Digitus eSATA II EXPRESSCARD User manual

1
eSATA II
EXPRESSCARD
User Manual

2
Features and Benefits
Fully compliant with ExpressCard Specification 1.0
ExpressCard/34 Form Factor Module
Serial ATA generation 2 transfer rate of 3.0Gbps
Supports hot plug for extend Serial ATA port
Supports Windows 7, Vista, XP, 2000
Package Contents
1x eSATA II 300 1-Port ExpressCard
1x Driver CD
1x User Manual
System Requirements
Windows 7, Vista, XP, 2000
ExpressCard-enabled system with an available
ExpressCard slot

3
Hardware Description
Hardware Installation
General instructions for installing the card are provided below.
Since the design of system may vary, refer to your system’s
reference manual for further information, if needed.
Insert the Card into the ExpressCard slot of your system. Make
sure it is inserted all the way in for a solid connection.

4
Driver Installation
For Windows® 2000/XP/Server 2003/Vista/ 7
1.At the Found New Hardware Wizard window pop-up, please
click Cancel button to cancel the driver installation for the
device at this moment. The driver for this device will be
installed in the next step.
2.Please insert the CD driver bound with eSATA II 300 1-Port
ExpressCard into your CD-ROM Drive.
3.At the Windows desktop, click Start, then Run.
4.Type D:\DS-31101\Windows\Setup.exe, then click OK.
(Change D:\ to match your CD-ROM drive letter)
5.Follow the on-screen instructions to complete the installation.
6.Restart Windows to complete the installation.
To Verify Windows® 2000/XP/Server 20003/Vista/7
Installation
Click on the “Device Manager” tab in System Properties, which
you access from the Windows Control Panel. You should see an
“JMicron JMB36X RAID Controller” installed under “SCSI and
RAID controllers (Storage controllers – Vista)” item.

5
START > Control Panel > System > Device Manager
Hot-Plugging A Hard Disk Drive
To remove a drive from a powered up system, do the following:
1.Right click My Computer and click Manage.
2.Select Device Manger.
3.Click Disk Drives, right click the target disk and select
Disable/Enable.
4.You can now remove the target disk.