Digi TransPort WR11 User manual

Quick Start Guide
TransPort® WR11
LTEModels
Welcome to your Digi product
Get started: This guide helps you with initial product setup. Need more? Find additional
product support at www.digi.com/support/TransPortWR11. Or connect to the online
documentation by scanning this code:
Digi Technical Support: Digi offers multiple support plans to help you get the most out of
your product. For information on Technical Support plans and pricing, contact us at
877.912.3444 or visit www.digi.com/support.
Documentation Feedback: To provide feedback on this documentation, send your
comments to [e-mail].
1Verify your components
Included equipment Required additional equipment
Verify that you have all included equipment. If any item is missing or damaged, contact your supplier.
2Connect the hardware
1. Open the SIM door. Using your finger, slide the SIM door out and
lift up.
4. Connect the primary and secondary cellular antennas to the
respective antenna connectors on the unit.
Note Two antennas are required for normal operation of this
device.
2. Insert the SIM card(s) as shown, with the notch facing the bottom-
right corner of the device. If you are using one SIM card only,
insert it in the SIM 1 slot.
5. Connect the plug end of the 5-volt power supply to the power
connector on the unit, and plug the other end into a wall outlet.
Insert the power supply end fully and rotate clockwise to engage
and lock.
3. Close the SIM door. 6. Connect one end of the Ethernet cable to the Ethernet port on the
unit and the other end to an Ethernet port on a PC.
Note Position the Digi TransPort WR11 on a flat, level surface in a location with adequate ventilation. The unit is designed for indoor use.
Do not expose the unit to extreme heat or cold, strong magnetic fields, or liquids.
© 2016 Digi International Inc.
Digi, Digi International, and the Digi logo are trademarks or registered trademarks in the United States and other countries worldwide. All other trademarks mentioned in this
document are the property of their respective owners.

3Run the Getting Started Wizard
If your PC is configured to automatically get an IP address, it can obtain the IP address from the TransPort WR11. Otherwise, make sure your PC
can connect to the network 192.168.1.0 (255.255.255.0).
1. Enter 192.168.1.1 into the address bar of the web browser.
2. The first page of the Getting Started Wizard appears. This wizard guides you through initial configuration of your TransPort device.
nTo run the wizard, click Get Started.
nTo manually configure the TransPort device, click Skip Wizard.
Note The default username and password for logging in to the TransPort device are username and password.
4View the TransPort LEDs and startup states
Service LED: Indicates the presence and level of cellular service running on the device.
Off: No cellular service
1 blink: GPRS mode
2 blinks: EDGE mode
3 blinks: UMTS mode
4 blinks: HSDPA mode
5 blinks: HSUPA mode
6 blinks: LTE mode
Signal LED: Indicates the strength of the cellular signal.
Off: Poor or no signal. Place the device in a location where it gets a better signal.
Amber: Fair
Green: Good
Power LED:
Off: No power
Green:TransPort device is powered
After the Getting Started Wizard completes, the TransPort web interface appears. For additional configuration, use the web interface and refer
to the Digi TransPort User Guide and Application Notes on the Digi website at www.digi.com/support/TransPortWR11.