Dream On Me 401 Quick guide

INSTRUCTIONS FOR SAFE USE
Babies can FALL from product resulting in head injuries.
Prevent access to stairs, steps and uneven surfaces.
Guard all fires,heating and cooking appliances.
Remove hot liquids, electrical flexes and other potential hazards from reach.
Prevent collisions with glass in doors, windows and furniture.
This product frame should be used only for short periods of time (e.g.20mins).
This product frame is intended to be used by children who can sit unaided,
approximately from 6 months. This product is not intended for children weighing more
than 26.4LB who can walk or climb out of product unassisted.
Check regularly that: All fastenings and components are secure. Tighten and adjust
as necessary and the castors rotate and run freely. That no components are broken
or missing.
Do not use the stationary activity center if it is damaged or broken.
Non-approved spare parts may render the repair or baby activity center unsafe
Poduct are:
Wipe all plastic/metal parts clean with a damp cloth using mild soap, dry thoroughly.
Light soiling of the seat pad can be with a damp cloth
Machine wash seat pad in cold water on a gentle cycle. Do not use strong detergents or
abrasive materials. Do not dry clean. Do not tumble dry. Line dry the seat pad.
To maintain stopping performance, clean friction strips regularly with damp cloth.

Item No.: #401
IMPORTANT! KEEP FOR FUTURE REFERENCE.
Read all instructions carefully before use and keep them for future reference. The child
may hurt if you do not follow the instructions.
Adult assembly required.
WARNING
To prevent serious injury or death,use only for a child who is able to hold head upright
unassisted and who is not able to walk or climb out of product.
Never leave child unattended.
Never use near steps, pools, hot surfaces or areas that may be hazardous to a child.
Product may move during use.
To avoid tip-over, place product on a flat level surface.
Strings can cause strangulation! DO NOT place items with a string around child’s neck,
such as hood strings or pacifier cords. DO NOT suspend strings over product or attach
strings to toys.
Battery Information:
Do not mix new and used batteries.
Do not mix different types of batteries.
Only use replacement batteries of the type batteries,
2x1.5V,‘AA’/SUM3 / LR6
Always remove exhausted batteries from the not attempt to charge
batteries.
Remove rechargeable batteries before charging.
Charge under adult supervision.
The batteries must be inserted with the correct polarity.
Do not short-circuit the supply terminals.
Battery Disposal:
Dispose of exhausted batteries at an official waste disposal site.
Do not burn or place in waste. 1

3xebutemarF3xesaB
Base tube x3Butterfly toy x1 Octopus toy x1
Seat unit x1
Lollipop & bee
toy bar x1
Parts
Rainbow toy x1
Play tray x1
Assemble the Frame Parts
Insert the frame part A,frame part B and frame part C
into the corresponding place of the upper tray overleaf
one by one, and then use the family cross screwdriver
to fix the screw well.
C
AB
2
Frame x1
Frame Part A x1
Frame Part B x1
Frame Part C x1
AB
C
Please check to make sure that all of the following parts listed are
included in the box when opened. I there are any missing parts,
please contact before using the product.

3
Insert and “snap” the seat unit into the
seat ring with moderate force, pull up on
the seat to be sure it is secure.
Fit the seat unit
Assemble the base and base tube
Install the strap of the frame tube into the frame
Assemble the frame tube into the base
Place a base on the flat surface. While
pressing the button “a” on a base, insert
it into the base tube “b”. Continue to slide
the base into the base tube until you hear
a “click”. Repeat this to assemble
the other base to the other base tube.The
final base assemble of this product is a circle.
Fit the strap of the frame tube into the desired
slot in the frame side.(Pic1) Pull the strap to the
desired height 1,2,3,push to “snap” and
fasten the strap.(Pic2 & Pic3)
Repeat this process to attach the other two
straps to the frame.IMPORTANT! Make sure
all three straps are adjusted to the same height.
While pressing the button “a” on a frame tube,
insert it into a base tube”b”. Continue to slide
the frame tube into the base tube until you hear
a “click”. Pull up on the frame tube to be sure it
is secure.Repeat this procedure to assemble the
two remaining frame tubes on the base tubes.
a
b
3
2
1

4
Attaching the rainbow toy
Push downward the toy rainbow press
down and clockwise rotation until
position. 2xAA size Alkaline batteries
are needed for the toy (batteries not
included). Put batteries into the toy tray.
The toy should be assembled by adult.
Attaching the toy tray
Place the toy tray into the holes located on
the top section and turn the tabs around to
secure the toy tray to the walker.
To attach the octopus and butterfly
Positionthe octopus andbutterfly toys over
the slots in the front uptrayandinsertthe
tabs on the toys into the slotsonthetrayup
and turn them in aclockwisedirectionuntil
they lock into place.
Attaching the lollipop & bee toy bar
Position the lollipop & bee toy bar over the
slots in the rear up tray and turn them in a
clockwise direction until they lock into place.

To rotate the seat
5
The seat can be rotated by 360 degree .
INSTRUCTIONS FOR SAFE USE
READ THESE INSTRUCTIONS CAREFULLY BEFORE
USE AND KEEP THEM FOR FUTURE REFERENCE.
THE CHILD MAY HURT IF YOU DO NOT
FOLLOW THESE INSTRCUTION.
WARNING:A CHILD’S SAFETY IS YOUR RESPONIBILITY
WARNING:NEVER LEAVE THE CHILD UNATTENDED
WARNING:THE CHILD WILL BE ABLE TO REACH FARTHER AND MOVE
RAPIDLY WHEN IN THE ACTIVITY CENTER.
Prevent access to starirs,steps and uneven surfaces.
Guard all fires,heating and cooking appliances.
Remove hot liquids,electrical flexes and other potential hazards from reach.
Prevent collisions with glass in doors,windows and furniture.
This activity center frame should be used only for short periods of time(e.g.20mins).
The activity center frame is for a child able to support its head unaided up to a
maximum weight of 26.4LB.
Before use:Check that the Activity center is correctly assembled.
Check regularly that :All fastenings and components are secure. That no components are
broken or missing.
Do not use the activity center if any components are broken or missing.
Do not use replacement parts other than those approved by the manufacturer
or distributor.
Non-approved spare parts may render the repair or activity center unsafe.
WARNING! DO NOT USE THE BABY BOUNCER AS A SWING!
Place your child in the seat, check the distance between your baby’s feet and the floor.
Your child’s toes should touch the floor(without bouncing). If your child’s entire foot is
touching the floor or the toes are not touching the floor at all, adjust the height to any of
three positions(one for the smallest child and three for the tallest child).
To ensure that the child is correctly and safely positioned in the seat of the baby bouncer.
Please be aware of the danger of allowing other childre to play near the activity center.

6
Product care:
Wipe all plastic/metal parts clean with a damp cloth using mild soap,dry thoroughly,
light soiling of the seat pad can be a damp cloth and a mid soap. Machine
wash seat pad in cold water on a gentle cycle.
Do not use strong detergents or abrasive materials.
Do not dry clean.
Do not tumble dry.
Line dry the seat pad.
To maintain stopping performance,clean friction strips regularly with damp cloth.
Thank you for choosing Dream On Me and congratulations on joining The DOM Family,
a family that has been transforming lives for 30 years! We appreciate your feedback and
wish you the very best in the coming years with your new addition. If you have any questions
or concerns please don’t hesitate to reach out and a trusted DOM representative will
assist you. Thank you again for entrusting us to supply you with the safest, functional
and affordable baby products and accessories. Feel free to follow us on Facebook and
Instagram for further opportunities and offers.
Dream On Me Inc.
1532 S Washington Ave Piscataway Twp. NJ 08854
Fax: [phone]

.
.
Battery Information:
.
Battery Disposal:
1
: #401

C
AB
2
Base x3
x1
AB
C

3
a
b
3
2
1

4
To attach the octopus and butterfly
Position the octopus and butterfly toys over
the slots in the front up tray and insert the
tabs on the toys into the slots on the tray up
and turn them in a clockwise direction until
they lock into place.

5

6
Thank you for choosing Dream On Me and congratulations on joining The DOM Family,
a family that has been transforming lives for 30 years! We appreciate your feedback and
wish you the very best in the coming years with your new addition. If you have any questions
or concerns please don’t hesitate to reach out and a trusted DOM representative will
assist you. Thank you again for entrusting us to supply you with the safest, functional
and affordable baby products and accessories. Feel free to follow us on Facebook and
Instagram for further opportunities and offers.
Dream On Me Inc.
1532 S Washington Ave Piscataway Twp. NJ 08854
Fax: [phone]