Fisher-Price 74067 User manual

Please keep this instruction sheet for future reference,
as it contains important information.
Requires four “AA” (LR6) alkaline batteries for operation (not included).
Adult assembly is required.
Tool required for battery installation:
Phillips screwdriver (not included).
L
E
A
R
N
I
N
G
P
A
T
T
E
R
N
S
L
E
A
R
N
I
N
G
P
A
T
T
E
R
N
S
™
Model Number: 74067
w
w
w.
fi
s
he
r
-p
r
i
c
e
.
c
o
m
Motion & Music Jungle Gym

2
Parts
Gym Arch
2 Supports
3 Soft Animals
Quilt

Battery Installation
Battery
Compartment
Door
• Locate the battery compartment
door on the gym arch.
• Loosen the screws in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Insert four “AA” (LR6) alkaline
batteries, as indicated inside the
battery compartment.
Hint: We recommend using alkaline
batteries for longer life.
• Close the battery compartment
door and tighten the screws with
a Phillips screwdriver. Do not
over-tighten.
• When sounds or motions from this
toy become faint or stop, it’s time
for an adult to change the batteries!
1.5V x 4
"AA" (LR6)
Shown Actual Size
Battery Safety Information
Batteries may leak fluids that can
cause a chemical burn injury or
ruin your toy (product). To avoid
battery leakage:
• Do not mix old and new batteries
or batteries of different types:
alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside
the battery compartment.
• Remove batteries during long
periods of non-use. Always
remove exhausted batteries
from the toy. Dispose of batteries
safely. Do not dispose of batteries
in a fire. The batteries may
explode or leak.
• Never short-circuit the battery
terminals.
• Use only batteries of the same or
equivalent type as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries
from the toy (product) before
charging.
• If removeable, rechargeable
batteries are used, they are
only to be charged under
adult supervision.
3

Assembly
4
• Grasp each end of a support. Pull the ends apart to open the support.
• Repeat this procedure to open the other support.
1
1
• Place the quilt with the print side up on a flat surface.
• Position the supports on either side of the quilt with slots toward the center
of the quilt.
• Fit the two straps on each side of the quilt through the slots in each support.
Make sure the tab at the end of each strap forms a “T” under the support.
• Pull up on the quilt to be sure it is secure to the supports.
2
2Slots
Slots
Supports

Assembly
5
• Position the gym arch over the quilt as shown.
• Fit the two small fasteners straps on the end of each tube through
the slots inside the circular openings in the supports.
• Fasten the two ends of the straps together to secure the tubes to
the supports.
3
3
• Attach the three soft animals to the hangers on the gym arch as shown by
fitting the strap through the slot in each hanger. Make sure the tab at the
end of each strap forms a “T” on the back of the hanger.
4
4
Gym Arch
Tubes
Straps
Tubes
Monkey Zebra Toucan
Bottom View

Fun Music and Motion
6
Power/Volume Switch
• Locate the power/volume switch on the gym arch. The switch has three
positions: off ; on with low volume and on with high volume .
Start Button
• Locate the start button on the gym arch. Press the start button for
extended music, motion and sound effects.
• Music will play continuously for about two minutes while motions will
go on and off.
• To restart, press the start button again.
• Baby can bat the soft animal toys for short playing music, motion and
sound effects.
Note: If baby holds the moving toys, you may hear a clicking sound.
This is normal and will not damage the toy.
Hint: If your child is not actively playing with this toy, it turns off automati-
cally (sleep mode).
• Slide the power/volume switch to the off position when not in use.
As Baby Grows
When your child is older, remove the gym arch and attach the animals to
the buttonholes on the quilt for floor play.
Power/Volume Switch
Start Button

Care
Soft Animals
• Push the tabs on the animals back through the slots in the hangers
to remove.
• Place the toys in a pillowcase and wash them in cold water on a gentle
cycle. Do not use bleach. Tumble dry the toys on low heat.
Quilt
• Remove the gym arch and supports.
• Wash the quilt in cold water on a gentle cycle. Do not use bleach.
Tumble dry the quilt on low heat.
Gym Arch and Tubes
• Wipe the surface with a clean cloth dampened with a mild soap and
water solution.
• Do not immerse the gym arch or tubes.
Pack it Up
• Grasp each end of a support and fold them in and together as shown.
• Bring the corners of the quilt together and attach the fasteners as shown.
7

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
© 2003 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Consumer Information
Questions? We'd like to hear from you!
Call Fisher-Price®Consumer Relations, toll-free at
1-800-432-5437, 8 AM - 6 PM EST Monday through Friday.
Hearing-impaired consumers using TTY/TDD equipment, please
call 1-800-382-7470. Or, write to: Fisher-Price®Consumer
Relations, 636 Girard Avenue, East Aurora, New York 14052.
Printed in China 74067a-0920
FCC Note (United States Only)
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's authority
to operate the equipment.
For countries outside the United States:
CANADA
Questions? 1-800-567-7724, Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2.
GREAT BRITAIN
Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500302.
AUSTRALIA
Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
NEW ZEALAND
16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA
Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.