Dimplex Duoheat User manual



ContactDetails

Pleasenotethatsomeofthecontactdetailson
thisPDFdocumentmaynotbecurrent.

Pleaseusethefollowingdetailsifyouneedto
contactus:

Telephone:08448793588
Email:[email protected]


Thecustomersupportsectionofourwebsitealsofeaturesawide
rangeofinformationwhichmaybeofusetoyouandisavailable
24hoursaday.Itincludes:

•Operatingandinstallationinstructions
•Easy‘Howtouse’guidesforstorageheaters
•Serviceandrepairs
•Wheretobuyourproducts
•Literaturedownloads
•Heatingrequirementcalculator

Visit‐www.dimplex.co.uk/support
A division of GDC Group Ltd
Millbrook House Grange Drive Hedge End Southampton SO30 2DF
www.dimplex.co.uk
Re
g
istered No: 1313016 En
g
land
VAT GB 287 1315 50004
EEE Producer Registration Number –
WEE/GE0057TS
Paper from sustainable sources

Quick Start Guide
Duoheat Radiator with RX010006 Programmer QS007
This guide is for quick reference only. Refer to the Duoheat and Programmer installation and operating instructions for further information
Duoheat Radiator Overview
Dimplex UK Ltd, Millbrook House, Hedge End, Southampton, SO30 2DF. For further assistance please contact Dimplex customer services on 0845 600 5111. Web-site: www.dimplex.co.uk
Room temperature control
Your DuoHeat radiator works by providing continual warmth from a
carefully balanced combination of retained and ‘direct response’
heating.
Some energy is taken in by the radiator when electricity tariffs are
low. The radiator will automatically determine how much heat
needs to be stored each night depending on changing weather
conditions.
The stored heat is supplemented whenever needed by top up heat
from the radiant front panel, to ensure room temperatures remain
to your preferred level throughout the day.
• Controls the amount of heat emitted from the radiator.
• When only background heating is required (e.g. the room is
unoccupied) set the control to minimum (1 bar).
• When more heat is required (e.g. when the room is occupied)
set the control to your preferred comfort setting
• To set the room temperature level required, press the ‘+’ or ‘-‘
buttons.
• The display will indicate the level you have selected.
• After the control has been adjusted, the brightness of the dis-
play will revert to a background level after a few seconds of
inactivity.
Child lock
• To activate the child lock,
press the ‘+’ and ‘-‘ buttons
together for approximately 3
seconds.
• A light in front of the key symbol on the display will illuminate,
indicating that the control is locked and cannot be adjusted.
• To deactivate the child lock, press the buttons simultaneously
again for 3 seconds, until the light in front of the key symbol is
no longer illuminated.
Pilot wire central programmer RX010006
The RX010006 central control can be used to
control the operation of multiple DuoHeat
radiators remotely.
Depending on the controller setting, DuoHeat
radiators will respond in the following way:
Min Max
Comfort Heater functions at the selected output set by the heater room temperature
control
Setback (background) Heater functions with room temperature control automatically set to
minimum output setting.
(NB room temperature control cannot be adjusted)
Frost protection No subsequent input charge is accepted. Front panel will maintain frost
protection temperature
Off Heater does not function – off peak and 24hr supplies both
disconnected