Denver DVBT-10 User manual

GB-1
Safety Precautions
• TO REDUCE FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS RECEIVER TO
RAIN OR MOISTURE.
• TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER OR
BACK PANEL. THERE ARE NO USER-
SERVICEABLE PARTS INSIDE. PLEASE
REFER TO QUALIFIED SERVICE PER-
SONNEL.
• Do not stack electronic components or
other objects on top of the receiver. The
slots on top of the receiver must be left
uncovered to allow airflow to the unit.
Blocking the airflow to the unit could impair
performance or damage your receiver and
other components.
• Do not stack the receiver on top of a “hot
component”such as an audio power ampli-
fier.
• Keep a clear space around the receiver to
allow for sufficient ventilation.
WARNING:
CAUTION:

GB-2
Safety Precautions
• Use of cloth and mild solution of washing-
up liquid to clean the casing only when the
receiver is disconnected from the main
power supply.
• Do not connect / disconnect or modify
cables when the receiver is plugged in.
• Do not cover the receiver or place it on a
unit that emits heat.
• Avoid exposing the receiver to direct sun
shine.
• Ensure that children do not poke objects
into the ventilation slots.

GB-3
Safety Information
CAUTION: Use of controls or adjustments or perform-
ance of procedures other than those specified herein
may result in hazardous radiation exposure.
Please carefully study this manual and always keep it
available. There are, however, some installation and oper-
ation precautions which you should be aware of.
1.Cleaning - Unplug this product from the wall outlet
before cleaning. Do not use liquid cleaners or aerosol
cleaners. Use a damp cloth for cleaning.
2.Water and Moisture - Do not use this product near water
for example, near a bath tub, wash bowl, kitchen sink, or
laundry tub; in a wet basement; or near a swimming
pool; and the like.
3.A product and cart combination should be moved with
care. Quick stops, excessive force, and uneven surfaces
may cause the product and cart combination to overturn.
4.Damage Requiring Service - Unplug this product from
the wall outlet and refer servicing to qualified service
personnel under the following conditions:
a. When the power-supply cord or plug is damaged.
b. If liquid has been spilled, or objects have fallen into
the product.

GB-4
Safety Information
c. If the product has been exposed to rain or water.
d. If the product does not operate normally by following
the operating instructions. Adjust only those controls
that are covered by the operating instructions as an
improper adjustment of other controls may result in
damage and will often require extensive work by a
qualified technician to restore the product to its nor-
mal operation.
e. When the product exhibits a distinct change in per-
formance - this indicates a need for service.
5. Do not connect or modify cables when the DVB is
plugged in.
6. Safety Check - Upon completion of any service or
repairs to this product, ask the service technician to per
form saftey checks to determine that the product is in
proper operating condition.

GB-5
General Information
Thank you for purchasing this product.
You have just purchased a fully DVB compliant digital ter-
restrial receiver.
All functions can be carried out using the buttons on the
remote control, and some of the functions can also be car-
ried out using the buttons on the front panel.
Please note that the actual controls and components, menu
items, etc. of your receiver may look somewhat different
from those shown in theinstruction manual.
Please be aware that new software may change the func-
tionality of the DVB.
Should you experience any difficulties with the operation of
your DVB, please consult the relevant section of this man-
ual or alternatively call your dealer or a customer service
adviser.

Table of Contents
GB-6
Safety Precautions...........................................................1
Safety Information............................................................3
General Information.........................................................5
Table of Contents.............................................................6
Remote Control................................................................7
Panel Description...........................................................10
Systemic Connection.....................................................12
Basic Operation..............................................................13
Guide of Main Menu.......................................................14
Trouble Shooting............................................................30

Remote Control
THE INSTRUCTIONS IN THIS MANUAL DESCRIBE
THE FUNCTIONS ON THE REMOTE CONTROL.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
21
20
22
1. POWER
2. NUMBERS
3. P/N
4. STB/VCR
5. INFO
6. CH+
7. VOL-
8. CH-
9. GAME
10. EXIT
11. 16:9/4:3
12. P-
13. LANGUAGE
14. MUTE
15. R/L
16. TV/RADIO
17. VOL+
18. OK
19. EPG
20. TELETEXT
21. MENU
22. P+
GB-7

GB-8
Remote Control
1. POWER:
2. NUM-
BERS:
3. P/N:
4. STB/VCR:
5. INFO:
6. CH+:
7. VOL-:
8. CH-:
9. GAME:
10. EXIT:
11. 16:9/4:3:
12. P-:
13. LANG-
UAGE:
Switch between Operation and Standby
modes.
Press to change channel or enter your
numeric values on the menu.
Select output mode for TV.
When VCR is playing, Press to switch
between VCR and STB;
When VCR is closed, Press to switch
between CVBS and RGB.
Display the information about the channel
and program.
Press to change channels or move up in
the menus.
Let up the volume.
Press to change channels or move down
in the menus.
Play the different game.
Exit the main menu or guide screen.
Set video aspect ratio.
Page down and Let up the volume.
Set the appropriate language.

GB-9
Remote Control
14. MUTE:
15. R/L:
16. TV/RADIO:
17. VOL+:
18. OK:
19. EPG:
20. TELETXT:
21. MENU:
22. P+:
Press to mute/un-mute audio volume.
Setup right or left channel.
Press to switch between TV and RADIO.
Advance the volume.
Press to confirm choices.
Display Electronic Program Guide menu.
The servicer provided with text message
transmitted to TV has Teletext decoder.
Display the main menu.
Page up and advance the volume.

GB-10
Panel Description
Front Panel
1 2 3 4
1. LCD: Red light refers to the receiver is in standby
mode; Green light refers to the receiver is on; Orange
light refers to the VCR send the program to TV.
2. Channel up: Press to change channels or move up
in the menus.
3. Channel down: Press to change channels or move
down in the menus.
4. Standby button: Press to be(off) in standby mode.

GB-11
Panel Description
Rear Panel
DENVERELE
C
TR
O
NI
CS
1 2 3 4 5 6 7
8
1.RF IN: Provide modulated RF signals (PAL/NTSC) from
Receiver to TV.
2.RF LOOP THROUGH: Output signals to the next
receiver.
3.VCR: Connection to VCR.
4.TV: Connection to TV.
5. AUDIO: Audio signal to Hi-Fi system.
6. Coaxial: Connect the coaxial cable from the coaxial of
the Receiver to the wired TV’s jack.
7.RS232: Serial cable connector for downloading data,
etc.
8. POWER CABLE: Connect to power source.

GB-12
Systemic Connection
The following figure is a simple guideline for installing one
receiver. If you have any problem about connection and
need help, please contact your local dealer.
DENVERELE
C
TR
O
NI
CS
• Install the antenna appropriately.
Note:
•To avoid damaging the receiver, Please make sure of
antenna selecting “Off”, if the sort of antenna is uncertain;
then connect the antenna to the receiver.
•Please make sure of the power on, before you connect
the output.

GB-13
Basic Operation
Switching Channel
Volume Control
When the receiver is turned on, the default setting is the
TV program status.
You can switch the current channel using one of the fol-
lowing methods.
• Enter your desired channel numeric using the “NUMER-
ICAL(0~9)” buttons to move the channel directly.
• Press the “TV/RADIO” button to switch between TV
channel and Radio channel.
• Press the “OK” button to display Channel list, Use the
“CH+/CH-” and the “OK” button to select channel.
• Press the “V-/V+”or “P+/P-” button to adjust the audio
volume.

Guide of Main Menu
GB-14
To display the Main Menu, press the “MENU” button.
Program List
Program Search
Parental Control
System Setting
TV Program List
Music Program list
Sort
Automatic Search
Manual Search
Channel Lock
Parental Setting
Change PIN
TV Standard
Display Type
Autenna Power
Country
Regional Setting
Language
Time Setting
System Schedule

Guide of Main Menu
GB-15
Use the / button to move up or down from one item to
another. The corresponding sub menu will be displayed on
the TV screen as long as the “OK” button is pressed on
the selected item.To escape the menu system at anytime,
press “EXIT” or “MENU” button on the remote control.
NOTE: If you use the receiver for the first time, You will
see the dialog on the TV screen as follows.
Game
Accessory
Personal Style
Mine
Tetris
GomoKu
Calendar
System Information
Factory Default
System Update
Menu Color
Transparency Level
Border Pattern
Entry Animation

Guide of Main Menu
GB-16
First Time Installation
Do you want to start first time Installation Wizard?
First Time Installation
YES NO
The default setting is “NO”, press either the “EXIT” or
“MENU” button on the remote control to exit the dialog.
When you press “OK” button on the remote control to
select “YES”, and then enter the “First Time Installation(1)”
dialog.
First Time Installation (1)
German
Country
NEXT
Language
Time Zone
Antenna Power
BACK
German
GMT+00:00
OFF
Press / button to select item desired.
Select “NEXT” button to enter “First Time Installation
(2)”dialog.

Guide of Main Menu
GB-17
BACK: return to the upper menu.
YES: start auto search.
NO: cancel auto search, and enter the main menu.
First Time Installation (2)
YESBACK NO
Do you want to start Auto search?
Previous channel list will be replaced.
Automatic Search
Progress
Channel No
Frequency
50%
20
546MHz
TV list: 000 Radio list 000

Guide of Main Menu
GB-18
The default highlight menu bar is the one on the first line
or the one operated lastly. Moving / button of remote
control to change the setting.
Program List
Under the main menu, Moving / button of remote con-
trol to highlight the program list menu, then press the“OK”
button to enter the TV Program list, and then will display
the following list:
No. Program name Favor Move Del
Program Edit Table
TV Program List

No. Program name Favor Move Del
Program Edit Table
Under the main menu, Moving / button of remote con-
trol to highlight the program list menu, then press the
“OK” button to enter the Music Program list, and then will
display the following list:
Guide of Main Menu
GB-19
The default highlight menu bar is the one on the first line
or the one operated lastly. Moving / button of remote
control to change the setting.
Music Program List