Digitus DS-30220-4 User manual

USB 3.0, 2-PORT
PCI EXPRESS ADD-ON CARD
User Manual
DS-30220-4

Features
Fully compliant with PCI Express Base Specification Revision 2.0
Single-lane (x1) PCI Express throughput rates up to 5 Gbps
Compliant with Universal Serial Bus 3.0 specification Revision 1.0
Supports simultaneous operation of multiple USB 3.0, USB 2.0 and
USB 1.1 devices supporting the following speed data rates as
follows: Low-speed (1.5Mbps) / Full-speed (12Mbps) /
High-speed (480Mbps) / Super-speed (5Gbps)
Supports 2 downstream ports for all speeds
Built-in 4-pin power connector for receiving extra
power supply from system
Hot-swapping feature allows you to connect/disconnect devices
without powering down the system
Support Windows®XP/Vista/7/8 (32/64 bit)
System Requirements
Windows®XP/Vista/7/8 (32/64 bit)
One available PCI Express slot (Recommend PCI Express 2.0)
Package Contents
1 x USB 3.0 2-Port PCI Express Add-On Card
1 x Driver CD
1 x User Manual
Hardware Description

Hardware Installation
1. Turn Off the power to your computer.
2. Unplug the power cord and remove your computer’s cover.
3. Remove the slot bracket from an available PCIe slot.
4. To install the card, carefully align the card’s bus connector
with the selected PCIe slot on the motherboard.
Push the board down firmly.
5. Replace the slot bracket’s holding screw to secure the card.
6. Replace the computer cover and reconnect the power cord.
Driver Installation
For Windows®XP/Vista/Win7/8 (32/64 bit)
1. Please insert the CD driver bound with USB 3.0 2-Port PCI
Express Add-On Card into your CD-ROM Drive.
2. At the Windows desktop, click Start, Run.
3. Type D:\RENESAS NEC uPD720200F1\Setup.exe, click OK.
(Change D: to match your CD-ROM drive letter)
4. Follow the on-screen instructions to complete the installation.
To Verify Driver Installation
Click on the “Device Manager” tab in System Properties, which you
access from the Windows Control Panel. You should see a “NEC
Electronics USB 3.0 Host Controller” and a “NEC Electronics USB
3.0 Root Hub” under the “Universal Serial Bus controllers” item.