DS Services of America 200K Series User manual

1. Turn o the hot tank heater switch
on the back of the dispenser and
unplug your unit (Fig 1). Let the unit
stand for one hour before cleaning
to allow the hot tank to cool.
Fig 2 Fig 3
Fig 4
DIY: HOW TO CLEAN
YOUR WATER DISPENSER
Your water dispenser exterior should be thoroughly cleaned every 6 months, and
your CrystalFlo water cartridge replaced every 12 months. If you do not have a
replacement cartridge handy, you can order one here and it will be shipped
directly to you.
Before you start cleaning, wash your hands thoroughly with soap and water for at least 20 seconds.
TIP: Have a bucket nearby to dispose of the used
CrystalFlo cartridge, which will contain water.
TM
3. Press the cover lock on the top rim
of the cooler and pull up to open
(Fig 3).
4. Pull CrystalFlo water cartridge upward to remove (Fig 4). Do not squeeze
the water reservoir as water could leak out.
WHAT YOU’LL NEED:
• CrystalFlo replacement cartridge
• 70% rubbing alcohol or disinfecting wipes
• Clean cloth or soft brush
• Rubber gloves
• Bucket
• Towels to absorb any water spills
TIP: The best time to replace your water cartridge and clean your dispenser
is when the existing water bottle is empty.
WARNING: Always use caution when handling hot water.
2. Place a glass or other container
below the water faucets to catch
any drips (Fig 2).
Fig 1

Fig 6
Fig 5
7. Close the top cover by pushing down to lock into place (Fig 6). If cover does
not close, check the CrystalFlo cartridge to make sure it is inserted completely.
8. Clean the cabinet, bottle receptacle and spigots with 70% rubbing alcohol or
disinfecting wipes. Vacuum or wipe the grill on the back of the dispenser to
remove any dust.
©2020 DS Services of America, Inc.
TM
5. Before installing the new replacement cartridge, ensure that the seal is properly
installed on the inlet/outlet tube of the CrystalFlo water cartridge assembly as it
may have shifted during shipment or un-packaging.
6. Align the CrystalFlo water cartridge with openings in cooler (Fig 5). With rm
pressure, push downward to lock the water cartridge into place. Ensure that
foam seal is pushed down and seals the reservoir completely.
Fig 7
9. Clean the drip tray and grill by emptying the tray and cleaning the tray and grill
with mild soap or by placing them on the top rack of the dishwasher (Fig 7).
TIP: The drip tray and grill should be cleaned monthly.
10. Wipe down the cooler and the surrounding area to dry any water spills. Turn on the
hot tank heater switch.
11. Wash your hands thoroughly with soap and water for at least 20 seconds.
Install a full water bottle on the dispenser.
12. Dispense water through the cold and hot spigots to prime the water cooler.
WARNING: Dispense water through the hot and cold spigots.
Failure to follow proper installation instructions may cause
damage to water dispenser.
Load water
bottle FIRST.
1
Dispense
water from
hot and cold
faucets.
2