Installation and operating instructions
for the DHi 2/DHi 11 auxiliary switch
electrical specialists. Electrical laypersons must not install and con-
nect devices of this type due to the considerable potential dangers.
later stage.
Application instructions and warnings
Devices with visible damage must not be installed or used.
When using both contact systems with voltages above 50 V AC or 60 V DC, the
system voltages must have the same origin and the same magnitude.
When removing the opening, no parts of the housing should fall inside the
residual current circuit-breaker.
(blue toggle) with the DFS with a blue toggle.
Intended use and installation
-
switch position of the contact apparatus changes immediately on the DHi.
Pre-selectable settings
functions may be pre-selected:
-
tion of the residual current circuit-breaker.
-
nalled by the DHi.
Assembly
-
eral opening in the region of the toggle on the DFS must be broken through using
via the connector.
Wiring
normally closed contact. All connection terminals are arranged such that they can
also be easily accessed from above in the assembled unit.
Test function
residual current circuit-breaker and thus permits the function of the auxiliary switch
-
the auxiliary switch to activate the test function.
Warranty
All professionally installed, unaltered devices are covered by warranty for the dura-
warranty is not applicable to damage incurred during transport or caused by short-
-
rial being discovered within the warranty period, the company will provide repair or
is opened without authorisation.
Technical data
DHi 2/DHi 11 auxiliary switch for DFS 2 and DFS 4
Rated voltage
Connection terminals
Short-circuit back-up
Maximum number of
conductors per terminal
Duty cycle
Mounting type
Dimensions
Wiring diagram
12
14
22
11
21
Dimensional drawing
85
9
6
71
45
||
Doepke
DE EN
