Draytek Vigor2760 User manual

www.draytek.net.nz
www.snappernet.co.nz
Vigor2760 » Quick Start Guide
Configure your computer’s network
Connect your computer to the Vigor2760 with an Ethernet cable (supplied). Ensure your computer is obtaining an IP
address automatically.
Connect to the Web Interface
Open your Web Browser (e.g. Internet Explorer, Google Chrome or Mozilla Firefox), enter http://192.168.1.1/ into
the address bar, and press the Enter key on your keyboard.
You should be asked for a username and password. Enter admin into both fields (the password may show as dots or
stars) and click the Login button.
Run the Quick Start Wizard
On the left-hand navigation menu, click Wizard and then Quick Start Wizard.
Choose a new Administrator password - you will use this to log into the Web
Interface in future. Enter this password (the password may show as dots or stars)
into both fields and click Next.
Select the correct Timezone. For New Zealand this will be found at the bottom and listed as (UTC+12:00)
Auckland, Wellington. Click Next.
Ensure the Protocol is set to PPP and click Next.

Enter the username and password provided to you by your Internet Service Provider. Username should be in the
form of an email address, and the password will need to be entered into both the Password and Confirm Password
fields. All fields are case sensitive.
In the ADSL section (you may need to click on ADSL to expand this) enter the following settings depending on
whether you have an ADSL or VDSL connection, then click Finish.
ADSL
VDSL
Configure VID Tag (VDSL only)
On the navigation menu, click Network and then WAN. Select the DSL tab and tick the checkbox of the profile
named "[DSL] PVC1". Click the Edit button.
Locate the VLAN Encapsulation option and enable it. The VLAN ID box will appear, enter 10 and click Apply.
Need help?
We’re available 9:00am to 5:00pm, Monday to Friday.
Phone: [phone]
Email: [email protected]z
Firmware updates are available free of charge from www.draytek.net.nz