DSE DSEGenset DSE8004 User manual

DSE8004 Operator Manual ISSUE: 2
DEEP SEA ELECTRONICS PLC
DSE8004 Operator Manual
Document Number: 057-229
Author: Ashley Senior

DSE8004 Operator Manual
2
DEEP SEA ELECTRONICS PLC
Highfield House
Hunmanby
North Yorkshire
YO14 0PH
ENGLAND
Sales Tel: [phone]
Sales Fax: [phone]
E-mail: [e-mail]
Website: www.deepseaplc.com
DSE8004 Operators Manual
© Deep Sea Electronics Plc
All rights reserved. No part of this publication may be reproduced in any material form (including
photocopying or storing in any medium by electronic means or other) without the written permission
of the copyright holder except in accordance with the provisions of the Copyright, Designs and
Patents Act 1988.
Applications for the copyright holder’s written permission to reproduce any part of this publication
should be addressed to Deep Sea Electronics Plc at the address above.
The DSE logo is a UK registered trademarks of Deep Sea Electronics PLC.
Any reference to trademarked product names used within this publication is owned by their
respective companies.
Deep Sea Electronics Plc reserves the right to change the contents of this document without prior
notice.
Amendments List
Issue No. Comments
1 First Release
2 Added support for DSE8610 MKII and DSE8660 MKII
Clarification of notation used within this publication.
NOTE: Highlights an essential element of a procedure to ensure correctness.
CAUTION! Indicates a procedure or practice, which, if not strictly observed, could result in
damage or destruction of equipment.
WARNING! Indicates a procedure or practice, which could result in injury to personnel or
loss of life if not followed correctly.

DSE8004 Operator Manual
3
TABLE OF CONTENTS
Section Page
1 BIBLIOGRAPHY.............................................................................................. 6
1.1 INSTALLATION INSTRUCTIONS ........................................................................6
1.2 MANUALS............................................................................................................6
2 INTRODUCTION.............................................................................................. 7
3 SPECIFICATIONS............................................................................................ 8
3.1 SHORT NAMES...................................................................................................8
3.2 OPERATING TEMPERATURE ............................................................................8
3.3 TERMINAL SPECIFICATION...............................................................................8
3.4 POWER SUPPLY REQUIREMENTS ...................................................................8
3.4.1 MODULE SUPPLY INSTRUMENTATION DISPLAY......................................8
3.5 DIGITAL INPUTS/OUTPUTS A TO C ..................................................................9
3.5.1 CONFIGURED AS INPUTS ...........................................................................9
3.5.2 CONFIGURED AS OUTPUTS .......................................................................9
3.6 CONFIGURABLE VOLT-FREE OUTPUT D.........................................................9
3.7 COMMUNICATION PORTS................................................................................10
3.7.1 COMMUNICATION PORT USE ...................................................................11
3.7.1.1 USB CONNECTION........................................................................................11
3.7.1.1.1 USB SLAVE PORT (FIRMWARE UPDATE) ................................................11
3.7.1.1.2 USB HOST PORT (CONFIGURATION).......................................................11
3.7.1.2 RS232 PORT ..................................................................................................12
3.7.1.3 RS485 PORT ..................................................................................................12
3.7.1.3.1 CABLE SPECIFICATION.............................................................................12
3.7.1.4 ETHERNET PORT..........................................................................................13
3.7.1.4.1 DIRECT MODULE CONNECTION...............................................................14
3.7.1.4.2 CONNECTION TO BASIC ETHERNET .......................................................15
3.7.1.4.3 CONNECTION TO COMPANY INFRASTRUCTURE ETHERNET...............16
3.7.1.4.4 CONNECTION TO THE INTERNET ............................................................17
3.7.1.4.5 FIREWALL CONFIGURATION FOR INTERNET ACCESS..........................18
3.8 SOUNDER..........................................................................................................19
3.8.1 ADDING AN EXTERNAL SOUNDER TO THE APPLICATION....................19
3.9 DIMENSIONS AND MOUNTING.........................................................................20
3.9.1 DIMENSIONS ..............................................................................................20
3.9.2 PANEL CUTOUT .........................................................................................20
3.9.3 DISPLAY DIMENSIONS...............................................................................20
3.9.4 WEIGHT ......................................................................................................20
3.9.5 FIXING CLIPS..............................................................................................21
3.9.6 SILICON SEALING GASKET.......................................................................22
3.9.7 APPLICABLE STANDARDS........................................................................23
3.9.8 ENCLOSURE CLASSIFICATIONS..............................................................24
3.9.8.1 IP CLASSIFICATIONS....................................................................................24
3.9.8.2 NEMA CLASSIFICATIONS .............................................................................25
3.9.8.2.1 THE MODULES NEMA RATING (APPROXIMATE).....................................25
4 INSTALLATION............................................................................................. 26
4.1 CONNECTIONS.................................................................................................26
4.1.1 DC SUPPLY, DIGITAL INPUTS AND OUTPUTS.........................................26
4.1.2 RS485 & RS485/CAN CONNECTOR..........................................................27
4.1.3 USB SLAVE (FIRMWARE UPDATE) CONNECTOR...................................28
4.1.4 USB HOST (CONFIGURATION) CONNECTOR..........................................28

DSE8004 Operator Manual
4
4.1.5 RS232 CONNECTOR..................................................................................29
4.1.6 ETHERNET CONNECTOR..........................................................................30
4.2 TYPICAL WIRING DIAGRAM.............................................................................31
4.2.1 TYPICAL WIRING OF RS485......................................................................31
4.3 CONFIGURATION (GRAPHICAL USER INTERFACE SETUP) .........................32
5 DESCRIPTION OF CONTROLS.................................................................... 33
5.1 DISPLAY............................................................................................................34
5.1.1 SYSTEM OVERVIEW..................................................................................34
5.2 CONTROL PUSH-BUTTONS.............................................................................35
5.2.1 START/STOP BUTTONS ............................................................................35
5.2.2 WHEN CONNECTED TO DSE8X10............................................................36
5.2.3 WHEN CONNECTED TO DSE8X20............................................................38
5.2.4 WHEN CONNECTED TO DSE8X60............................................................42
5.3 VIEWING THE INSTRUMENT PAGES...............................................................46
5.3.1 CONFIGURABLE WIDGETS.......................................................................47
5.3.2 HOME PAGE...............................................................................................48
5.3.2.1 SUMMARY SECTION.....................................................................................49
5.3.2.1.1 WHEN CONNECTED TO DSE8X10 CONTROLLER ...................................49
5.3.2.1.2 WHEN CONNECTED TO DSE8X20 CONTROLLER ...................................49
5.3.2.1.3 WHEN CONNECTED TO DSE8X60 CONTROLLER ...................................49
5.3.2.1.4 SYNCHROSCOPE DISPLAY.......................................................................49
5.3.2.2 INSTURMENT OVERVIEW.............................................................................50
5.3.2.2.1 WHEN CONNECTED TO DSE8X10 CONTROLLER ...................................50
5.3.2.2.2 WHEN CONNECTED TO DSE8X20 CONTROLLER ...................................50
5.3.2.2.3 WHEN CONNECTED TO DSE8X60 CONTROLLER ...................................50
5.3.3 ENGINE.......................................................................................................51
5.3.4 GENERATOR..............................................................................................53
5.3.5 MAINS..........................................................................................................54
5.3.6 BUS .............................................................................................................55
5.3.7 ALARMS......................................................................................................56
5.3.8 I/O................................................................................................................57
5.3.8.1 DIGITAL INPUTS............................................................................................57
5.3.8.2 DIGITAL OUTPUTS........................................................................................57
5.3.8.3 DSE2130 EXPANSION MODULE....................................................................58
5.3.8.4 DSE2131 EXPANSION MODULE....................................................................58
5.3.8.5 DSE2133 EXPANSION MODULE....................................................................59
5.3.8.6 DSE2152 EXPANSION MODULE....................................................................59
5.3.8.7 DSE2157 EXPANSION MODULE....................................................................60
5.3.8.8 DSE2548 EXPANSION MODULE....................................................................60
5.3.9 SCHEDULE .................................................................................................61
5.3.10 STATUS ...................................................................................................62
5.3.10.1 COMMUNICATION AND MODULE INFORMATION .......................................62
5.3.10.2 COMMISSIONING SCREENS.........................................................................62
6 OPERATION.................................................................................................. 63
6.1 QUICKSTART GUIDE........................................................................................64
6.1.1 SELECTING THE ENGINE..........................................................................64
6.1.2 STARTING THE ENGINE............................................................................64
6.1.3 STOPPING THE ENGINE............................................................................65
6.2 MANUAL FUEL PUMP CONTROL.....................................................................65
6.3 MANUAL SPEED CONTROL.............................................................................66
7 PROTECTIONS ............................................................................................. 67
7.1 PROTECTIONS DISABLED...............................................................................68
7.1.1 INDICATION / WARNING ALARMS.............................................................68

DSE8004 Operator Manual
5
7.1.2 SHUTDOWN / ELECTRICAL TRIP ALARMS ..............................................68
7.2 WARNINGS........................................................................................................69
7.3 ELECTRICAL TRIPS .........................................................................................69
7.4 SHUTDOWNS....................................................................................................69
8 FRONT PANEL CONFIGURATION............................................................... 70
8.1 ACCESSING THE DSE8004 RUNNING EDITOR ..............................................71
8.2 ACCESSING THE DSE8XXX CONTROLLER RUNNING EDITOR....................75
8.3 FRONT PANEL EDITOR ACCESS....................................................................75
8.3.1 FRONT PANEL EDITOR SECURITY...........................................................75
8.3.2 ACCESSING THE DSE8XXX CONTROLLER FRONT PANEL EDITOR
OPERATION.............................................................................................................76
9 MAINTENANCE, SPARES, REPAIR AND SERVICING ................................ 77
9.1 PURCHASING ADDITIONAL CONNECTOR PLUGS FROM DSE.....................77
9.1.1 INDIVIDUAL PLUGS....................................................................................77
9.2 PURCHASING ADDITIONAL FIXING CLIPS FROM DSE..................................77
9.3 PURCHASING ADDITIONAL SEALING GASKET FROM DSE..........................77
10 WARRANTY................................................................................................ 78
11 DISPOSAL .................................................................................................. 78
11.1 WEEE (WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT)................78