Compliance Information
FCC
Compliance Notice
Supplier's Declaration
of
Conformity
Product name;
OJI
MIC
Model Number:
AST01
/
ASR01
Responsible Party:
OJI
Technology,
Inc.
Responslble
Party
Address
;
201
S.
Victory
Blvd.,
Burbank,
CA
91502
Website:
www.dji.com
We
,
OJI
Technology, Inc., being the responsible party, declares that
the above mentioned model
was
tested to demonstrate complying
with all applicable
FCC
rules and regulitions.
This device complies with Part 15
of
the
FCC
Rules.
Operation is
subject
to
the
following two conditions: (1) This device may
not
cause harmful interference, and (2) This device must accept any
interference
received.
including
interference
that
may
cause
undesired operation.
Any changes
or
modifications not expressly approved by the party
responsible
for
compliance could void
the
user's
authority
to
operatethe equipment.
This
equipment
has
been
tested and found
to
comply with the limits
for
a
Class
B digital device, pursuant
to
part 15
of
the
FCC
Rules.
These limits are designed
to
provide reasonable protection against
harmful interference in a residential installation. This equipment
generates,
uses
and
can
radiate radio frequency energy and,
if
not
installed and used in accordance with the instructions, may cause
harmful interference
to
radio communications. However, there is
no
guarantee thatinterference will notoccur
in
aparticularInstallation.
If
this equipmentdoes
cause
harmful interference
to
radio
or
television
reception, which
can
be
determined by turning the equipment
off
and on, the user
Is
encouraged
to
try
to
correct the interference by
one
or
more
of
the following measures:
-Reorient
or
relocate the receiving antenna.
-Increase the separation between theequipmentand receiver.
-Connect the equipment into an outleton a circuit different from
thatto which the receiver
is
connected.
-Consult the dealer
or
an experienced radio/TV technician
for
help.
This equipment complies with
FCC
radiation exposure limits set
forth
for
an
uncontrolled
environment.
End
user
must
follow
the
specific
operating
Instructions
for
satisfying
RF
exposure
compliance. This transmitter must not
be
co-located
or
operating in
conjunction with any otherantenna
or
transmitter.
The
portable
device is
designed
to
meet
the
requirements
for
exposure
to
radio
waves
established
by
the
Federal
Communications Commission
(USA).
These requirements set a
SAR
limit
of
1.6 W/kg averaged over one
gram
of
tissue.
The
highest
SAR
value reported under this standard
during
product
certification for use when properly
worn
on the
body.
I
SED
Compliance Notice
CAN
ICES-003
(B)
/
NMB-003(B)
This device contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation,
Science
and Economic Development
Canada's
licence-exempt
RSS(s).
Operation
Is
subiect
to
the
following
two
conditions:
(1
)This
device may not
cause
int
erference.
(2)This device must accept any interference, including interference
that may
cause
undesiredoperation
of
thedevice.
L'emetteur/recepteur
exempt
de
licence
contenu
dans
le
present appareil est conforme aux
CNR
d'lnnovatIon, Sciences
et
Developpement economlque Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorlsee aux deux
conditions
suivantes
:(1
)L'appareil
ne
dolt
pas
produire
de
brouillage; (2)L'appareil doltaccepter tout brouillage radioelectrique
subi, meme
si
le brouillage est susceptible d'en compromettre le
fonctionnement.
This equipment complies with
RSS-102
radiation exposure limits
set forth
for
an uncontrolled environment.
End
user must follow
the
specific
operating
instructions
for
satisfying
RF
exposure
compliance. This transmitter must
not
be co-located
or
operating
In
conjunction with any other antenna
or
transmitter.The portable
device is designed to meet the requirements for exposure to radio
waves established bythe
CNR
102.
Cet
equipement
est
conforme
aux
limites
d'exposition
aux
rayonnements
RSS-102
etablies
pour
un
environnement
non
contr0le. L'utilisateur final
doit
suivre les instructions specifiques
pour
satisfaire les normes. Cet
emetteur
ne
dolt
pas
etre
co-
implante ou fonctionner en conjonction
avec
toute autre antenne
ou transmetteur.
Le
disposit1f
portatif
est con~u
pour
repondre
aux
exigences
d'exposition
aux
ondes
radio
etablie
par
le
developpement energetique
DURABLE.
These
requirements set a
SAR
limit
of
1.6 W/kg averaged over one
gram
of
tissue. The highest
SAR
value reported under this standard
during
product
certification for use when properly
worn
on
the
body.
Ces
exigences
un
SAR
llmlte
de 1,6
W/kg
en moyenne
pour
un
gramme
de
tissu.
La
valeur
SAR
la
plus
elevee
signalee
en
vertu de
cette norme lors de la certification de produ1t autiliser lorsqu'il est
correctementporte surle corps.
China Compliance Notice
Q1t).ffi
:'lfflaJJ;
U!
~ LI 1-lftffl
~;J~~
•:.-•u
(Pb)
(Hg)
(Cd)
(Cr~
(PBB)
(PBDE)
tiirtilt&
X 0 0 0 0 0
$'~!JI!!
X 0 0 0 0 0
;a~m
X 0 0 0 0 0
<~an
l
~-81114 X 0 0 0 0 0
fl;Jgi!t:ii~ X 0 0 0 0 0
R~!4-
X 0 0 0 0 0
;ti;~ffll
SJ/T
11364
8\JAA\~!MM.
o:
~IIM!i:EinlWt/HliSJAU~~q:,~~i:E
GB/T
26S72
AAlli'fAIQ
Alf;,1(1:J-i::.
x,
1umUiW4:')J/Ji.¥1>i:Eilllli4£A¥-tsJ~~~""8\J~•l!ltt
GBIT
26sn
AA!iE8\JIIRAJM<.
(P'aa?vS~:ll
ROHS
nn·i;i;~•*)
-
