Digital Watchdog Star-Light DWC-MC253WTIR User manual

Quick Start Guide Quick Start Guide
1. The mounting surface must withstand five times the weight of
your camera.
2. Pay attention to the cables. They can easily become caught and
damaged. Any damage may cause a short or fire.
3. Detach the camera’s dome cover by removing the security screw from
the decorative ring.
4. Unscrew the decorative ring from the camera module by rotating it
counter-clockwise.
STEP 1 – PREPARING TO MOUNT THE CAMERA
Pass the wires through the mount bracket and make all necessary
connections. Connect the BNC cable and power cables to the
camera.
STEP 2 – CABLING THE CAMERA TO
EXTERNAL DEVICES
Power requirements Power consumption
12VDC ON LY !
CAUTION! The camera supports
DC power supply only
DC12V (LED o): 1.92W
DC12V (LED on): 3.12W
Tel: [phone]
Technical Support Hours:
9:00AM – 8:00PM EST, Monday thru Friday
digital-watchdog.com
WHAT’S IN THE BOX
Black and
white
decorative
rings
1Hex Allen
wrench 1
Test video
cable 1Mounting template 1
Screws and
plastic
anchors-4pcs
1 Set Quick set up
guide 1
External OSD
and signal
controller
1
Protective sheet
Attention: This document is intended to serve as a quick reference for initial
set up. It is recommended that the user read the entire instruction manual for
complete and proper installation and usage.
NOTE: Download all your support materials and tools in one place.
1. Go to: http://www.digital-watchdog.com/resources
2. Search your product by entering the part number in
the ‘Search by Product’ search bar. Results for
applicable part numbers will populate automatically
based on the part number you enter.
3. Click ‘Search’. All supported materials, including manuals
and quick start guide (QSGs) will appear in the results.
DW® Universal HD over Coax®
micro dome cameras
DWC-MC253WTIR DWC-MC253W-28

External OSD and
signal controller
Quick Start Guide
1. The camera supports HD-Analog, HD-CVI and HD-TVI signals. To
switch between the signals:
a. Remove the camera’s dome and connect the external controller to
the base of the camera. See the image below for more information.
b. Use the OSD Switch to switch the camera’s signal.
1. Once all cables have been connected, use the screws included with the camera to properly mount and secure the camera to the mounting surface.
2. Adjust the camera’s pan, tilt and position to achieve the desired view. The cameras’ max angles are:
Pan: 0° ~ 360°
Tilt: 0° ~ 70°
Rotation: 0° ~ 360°
3. Once the installation is complete, remove the protective film from the camera’s dome cover.
4. For DWC-MC253WTIR models, the camera has a manual IR switch,
located under the camera’s lens. You can use this switch to manually
turn the IR LED board on or o according to the installation needs.
STEP 4 – INSTALLING THE CAMERASTEP 3 – CHANGING THE SIGNAL IN
THE CAMERA
Rev Date: 09/19
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
Rotation 360°
Titling 70°
Panning 360°
OSD board
- To switch the camera to
HD-TVI mode, press OSD
joystick to the left
for 5 seconds.
- To switch the camera to
HD-Analog mode, press OSD
joystick to the right
for 5 seconds.
- To switch the camera to CVBS
mode, press OSD joystick up
for 5 seconds.
- To switch the camera to
HD- CVI mode, press OSD
joystick down for 5 seconds.
External OSD and
signal controller
IR Switch
ON/OFF