your
local electricity company.
The flexible mains lead is supplied connected to a B.S. 1363 fused plug
having a fuse of 13 amp capacity. Should this plug not fit the socket out-
lets in your home, it should be cut off and replaced with a suitable plug,
following the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should
therefore be properly disposed of and not left where children might find
it and plug it into a supply socket - with the obvious consequent danger.
N.B. We recommend the use of good quality plugs and wall sockets that
can be switched off when the machine is not in use.
important: the wires in the mains lead fitted to this appliance are
coloured in accordance with the following code:
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured green and yellow must be connected to the
terminal in the plug which is marked with the letter E or by the earth
symbol or coloured green or green and yellow.
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are securely
retained in each terminal. Do not forget to tighten the mains lead clamp
on the plug. If your electricity supply point has only two pin socket out-
lets, or if you are in doubt, consult a qualified electrician.
Should the mains lead ever require replacement, it is essential that this
operation be carried out by a qualified electrician and should only be
replaced with a flexible cord of the same size.
After replacement of a fuse in the plug, the fuse cover must be refitted.
If the fuse cover is lost, the plug must not be used until a replacement
cover is obtained.The colour of the correct replacement fuse cover is
that of the coloured insert in the base of the fuse recess or elsewhere
on the plug. Always state this colour when ordering a replacement fuse
cover.
Only 13amp replacement fuses which are asta approved to B.S. 1362
should be fitted.
This appliance conforms to the Norms EN 55014 regarding the sup-
pression of radio interference.
Warning - this appliance must be earthed
GREEN ANDYELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE
Green and Yellow to Earth
Blue to
Neutral
13 amp
Fuse
Brown
to Live
Cord Clamp
BAMBINO 21-04-2004 9:58 Pagina 6

5705001300/04.04
BAMBINO 21-04-2004 9:58 Pagina 7