Duke 229344 User manual

This manual is Copyright © 2019 Duke Manufacturing Co. All rights reserved.
Reproduction without written permission is prohibited. Duke is a registered
trademark of the Duke Manufacturing Co.
CAUTION: Please read these instructions completely before attempting
to install, operate or service this equipment.
WARNING: Cancer and Reproductive Harm -
www.p65warnings.ca.gov
Instruction Sheet
Proofer and Oven
Handle Replacement
P/N 229344
REV A 10/31/2019
Kit # 229344
Parts In Kit
512917 - 3ea. - SCREW,10-24X1-3/4OV SL SS W/NYLOK
NYTEMP PATCH
502779 - 3 Ea. - SCREW,12-24X2”FL PH SS-NY PATCH HI
TEMP
512920 - 4 Ea. - SCREW,10-32X1-3/4FL PH SS 502780 - 3 Ea. - WASHER,LOCK 1/4”CNSK SS E
154437 - 4 Ea. - WASHER,10 COUNTERSUNK EXT 512905 - 1 Ea. - Door Handle and mounting plate

Installation and Operation of: Door Handle Replacement
Duke Manufacturing Co.
2305 N. Broadway
St. Louis, MO 63102
Phone: [phone]
Toll Free: 1-800-735-3853
Fax: [phone] www.dukemfg.com
INSTRUCTIONS
Step 1
Using a Philips or Straight Blade screwdriver remove
handle from door.
NOTE: Depending on the model of your
unit, your handle may have two (2),
three (3) or four (4) screws holding the
handle in place.
Step 2
Using a Phillips or Straight Blade screwdriver replace
handle on door with new screws.
Step 3
Make sure your handle is adjusted properly. Make
sure the door gasket is slightly compressed alround
the door.
Kit contains three dierent size screws. Make sure you
use the proper screws for your application.
If Existing Door Had:
• 2 screws – Use 2 – P/N 512917 Screws & 2- P/N
154437 washers
• 3 screws (installed at factory) – Use 3 – P/N
512917 Screws & 3- P/N 154437 washers
• 3 screws (from door handle kit) - Use 3 – P/N
502779 Screws & 3- P/N 502780 washers
• 4 screws - Use 4 – P/N 512920 Screws & 4- P/N
154437 washers
NOTE: If holes in door are damaged,
P/N 600144 Door Handle Kit & P/N
502774 Drill Fixture will be required for
repair.