Dundalk LeisureCraft Tiki Bar User manual

Dundalk LeisureCraft
Tiki Bar Assembly
Your Tiki Bar will arrive partially assembled. The bar base is assembled.
All you need to do is attach the bar top and assemble and attach the
roof, and assemble the stools.
Required: Hardware packet:
• people (recommended) 1½” brown ceramic-coated deck screws,
•Rubber Mallet 4” brown ceramic-coated deck screws,
•Cordless Drill (we supply the bit) ¾” zinc-plated flat-head wood screws,
1½” Tin-plated Kreg screws (not shown)
Nylon Cable Clamps.
# Robertson screwdriver bit
Place the bar base in position and fit the bar top over the base as shown.
Insert the roof post assemblies into the two holes on the top of the bar all
the way until they hit bottom.
Roof:
Lay-out the roof parts as shown on the left.
Insert the tenons into the holes, and use a rubber mallet to tap them in
securely, as shown below.

Fasten the six horizontal roof slat boards as shown, with one 1½” deck screw
per joint.
Lay a piece of roof thatch in place, and attach it with supplied ¾” wood
screws and nylon cable clamps close to each end and two places in the
middle evenly spaced out. (4 places)
Also fasten the thatch onto the bottom slat using cable clamps wrapped
around the netting of the thatch as shown (4 places).
Repeat for the other side of the roof.
Set the assembled roof top on top of the roof posts and fasten with 4” deck
screws, (4 places) as shown.
…View Assembly Video online:
https://www.youtube.com/watch?v=KLe-pounehU...
or
Scan this QR code to
watch the Assembly Video
on YouTube
Manufactured by:
Dundalk LeisureCraft Inc Phone: [phone]
318448 8
th
Line E, www.dundalkleisurecraft.com
Dundalk, Ontario Canada
L9V 2K3
www.leisurecraftusa.com