Page 9
LED Diagnostics and Troubleshooting
LED Status Description Troubleshooting
Module Programming
Solid red Waiting for bus detection.
If the key was turned to IGNITION:
To know if the bus is detected, connect the pink ignition
input wire from the black 10-pin connector to (+) 12v.
If the LED starts flashing orange:
The bus was detected, but the ignition was not detected in
data. In this case, connecting the pink ignition input wire
from the black 10-pin connector will fix the issue.
Flashes red x1 Data bus detection timeout. J1850 was not detected. Refer to the wiring diagram to
verify your connections to the vehicle.
Flashes red x3 Bypass detection timeout. Bypass was not detected after a timeout period. Refer to
the wiring diagram to verify your connections to the vehicle.
Solid red 3 sec. The Saturn Ion type of bypass
programmed, but J1850 did not.
J1850 was not detected. Refer to the wiring diagram to
verify your connections to the vehicle.
Flashes orange Waiting for the bypass to
program.
Waiting for the key to be at the START position. If it was
already turned to that position, start is not being seen in
data. Connect the violet start input wire from the black 10-
pin connector on the module.
Flashes orange x1 Programming completed. Bypass detected = PassLock 1 door lock is on ISO.
Flashes orange x2 Programming completed. Bypass detected = PassLock 2 door lock is on ISO.
Flashes orange x3 Programming completed. Bypass detected = PassLock 3 door lock is on ISO.
Flashes orange &
green
Waiting for keyless
programming.
The module detected the ISO door lock. Press lock or
unlock on the OEM FOB to validate your installation. If it
does not work, refer to the wiring diagram to verify your
connections. If the OEM FOB is not available, it is possible
to skip the keyless programming by pressing 5 times on
the programming button. The LED will go to the final
status, and it will then turn OFF. The module will be
programmed in ISO door lock anyway.
Flashes green x1 Programming completed. Bypass detected = PassLock 1 door lock is on J1850.
Flashes green x2 Programming completed. Bypass detected = PassLock 2 door lock is on J1850.
Flashes green x3 Programming completed. Bypass detected = PassLock 3 door lock is on J1850.
Flashes green
Analogue bypass programming
in progress, waiting on more
information to complete the
sequence.
If the key was turned back to IGNITION, the module did not
move to the next step because it noticed an error in the
second recorded value. Refer to the wiring diagram to verify
your MUX connections. It is possible to skip the bypass by
pressing 5 times on the programming button. The LED will
turn ON solid red for 3 seconds, and then it will turn OFF
to indicate the bypass was skipped. The module will only
do convenience in this case.
Solid
Solid Red
3 sec.
Flashes x1
Flashes x3
Flashes
Flashes
Flashes x1
Flashes x2
Flashes x3
Flashes
Flashes x3
Flashes x2
Flashes x1
Platform: DBALL/DBALL2
Firmware: GM5 Remote Start Ready (RSR) Installation
© 2015 Directed. All rights reserved.
Rev.: 20150626
Brake Switch 2004-06
34
2
1
Brake Switch 2007-10
Brake Sense:
Light Blue, pin 2
OR
Passenger
Kick Panel
4
1
3
2
