Digitus DS-33150 User manual

1
SATA - IDE
CONVERTER
User Manual

2
Introduction
This Bridge Board is a converter solution for the Parallel Ultra ATA
Device. It has a standard 40 pin ATA port which can interface to IDE
device (hard disk, CDROM, DVD, CD-RW, etc). It accepts Serial ATA
commands through the SATA interface from the host, decodes the
commands and converts them to parallel ATA commands to the device.
Response from the device through the parallel ATA bus are deciphered,
processed and converted to SATA protocol and send to the host.
The PATA to SATA 150 Converter supports the Serial ATA Generation
1 transfer rate of 1.5GB/s (150MB/s) on the Serial ATA side and is
compatible with Ultra ATA-133 on the parallel ATA side.
Features
Overall Features
Compatible with Ultra ATA 133 / 100 / 66 / 33 specifications
Supports all types of ATATPI, ATA/133, ATA/100, ATA/66,
ATA/33, EIDE and IDE storage devices (DVD, DVD-RAM, MO,
CD-ROM, CD-RW, Hard Disk, …)
100% hardware bridge converter to support PC and MAC
environment

3
Serial ATA Features
Compliant with Serial ATA 1.0 specifications
Supports Serial ATA Generation 1 transfer rate 1.5Gb/s
Hardware Installation
1. Connect the PATA to
SATA 150 Converter to
your IDE device, please
remind the direction of
IDE port.

4
2. Plug the 4 PIN power
cable to PATA to SATA
150 Converter.
3. Connect the 4 PIN power
cable to your IDE device.
4. Connect a SATA cable to
PATA to SATA 150
Converter and remember
to plug the other
connector of the cable to

5
your computer.
Note1: IDE device must be set on Master Mode.
Note2: Please make sure that your PC is shut down during
your hardware installation. This PATA to SATA 150
Converter with your IDE device is not hot swap device and
please shut down your computer before your want to
connect this device.