Displays2go 2TCASE User manual

2TCASE - Display Case
*** 2 People are needed for assembly***
Step 1: Remove all pieces from black
travel case
***Bottom Case Assembly***
Step 2: Needed: Front & back panels with
black feet.
Have (1) person hold the panels on
edge parallel to each other (as shown)
Step 3: Needed: (2) Side panels with extended
corner extrusion (not the side panels
with the washer & screw)
Have 2nd person slide the panels in
(as shown)
Step 4: Use the included allen key to tighten the
(4) screws inside the legs of the side panels
Step 5: Using (2) people, stand the bottom
case assembly upright & set aside
Step 6: Needed: Wooden floor panel
With the unit upright, open the door &
insert the wooden floor panel by pushing
it down in the base until it is fully seated in
the extrusion. The wooden floor panel is
pressure-fitted into the unit, so extra force
may be required to properly place panel in
the unit
Note: The wooden floor panel is the panel with all the
hardware attached on the underside. Remove all
hardware from the panel before assembly
Step 7: Assemble the bottom by putting together
the (3) non-door panels - then slide in the
light panel and slide on the door
***Top Case Assembly***
Step 8: Using (2) people, stand the top case
assembly upright
Very Important: The top case assembly must be picked up
by the front & back panels. The side panels of the top
case assembly are not secured & will slide out of the
unit if not picked up properly. Highly recommended to
see our assembly video online under the SKU:
2TCASESLVS & 2TCASESBLKL Page 1

2TCASE - Display Case
*** 2 People are needed for assembly***
Step 9: Connect all wires on top of the case.
After completing the wire assembly,
place the top cover over the wires. Make
sure all wires are pushed down & in so
that the top over is properly seated on
the unit.
Step 10: Using (2) people, carefully pick up the
top case assembly. The (4) male
connector rods on the bottom of the
top case assembly should fully sit inside
the extrusion on the bottom case
assembly.
Very Important: The top case assembly must be picked up by
the front & back panels. The side panels of the top case
assembly are not secured & will slide out of the unit if not
picked up properly.Highly recommended to see our
assembly video online under the SKU: 2TCASESLVS &
2TCASESBLKL
Step 11: With all doors open on both the
top & bottom cases, proceed to
connect the wiring from the
bottom case to the wiring on
the top case.
Step 12: Connect all side bulbs
Step 13: Insert rubber pieces into the
metal shelf holders
Step 14: Place all shelves in (frosted shelf
goes in base of top unit)
Step 15: Plug in
Page 2
Frosted Shelf