Delta Voice Faucet Module User manual

Voice Faucet Module
Quick Start Guide

Wi-Fi
REQUIRED
● Delta Touch2O faucet or Brizo SmartTouch faucet
● Smartphone or Tablet (for setup)
● WIFI
● Power outlet
● Amazon Echo
CONTENTS
● Cable
● Power Supply
● Voice Module
NOTICE
While the faucet will operate on batteries alone,
the voice activation module requires the use of the
power supply.
Delta App

Connect power supply to electrical
outlet under sink, then insert
connector into input on solenoid.
1
2
1
1
2
1
Close water supplies and faucet.
1 2
2
1
A
2
1
1
2
B
2
2
1
C
3
Pull down moderately to ensure connection has been made.
C

4
Connect cable from solenoid assembly to voice module.
Green LED will begin blinking within 10 seconds.
2
1
1
5
1
2
2
Turn water on and perform leak check.

6
Welcome To Delta
Congratulations on the purchase of your
Delta Voice Activation Faucet Mod. Let’s
get started setting up your product.
Get Started
On your smartphone or tablet, change your WIFI settings to connect
to the Voice Module. Name of WIFI will be “Delta-XXX” where -XXX
represents a unique identier for your device.
Open a browser and enter the URL 10.10.10.1 for product setup.
Follow instructions to complete product setup.
Bookmark device.deltafaucet.com to access the WebApp for
settings, FAQ and a list of voice commands.
A
B
10.10.10.1
Troubleshooting Tips: if 10.10.10.1 fails to load, try disabling
cellular data on your phone. Your phone may be trying to reach the
internet to resolve the URL.

Commands
Alexa, ask Delta to turn on
Alexa, ask Delta to warm up
Alexa, tell Delta to ll 2 cups
Alexa, ask Delta to ll the sink
Questions
Email: [email protected]
device.deltafaucet.com/#/faq/faq
Delta Faucet Company
3441 Ridgecrest Road Extended
Jackson, TN 38305
© 2017 Delta Faucet Company
Made in USA

Contains FCC ID: 2ABPY-5B9198
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to com-ply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are de-signed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio frequency energy and
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC RF Exposure requirements for mobile and base station transmission
devices, a separation distance of 20 cm or more should be maintained be-tween
the antenna of this device and persons during operation. To ensure compliance,
operation at closer than this distance is not recommended. The antenna(s) used for
this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.

94041 Rev. C