“Add” or “Inc usion”. Excluding a node D allocated by Z-WaveTM
Controller means “Remove” or “Exc usion”.
Function Description
Add
1. Have Z-WaveTM Controller entered inclusion mode.
2. Pressing tamper key three times within 1.5 seconds
to enter the inclusion mode.
3. After add successful, the LED will light ON 1 second
Remove
1. Have Z-WaveTM Controller entered exclusion mode.
2. Pressing tamper key three times within 1.5 seconds
to enter the exclusion mode.
Node D has been excluded.
Reset
Notice: Use this procedure on y in the event
that the primary contro er is ost or
otherwise inoperab e.
1. Pressing tamper key four times within 1.5 seconds
and do not release the tamper key in the 4th
pressed, and the LED will light ON.
2. After 3 seconds the LED will turn OFF, after that
within 2 seconds, release the tamper key. f
successful, the LED will light ON one second.
Otherwise, the LED will flash once.
3. Ds are excluded and all settings will reset to
factory default.
Association
1. Have Z-WaveTM Controller entered association
mode.
2. Pressing tamper key three times within 1.5 seconds
will enter association mode.
Note: The device support 1 group.
The group 1 is for receiving the report message, like
tamper event. And the group support 8 nodes
maximum.
•Failed or success in including/excluding the node D can be
viewed from Z-WaveTM Controller.
Notice 1: Always RESET a Z-WaveTM device before trying to add it to a
Z-WaveTM network.
Notice 2: When the device into NW mode, the device functionality
will useless. The NW mode will timeout after 3 minutes. You can press
the tamper key (or the circle button) 3 times to abort the NW mode.
Z-WaveTM Message Report
n default the device will using Notification Report to represent the
trigger event, it can be changed to Sensor Binary Report by setting the
configuration NO. 7 Bit4 to 1.
* Tamper Report:
When the tamper key is pressed over 5 seconds. The device will into
the alarm state. n that state, if the tamper key be released, the device
will unsolicited to send the report to the nodes in the group 1.
Notification Report (V4)
Notification Type: Home Security (0x07)
Event: Tampering. Product covering removed (0x03)
Sensor Binary Report (V2)
Sensor Type: Tamper (0x08)
Sensor Value: 0xFF
Siren State Report
When the siren start playing or stop the alarm sounds, the device will
unsolicited to send the “Sensor Binary Report” to the nodes in the
group 1.
Sensor Type: General Purpose (0x01)
Sensor Value: 0xFF (Start play), or 0x00 (Stop play)
2
