DS Services of America Pure Water Dispenser 200 Series User manual

1. Turn o the hot tank heater switch on the back of the dispenser (Fig 1). Let the unit stand
for one hour before cleaning to allow the hot tank to cool .
2. Remove the water bottle and drain the water reservoir by dispensing water through
the hot and cold spigots .
3. Clean the cabinet, bottle receptacle and spigots with 70% rubbing alcohol or disinfecting
wipes. Vacuum or wipe the grill on the back of the dispenser to remove any dust.
4. Clean the drip tray and grill by emptying the tray and cleaning the tray and grill with
dishwashing soap or by placing them on the top rack of the dishwasher (Fig 2).
5. Press the cover lock on the top rim of the
cooler and pull up to open (Fig 3). Remove
the separator by lifting from one edge
with slow, steady pressure. Make note of
the separator positioning before removing
so that it can be re-installed correctly (Fig
4). (Note that the separator is designed to
t tightly in the reservoir and will require
force to remove.) Clean the separator with
dishwashing soap and dry thoroughly.
Fig 2
Fig 1
Fig 3 Fig 4
DIY: HOW TO CLEAN
YOUR WATER DISPENSER
WARNING: Always use caution when handling hot water.
WHAT YOU’LL NEED:
• 70% rubbing alcohol or disinfecting wipes
• Dishwashing soap
• Clean cloth or soft brush
• Disposable non-latex gloves
• Hot water (about a gallon)
• Heat-resistant container, like a metal pot
• Towels to absorb any water spills
TIP: The drip tray and grill should be cleaned monthly.
TM
TIP: The best time to clean your dispenser is when the existing water bottle is empty.
Your water dispenser should be thoroughly cleaned at least twice a year. If your
dispenser hasn’t been used in a while, we recommend ushing the equipment
prior to cleaning. Here are instructions for do-it-yourself cleaning:
Before you start cleaning, wash your hands thoroughly with soap and water for at least 20 seconds.

7. Wearing disposable non-latex gloves, wipe the inside of the reservoir with a clean
cloth or soft brush. Use caution as the water may still be hot to the touch (Fig 6).
8. Completely drain the water from the reservoir by dispensing the water through
the hot and cold spigots into a container .
9. Repeat steps 6 and 8 to completely ush the dispenser. It is not necessary to wipe
the inside of the reservoir a second time.
Fig 6
Fig 5
Fig 7
6. Carefully pour hot water into the reservoir until it is ¾ full (Fig 5). Let the water
sit for 5 minutes. Always use caution when handling hot water.
10. Replace the separator and close the cover (Fig 7). Wipe down the cooler and the
surrounding area to dry any water spills.
11. Wash your hands thoroughly with soap and water for at least 20 seconds. Install
a full water bottle on the dispenser. Dispense water through the hot and cold
spigots. Turn on the hot tank heater switch located at the rear of the
dispenser.
TM
©2020 DS Services of America, Inc.
WARNING: Dispense water through the hot and cold
spigots before turning on the hot tank switch. Failure
to follow proper installation instructions may cause
damage to water dispenser.
Load water
bottle FIRST.
1
THEN turn on the
hot tank switch.
3
Dispense
water from
hot and cold
faucets.
2