Discount Car Stereo A2D-HON User manual

Courtesy of: DiscountCarStereo.com
Serving the internet community since 1995
A2D-HON
BLUETOTOH MUSIC STREAMING INSTALLATION GUIDE FOR SELECT 1992-01 HONDA/ACURA
Created: April 15, 2017
RevisedFebruary23, 2022

PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
•This installation guide is provided as a GENERAL installation guide, some vehicles vary and
may require additional steps. We do not accept responsibility for third party labor charges
or modifications. Exercise due-diligence when installing this product.
•We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
•Careless installation and operation can result in equipment damage.
Requirement
Radios with CD button and 8-pin socket
Introduction:
They are literally thousands of older Hondas and Acura’s on the road that still
has the original radio in place that unfortunately lack support for Bluetooth, but
thanks to A2D-HON these radios can be upgraded to support Bluetooth music
streaming. Installation could not be simpler and only requires connecting
Bluetooth module to the 8-pin CD changer socket, pairing Bluetooth device and
be their way to enjoying music, navigation, audio books and other important
applications on the car system! Because this module uses the “CD” port,
factory single CD or CD changer (if present) must be disconnected.
Warning!! All compatible radios must have a “CD”button on face and 8-pin
socket at the rear. Radios with 8-pin socket at the rear but missing “CD”
button on faceplate (e.g., models: 1100, 1901, 2100, 2300 etc.) are NOT
compatible.
Installation:
1. Remove radio to gain access to the connector.
(vehicle specific radio removal instructions are not included but available
upon request)
2. Disconnect any accessory connected to 8-pin connector (See Fig. 2)
3. Connect module 90-degree 8-pin plug (See Fig. 1) to radio or slave cassette
player 8-pin port (See. Fig. 2)
Fig. 1
Fig. 2
8 pin socket
4. Reinstall radio.

Pairing:
Pairing process varies between devices but basic steps are the same. Pairing is
done upon initial install and will not have to be repeated.
1. Turn ignition and radio “ON”
2. On Bluetooth device: Go to Settings/Wireless & Networks/
Bluetooth Settings
3. Select Bluetooth and turn on.
4. Go to Bluetooth settings
5. Tap “
Scan”for devices .
6. Wait for Bluetooth device name to appear and select it (see image
below)
7. Confirmation heard on car speakers
Optional remote control
Wireless remote is not required for module to work as described, however
instead of fumbling audio device, you simply press the familiar remote-control
buttons while also keeping your eyes on the road.
Optional remote control allows users to:
1. Control music wirelessly
2. Activate VR commands (Google only)
3. Track up/down
4. Volume up/down
Pairing remote control:

Operation:
Use wireless remote to perform the following functions on any iOS7.0 and higher
or Android 4.4 and higher.
Contents:
Operation
1. Turn ignition and radio “ON”
2. Press "CD" or “CD/TAPE” button on radio (See Fig.3) until display changes
to CD mode (See Fig. 4)
Fig. 3
Fig. 3
CD display mode
Note: If radio does not switch to CD, cycle ignition OFF/ON and try again.
3. Launch streaming application on smart device.
4. Use radio volume button to set playback level and ensure smart device
volume is raised to 85% or higher. If playback is distorted, lower volume
smart device or if inaudible, raise volume on both smart device and/or
radio.
Warning: Playlist and track selection *NOT* possible from radio
buttons. Use smartphone built-in controls and display to access and
control audio files and applications.
5. If correct operation is confirmed go ahead and reinstall radio.

Frequently ask questions & troubleshooting
1. Does the A2D-HON work on all Honda radios?
NO; The A2D-HON works on select 1992-01 Honda CD changer controlling
radios. CD changer controlling radio will have a “CD”or “CD/TAPE”button
on face AND 8-pin socket at the rear. Honda radios missing the “CD”or
“CD/TAPE”button are not compatible even with 8-pin socket at the rear.
Must have both!!
2. My radio has a built-in 6 CD changer, will the A2D-HON work?
Most (if not all) Honda 6-CD changer radios (changer built-into radio) do
NOT support an external device (lacks 8-pin “CD” socket seen in Fig. 2)
and therefore not compatible. Many Acura 6-CD changer radios DO support
external devices. Please check for 8-pin DIN socket (See Fig. 2) prior to
purchase.
3. Can I use the Honda radio buttons to control streaming device?
NO; Use device built-in controls to browse music library.
4. Will I be able to make phone calls using this module?
NO; the A2D-HON supports music streaming not hands-free calls.
5. What happens if a call comes in while streaming?
Streaming will mute during call and resume upon ending call. Call taken on
handset as customary.
6. Can I connect module to the CD changer plug in trunk/hatch?
YES/NO; If vehicle has original CD changer, the module can be connected to
CD changer cable terminal, however; if vehicle has an aftermarket CD
changer (e.g., Alpine etc.); module must be connected to radio.
Disclaimer
• This product has no affiliation with Honda, Acura.
• We’re not liable for misuse of this product.
•We recommend professional installation.
email [email protected]
© 1995-Feb-22 Discount Car Stereo, Inc. All rights reserved. Information in this document is subject to
change without notice. Other products and companies referred to herein are trademarks or registered
trademarks of their respective companies or mark holders