DS Services of America Pure Water Dispenser 100 Series User manual

WHAT YOU’LL NEED:
• 70% rubbing alcohol or disinfecting wipes
• Dishwashing soap
• Clean cloth or soft brush
• Disposable non-latex gloves
• Hot water (about a gallon)
• Heat-resistant container, like a metal pot
• Towels to absorb any water spills
1. Turn o the hot tank heater switch on the back of the dispenser and unplug your unit
(Fig 1) . Let the unit stand for one hour before cleaning to allow the hot tank to cool .
(NOTE: If your cooler does not dispense hot water, you can proceed immediately to Step 2.)
2. Remove the water bottle and drain the water reservoir by dispensing water through
the hot and cold spigots .
3. Clean the cabinet, bottle receptacle and spigots with 70% rubbing alcohol or disinfecting
wipes. Vacuum or wipe the grill on the back of the dispenser to remove any dust.
4. Clean the drip tray and grill by emptying the tray and cleaning the tray and grill with
dishwashing soap or by placing them on the top rack of the dishwasher (Fig 2).
5. Remove the no-spill dispenser insert.
– If your insert has a notch, remove by pulling
up on the notch located on the top rear of
the dispenser (Fig 3a).
– If your dispenser insert has arrows, twist the
insert to align the “Open”arrows. Pull up (Fig 3b).
DIY: HOW TO CLEAN
YOUR WATER DISPENSER
Your water dispenser should be thoroughly cleaned at least twice a year. If your
dispenser hasn’t been used in a while, we recommend ushing the equipment
prior to cleaning. Here are instructions for do-it-yourself cleaning:
Before you start cleaning, wash your hands thoroughly with soap and water for at least 20 seconds.
Fig 1
Fig 2
Fig 3a Fig 3b
TIP: The drip tray and grill should be cleaned monthly.
TIP: The best time to clean your dispenser is when the existing water bottle is empty.
WARNING: Always use caution when handling hot water.
®

6. Remove the separator by pulling it straight out.
Make note of the separator positioning before
removing so that it can be re-installed correctly.
Clean these parts with dishwashing soap and let
them dry thoroughly (Fig 4).
No-spill
dispenser insert
Air lter
Separator
Reservoir
Fig 4
8. Wearing disposable non-latex gloves, wipe the inside of the reservoir with a clean
cloth or soft brush. Use caution as the water may still be hot to the touch (Fig 6).
9. Completely drain the water from the reservoir by dispensing the water through
the hot and cold spigots into a container .
10. Repeat steps 7 and 9 to completely ush the dispenser. It is not necessary to wipe
the inside of the reservoir a second time.
11. Replace the separator and the no-spill dispenser insert. Wipe down the cooler and
the surrounding area to dry any water spills.
12. Wash your hands thoroughly with soap and water for at least 20 seconds. Install
a full water bottle on the dispenser. Dispense water through the hot and cold
spigots. Plug it in and turn on the hot tank heater switch located at the rear
of the dispenser.
Fig 6
7. Carefully pour hot water into the reservoir until it is ¾ full. Let the water sit
for 5 minutes (Fig 5). Always use caution when handling hot water.
©2020 DS Services of America, Inc.
Fig 5
1
3
2
Load water bottle FIRST.
Dispense water from
hot and cold faucets.
THEN plug in dispenser
and turn on the hot
tank switch.
WARNING: Dispense water through the hot and cold
spigots before plugging in and turning on the hot tank
switch. Failure to follow proper installation instructions
may cause damage to water dispenser.
®