Discount Car Stereo A2D-CHRY Instruction Manual

Courtesy of: DiscountCarStereo.com
Serving the internet community since 1995
Radio
CD Changer
A2D-CHRY
QUICK START MUSIC STREAMIING, CHANGER RETENTION INSTALLATION GUIDE FOR SELECT 1995-02 CHRYSLER
Created February 6, 2017
Revised: August 13, 2021

PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
This installation guide is provided as a GENERAL installation guide, some vehicles vary and
may require additional steps. We do not accept responsibility for third party labor charges
or modifications. Exercise due-diligence when installing this product.
We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
Careless installation and operation can result in equipment damage.
Requirement
Working CD changer
Introduction
Portable audio products are everywhere, reflecting demand from active people
all over the world to take their music on the road. The A2D-CHRY module
provides Bluetooth music streaming solution for any A2DP enabled
Smartphone or Tablet for select 1995-02 Chrysler with optional CD changer. This
Bluetooth receiver allows Chrysler owners to stream audio books, apple music,
turn by turn directions and more directly into audio system and retains use of
the optional CD changer in lower dash, trunk or hatch. If vehicles does not have
a CD changer, purchase our BLU-CHR instead.
See Frequently Asked question at the end of this guide for more details.
Installation
Alert! Module connects directly to radio. CD Changer (required) remains
connected and functional.
Radio removal from dashboard required to gain access to connector. Vehicle
specific radio removal is not part of this guide; however, some may be available
upon request.
1. Disconnect factory CD changer plug (See Fig.2) from radio 8-pin “CD”
changer connector (See Fig. 1).
Fig. 1
2. Connect factory CD changer plug (See Fig. 2), to 8-pin connector on
adapter (See Fig. 3)
Fig. 2
Fig. 3
3. Connect 8—pin plug from adapter (See Fig. 2) to 8-pin “CD” changer
connector on radio (See Fig. 1)
4. Connect/splice/Tap red wire (See Fig. 4) to a 12V accessory (switched)
supply in vehicle. 12V accessory or switched supply is available on
radio harness.
Warning: Avoid connecting 12V accessory wire to battery (always on)
supply.

Fig. 4
5. Re-assemble dashboard and proceed to “Pairing”
Pairing
Pairing process varies between Bluetooth devices but basic steps are the same.
This process is done upon initial install and will not have to be repeated.
1. Turn ignition and radio “ON”
2. On audio device (e.g. Smartphone): Go to Settings, Wireless &
Networks, Bluetooth Settings
3. Select Bluetooth and turn it “ON” (if not already ON).
4. Select Bluetooth settings
5. Tap Scan for devices .
6. Wait for Bluetooth device name (See below) to appear and select it.
LED inside module peephole glow steady.
Note:
Pair multiple devices (10) but only one connection is supported.
Optional remote control
Purchase optional Smart remote to control music apps on the road or at home.
Optional smart remote control allows users to:
1. Keep audio device in pocket, glovebox, purse or elsewhere
2. To track up/down within playlist etc.
3. To adjust audio device volume (up/down)
Warning: Smart remote does not control functions on factory radio.
Pairing:

Operation:
Use wireless remote to perform the following functions on any iOS7.0 and higher
or Android 4.4 and higher.
Package Contents:
Test operation
1. Load at least one “CD”in changer magazine
2. Turn ignition and radio “ON”
3. Press “MODE” button on radio (Track/Disc number will be displayed)
3. Launch Bluetooth streaming application on audio device
4. Use radio volume control button to set the playback level. If distorted,
lower volume on audio device or if inaudible, raise volume on audio
device.
Warning! Playlist and Track selection is *NOT* possible from the
Radio. Use smartphone built-in controls to access and control audio
files and applications
To listen to CD’s:
a. Press “MODE”button on radio to enter CD changer mode
b. Disable Bluetooth on audio device.
CD Changer playback resumes. (Control changer from radio as
customary)
2. To return to music streaming:
Enable Bluetooth on audio device settings screen.
Note: Music streaming has priority and remains that way until
Bluetooth is disabled on audio device. CD changer playback is only
possible when audio device is not paired is out of range (approx. 30 ft.)
5. If correct operation is confirmed, tuck away any extra wires and enjoy
your new Bluetooth streaming module.

Frequent asked questions
1. How do I switch between streaming and CD changer playback?
The module automatically switches to CD upon un-pairing mobile device.
Simply un-pair audio device, press radio “MODE” button and control CD
changer functions as customary. To resume music stream simply pair
mobile device.
2. Will this adapter work on all 1995-02 Chrysler radios?
This adapter works on any 1995-02 Chrysler, Jeep, Dodge, and Plymouth
that has a remote/external CD changer. CD changer must be in working
order for this adapter to work. Some vehicles may include a separate cd
changer in lower dash while others have the CD changer in trunk/hatch,
glovebox, armrest etc.
When in doubt check your application prior to ordering.
3. Can I control smartphone from radio buttons?
NO; you must use audio device built-in controls to access music files. Radio
volume control button is used to set playback level. A safer option is to
purchase optional remote control which also helps to keep eyes on the road.
4. Can I use the A2D-CHRY to make/receive phone calls?
NO; The A2D-CHRY is for audio streaming and does not support hands-free
calls.
5. My vehicle does not have a separate CD changer, will the A2D-CHYR
work?
NO!, For the A2D-CHRY to work as described, the 1992-02 Chrysler vehicle
must include a working CD changer, otherwise purchase our BLU-CHRY
Disclaimer
• This product has no affiliation with Chrysler
• We’re not liable for misuse of this product.
•Whenever possible professional installation is recommended.
For additional questions email [e-mail]
© 1995-2021-08-13 Discount Car Stereo, Inc. All rights reserved. Information in this document is
subject to change without notice. Other products and companies referred to herein are
trademarks or registered trademarks of their respective companies or mark holders.