
10
A machine should not be allowed to
operate if any of the following occur:
• Excessively high water level.
• Machine is not connected to a properly grounded
circuit.
• Loading door does not remain securely locked
during the entire cycle.
• Vibration or shaking from an inadequate mounting
or foundation.
Table of Contents
Section 1:
Specications, Mounting Dimensions
Specications.................................................12-15
Dimensions....................................................16-17
Section 2:
Installation & Operating Instructions
Washer Installation ........................................20
Electrical Connections & Fusing Requirements .21
Dryer Installation.................................................22
Dryer Electric, Gas and Venting.....................23-24
Washer Operating Instructions......................25-26
Emergency Stop Button .................................25
Dryer Operating Instructions..............................26
Section 3:
Washer and Dryer Programming Instructions
Rapid Advance Mode......................................30
Washer Price Programming............................32-33
Wash Cycle Programming......................... 34-37
Coin Washer Cycle Parameter Ranges ................
Dryer Programming.......................................46-59
Section 4:
Dryer Service,Troubleshooting and Schematics
Dryer Service Procedures..............................62-68
Dryer Control Fault Codes...................................70
Dryer Troubleshooting Tips........................ 72-75
Dryer Schematics 60hz.............................76-81
Section 5:
Dryer Parts Data......................................83-103
Section 6:
50hz Gas Dryers
50hz Dryer Parts....................................106-110
50hz Dryer Schematics...........................112-113
Section 8:
Washer Service and Troubleshooting
Electronic Coin Drop Acceptor...........................116
Electronic Coin Drop Maintenance.............117-120
Optical Coin Drop Acceptor...............................122
Dexter Safety
Guidelines
FOR SAFETY
1. Always shut o power and water
supply and also discharge capacitors
before servicing.
2. Do not overload the washer.
3. Do not attempt to open door if cylinder
is in motion or contains water.
4. Do not mechanically force or override
door lock in any way.
5. Do not bypass any safety devices of
this washer.
6. Do not use volatile or ammable
substances in or near this washer.
7. Keep all panels in place. They protect
against shock and injury and add
rigidity to the washer.
To activate your warranty, be sure to return
your red warranty form to the factory. Please
have serial number and model ready when
calling for assistance.
WARNING
These washers are equipped with devices and
features relating to their safe operation. To
avoid injury or electrical shock, do not perform
and service, unless qualied to do so.
Part # 8533-120-001 9/21