Delta Electronics SFBD-1250A4Q1R User manual

SFBD-1250A4Q1R
DELTA ELECTRONICS, INC.
1 Revision: S0
04/12/2007
www.deltaww.com
Small Form Factor Bi-Directional Transceiver
Module for Gigabit Ethernet
FEATURES
 RoHS compliant
 IEEE802.3ah Gigabit Ethernet compliant
 SFF package with bi-directional SC
receptacle
 Upstream 1.25Gbps transmitter with 1310nm
FP Laser, and downstream 1.25Gbps receiver
with 1490nm PIN-TIA
 Integrated with WDM filter to cut 1550nm and
1650nm optical signal off
 Single +3.3V power supply
 LVTTL Transmitter Enable input and Rx
Signal Detect output
 Laser Class 1 Product which comply with the
requirements of IEC 60825-1 and IEC 60825-2
Description
The SFBD-1250xxxx series are 3.3V small
Form Factor Bi-Directional Transceiver Module
designed expressly for high-speed
communication applications that require rates of
up to 1.25Gbit/sec. It is compliant with the
Gigabit Ethernet standards, as well as the SFF
Multisource Agreement (MSA).
The module consists 1310nm FP laser,
InGaAs PIN, Preamplifier and WDM filter in a
high-integrated optical sub-assembly, and it is
contained in a standard SFF package with a
9/125um SC receptacle connector.
Application
 IEEE 802.3ah 1000BASE-BX10-U
 GE-Media Converter
 Gigabit Ethernet P2P Optical Network
 FTTx WDM Broadband Access
 SFBD-1250A4Q1R data link up to 10km in
9/125um single mode fiber.

SFBD-1250A4Q1R
DELTA ELECTRONICS, INC.
2 Revision: S0
04/12/2007
www.deltaww.com
1. Absolute Maximum Ratings
Parameter Symbol Min. Typ. Max. Unit Note
Storage Temperature Ts -40 85 ºC
Storage Ambient Humidity HA5 95 %
Power Supply Voltage VCC -0.3 4 V
Signal Input Voltage -0.3 Vcc+0.3 V
Receiver Damage Threshold +3 dBm
Lead Soldering Temperature TSOLD 260 ºC
Lead Soldering Time tSOLD 10 sec
2. Recommended Operating Conditions
Parameter Symbol Min. Typ. Max. Unit Note
Ambient Operating Temperature TA0 70 ºC
Without air flow
Ambient Humidity HA5 85 %
Non-condensing
Power Supply Voltage VCC 3.13 3.3 3.47 V
Power Supply Current ICC 300 mA
Power Supply Noise Rejection 100 mVp-p 100Hz to 1MHz
Data Rate 1.25
-100ppm 1.25 1.25 +100ppm Gbps
Transmission Distance 10 km
3. Specification of Transmitter
Parameter Symbol Min. Typ. Max. Unit Note
Average Launched Power PO-9 -3 dBm Note (1)
Launched power (Peak.) PP0 dBm
Extinction Ratio ER 9 dB
Center Wavelength λC1260 1310 1360 nm FP Laser
Spectrum Width (RMS) σCompliant with IEEE 802.3ah nm Note (4)
Transmitter OFF Output Power POff -45 dBm
Optical Rise/Fall Time tr/tf260 ps Note (2)
Total Jitter tJ227 ps Note (3)
Optical Return Loss Tolerance ORLT 12 dB
Relative Intensity Noise RIN12OMA -113 dB/Hz
Optical Transmitter Reflectance -6 dB
Transmitter and Dispersion Penalty TDP 3.3 dB
Output Eye Mask
{X1,X2,Y1,Y2,Y3}
Compliant with IEEE 802.3ah
{0.22,0.375,0.20,0.20,0.30} Note (5)
Note (1). Launched power (avg.) is power coupled into a single mode fiber with master connector.
Note (2). These are unfiltered 20-80% values.
Note (3). Measure at 27-1 NRZ PRBS pattern

SFBD-1250A4Q1R
DELTA ELECTRONICS, INC.
3 Revision: S0
04/12/2007
www.deltaww.com
Note (4): Spectral Width (RMS)
Note (5). Transmitter eye mask definition
4. Specification of Receiver
Parameter Symbol Min. Typ. Max. Unit Note
Input Optical Wavelength λIN 1480 1490 1500 nm PIN-PD
Receiver Sensitivity PIN -23 dBm Note (1)
Input Saturation Power (Overload) PSAT -3 dBm
Signal Detect -Assert Power PA-24 dBm
Signal Detect -Deassert Power PD-44 dBm Note (2)
Signal Detect Hysteresis PA-PD0.5 2 5 dB
Data Output Rise/Fall time tr/tf260 ps Note (3)
Optical Receiver Reflectance -12 dB Note (4)
1260 to 1360nm -43 dB
1550 to 1560nm -33 dB
Optical Isolation
from External
Source 1640 to 1665nm -33 dB
Note (1). Measured with Light source 1490nm, ER=9dB; BER =<10-12@PRBS=27-1 NRZ
Note (2). When SD deasserted, the data output is Low-level (fixed)
Note (3). These are 20%~80% values.
Note (4). Measured at wavelength of 1490nm.
Center Wavelength
R
MS spectral width(max)
nm nm
1260 2.09
1270 2.52
1280 3.13
1290
1295
1297
1329
1331
1340
3.50
1350 3.06
1360 2.58
Transmitter Spectral Limits
0
1
2
3
4
1240 1260 1280 1300 1320 1340 1360 1380
Center Wavelength (nm)
RMS (nm)
1
0
X1 X2 1-X2 1-X1
1+ Y 3
1
1-Y1
0.5
Y1
0
-Y2
N
ormalized Time
N
ormalized Amplitude

SFBD-1250A4Q1R
DELTA ELECTRONICS, INC.
4 Revision: S0
04/12/2007
www.deltaww.com
5. Electrical Interface Characteristics
Parameter Symbol Min. Typ. Max. Unit Note
Transmitter
Total Supply Current ICC A mA Note (1)
Differential line input Impedance RIN 90 100 110 Ohm
Differential Data Input Swing VDT 400 1600 mVp-p Note (2)
Transmitter Disable Input-High VDISH 2 VCC V
Transmitter Disable Input-Low VDISL 0 0.8 V LVTTL
Receiver
Total Supply Current ICC B mA Note (1)
Differential Data Output Swing VDR 400 800 1200 mVp-p Note (2)
Signal Detect Output Voltage-High VLOSH 2 Vcc+0.3 V
Signal Detect Output Voltage-Low VLOSL 0 0.8 V Note (3)
Note (1). A (TX)+ B (RX) = 300mA (Not include termination circuit)
Note (2). Internally AC coupled, but requires a 100Ohm differential termination at or internal to Serializer/
Deserializer.
Note (3). LVTTL logic output, internal 4.7K~10K Ohm pull-up resistor. External load on host board is
unnecessary.
6. Pin Description
Tx/Rx Pin No. I/O Pin Name Description
1
VeeR Receiver Ground
2
VccR +3.3V Receiver Power Supply
3 O
SD Normal Optical Input indicated by logic “High”, and No Optical
Input indicated by logic “Low”. (LVTTL)
4 O
RD(n) Inverted Receiver Data Output (AC-Coupled CML output)
Rx
5 O
RD(p) Non-Inverted Receiver Data Output (AC-Coupled CML output)
6
VccT +3.3V Transmitter Power Supply
7
VeeT Transmitter Ground
8 I
Tx_Dis LVTTL Logic “High” to Disable Transmitter, and Enable
Transmitter by Logic “Low”.
9 I
TD(p) Non-Inverted Transmitter Data Input (AC-Coupled LVPECL input)
Tx
10 I
TD(n) Inverted Transmitter Data Input (AC-Coupled LVPECL input)
MS Mounting studs/ connect this pin to Chassis ground
Note (1). EMI shielding lead must be connected to Signal ground
Bottom View
MS
MS

SFBD-1250A4Q1R
DELTA ELECTRONICS, INC.
5 Revision: S0
04/12/2007
www.deltaww.com
7. Recommended Interface Circuit (AC Coupling)
Transmitter
100ohm
100nF
100nF
9. TD(p)
10. TD(n)
8. Tx_Dis
6. VccT
7. VeeT
Receiver
100nF
100nF
1. VeeR
5. RD(p)
4. RD(n)
3. SD
2. VccR
100nF
10uF 100nF
10uF 100nF
1uH
1uH
3.3V
Protocol IC
SerDes IC
100ohm
Tx_Dis
SD
DELTA SFF Module
Z0=50ohm
Z0=50ohm
Z0=50ohm
Z0=50ohm
150ohm150ohm
RES
* RES is the internal 4.7K to 10K Ohms pull-up resistor.
VccR

SFBD-1250A4Q1R
DELTA ELECTRONICS, INC.
6 Revision: S0
04/12/2007
www.deltaww.com
8. Outline Dimensions
Parameter Unit Description Note
Mechanical Dimensions mm 48.3x13.5x9.6
Connector Type - SC/UPC connector IEC-61754-4
Week (52Weeks/Year) : 1月 2日=01

SFBD-1250A4Q1R
DELTA ELECTRONICS, INC.
7 Revision: S0
04/12/2007
www.deltaww.com
9. Regulatory Compliance
Feature Test Method Reference Performance
Human Body Model
(HBM)
MIL-STD-883E Method 3015.7
EIA-JESD22-A114
Electrostatic Discharge
(ESD) to the Electrical
Pins Machine Model (MM) EIA-JESD22-A115
Contact Discharge IEC/EN 61000-4-2Electrostatic Discharge
(ESD) to the Simplex
Receptacle Air Discharge IEC/EN 61000-4-2
Radio Frequency
Electromagnetic Field
Immunity
IEC/EN 61000-4-3
Electromagnetic
Interference (EMI)
FCC Part 15 Class B
EN 55022 Class B
(CISPR 22A)
(1) Satisfied with
electrical
characteristics of
product spec.
(2) No physical damage
Laser Eye Safety
FDA/CDRH
TUV
FDA 21CFR 1040.10, 1040.11
IEC/EN 60825-1
IEC/EN 60825-2
CDRH File # 0420993
TUV Certificate #
R50032471
Component Recognition
TUV
UL/CSA
IEC/EN 60950
UL 60950
UL File # E239394
Appendix A. Document Revision
Version No. Date Description
S0 2007-04-12 Preliminary datasheet