Denver VDB-216 User manual

VDB-216
denver.eu
04/2022

ENG - 1 -
1. Safety information
Please read the safety instructions carefully before using the
product for the first time and keep the instructions for future
reference.
This product is not a toy. Keep it out of the reach of children.
-
Warning: this product includes lithium batteries.
-
Only use 18650 type rechargeable batteries.
-
Keep the batteries out of the reach of children.
-
Never use old and new batteries or different types of batteries
together. Remove the batteries when not using the system for
long periods of time. Check the polarity (+/-) of the batteries
when inserting them in the product. Incorrect positioning
may cause the risk of an explosion.
-
The product's operating and storage temperature range is
between -10 degree Celsius to 40 degree Celsius.
Environments under and above this temperature might affect
functionality.
-
Only use the accessories which are packaged with the
doorbell. Using third party accessories can cause interference
signal issues which can also cause the product to work
abnormally.
-
Never open the product: the device may contain components
with deadly voltage.
-
Repairs or service should only be performed by qualified
personnel.

ENG - 2 -
2. Parts of the doorbell
1.
Light sensor
2. Video doorbell lens
3. Indicator light
4. Microphone
5. Doorbell button
6. Built-in speaker
7. Wall mounting board
8. Reset button
9. Micro USB (for
charging)
10. Micro SD cart slot
11. Battery compartment
12. Battery cover
13. Tamper screw hole

ENG - 3 -
3. Initial setup
Installing the battery and the micro SD memory card
Open the battery
cover.
Insert the batteries as
directed on the
housing.
Insert the micro SD
memory card.
Close the battery
cover.
The device will power on automatically as soon as the batteries are
connected to the power connectors.
Note: The camera will enter standby mode when it has been idle for
more than 15 seconds.

ENG 4
Resetting the doorbell
1.
Hold the reset button for about
3 seconds until you hear the
voice prompt “System reset”.
2. The blue indicator LED will
start flashing to indicate
readiness for connection.
3. Follow the instruction under
“Wi-Fi connection”.
4. Charging
Connect the doorbell to an external
power source via the supplied
charging cable.
While charging, you can view the
charging status in the app.
If you prefer to use a power adapter
(adapter is not included), the power
adapter specification is 5V/1.5A.