Dunelm Alexis User manual

Alexis Large Sideboard
White High Gloss PVC
H72xW155xD42cm

Thank you for purchasing your new piece of furniture from Dunelm.
We put a lot of effort in the design and construction of our products to ensure they set the standard for
quality, durability and ease of assembly.
If for any reason you feel we haven’t lived up to the high standards we set ourselves, please don’t
hesitate in contacting us on 03451 656565 where our team will be very keen to understand what has
gone wrong and, more importantly, put it right.
The Next Step...
straight forward, step-by-step guide to make sure that assembling your furniture is as easy as 1, 2, 3.
Before you begin, we advise that you check that you have everything you need to get started.
DEAR CUSTOMER
TOP TIP
Lay each panel down on a clean and level area, ideally in the room of intended use, ensuring there is
enough room to manoeuvre around the item. It is recommended that two people assemble this
product together.
TOP TIP
component, to make things easier when you are putting it all together.
on page 3 and 4 of this manual.
Safety and Care Advice
IMPORTANT -
Please take the time to read and understand these instructions before assembling your furniture.
Please keep these instructions for future reference.
Keep children and animals away from the assembly area.
This furniture contains small parts that could cause choking if swallowed.
Keep all plastic wrapping materials away from babies and children to avoid danger of suffocation.
Ensure that all packaging is disposed of carefully and responsibly.
Two people may be required for the assembly of this product.
Once items are part or fully assembled they are not returnable unless faulty.
This item is not for outdoor use – unless stated otherwise.
to the wall, to prevent a child from accidentally pulling furniture over.
Furniture can be dangerous if incorrectly installed. Assembly should be carried out by a competent
person. No liability will be accepted for damage or injury caused by incorrectly installed or
assembled furniture.
1

Parts & Fittings for the
Panel-
exploded view
Alexis Large Sideboard
(30477969)
2
1
2
4
5
3
6
6
7
8
9
9
10
10
11
11
12
12
13
14
15
16

Panels-plan view
1Top x1
420x1550mm
3
2Left side x1
419x518mm
Right side x1
419x518mm
5
3Left Middle divider x1
388x518mm
L/R Back x2
493x526mm
6
Base x1
420x1550mm
8
Metal Bar x2
25x1300mm
9Metal Leg x2
160x383mm
10
L/R Adjustable Shelf x2
369x483mm
12 Right Door x1
498x510mm
14
Left Door x1
498x510mm
16
4Right Middle divider x1
388x518mm
Middle Back x1
504x526mm
7
Adjustable Leg x2
38x160mm
11
Middle Adjustable shelf x1
369x502mm
13
Middle Door x1
498x510mm
15

Fittings
12mm
B
A
Ø8x30mm
C
H
F
D
K
Ø4mm
Ø6x50mm
Ø4x16mm
L
Ø3x14mm
O
4
Cam lock x8 Cam bolt x8 Wooden Dowel x8
Back wedge x9screw x4
screw x8
Allen Key x1 Anti-tip Kit x2
screw x6
35mm
Tools required
Cross slot screwdriver Hammer Tape measure
The use of power tools to assemble the product is not recommended due to the risk of
over tightening fixings.
Before you start
Check the pack and make sure you have all the parts listed above. If not ,contact the
helpline on 03451 656565 who will be able to help you.
When you are ready and sure that you have the right tools to hand,you will need plenty
of space and a clean dry area for assembly.
G
Ø5x16mm
Shelf support x12
I
8mm
screw x3
J
Ø6x12mm
screw x4
M
Ø4.5x15mm
screw x36 Magnetic catch x3
Hinge x6
E
Ø6x38mm
Handle screw x8
N
PQ
Ø25mm Cover x8

Ready?
Follow this step-by-step guide
5
B
Note:Insert cam bolt as
shown
1
Rear edge
1
2
B
B
B
B
B
B
B
B
1
Rear edge

Ensure the cam is pressed fully
into the hole and arrow pointing
towards the short edges
2
A
C
10mm
A A
Cam lock in open
position
Cam lock in closed
position
2
Rear edge
A
A
C
C
5
A
A
C
C
6
3
4
A
A
C
C
3
A
A
C
C
4
2
5
A
1
Rear edge
4
3

7
5
6
6
7
Front edge
6
K
Front edge
8
D
D
D
D
D
D
D
D

8
7
8
9
9
10
10
J
J
J
J
K10
9
9
10

Front edge
E
E
E
E
E
E
E
E
9
10
9
K
Ensure all screws are
well insert before fasten
Two people required to turn unit over
Front edge
11
11

10
11
12
Front edge
12
13
Ensure the finished surface is
facing the outside

11
13
14
M
M
MM
P
P
I
15
16
I
M
M
M
M
P
P
M
M
P
15
I
16
M
M
MM
P
P
I
14
15
16
Adjust the hinge to ensure the
grain of wave panel on the same level
Adjust Hinge Position

15
16
12
Rear edge
H
H
H
H
H
HH
H
H
Remove the plastic film on
all panels after assembly.
Front edge

Rear edge
Important note:
It is essential that this product is fixed
to a wall using the plastic zip ties supplied.
Wall fixing is not supplied.
13
Nearly there!
17
F
O

14
Wall Fixings

dunelm.com
Wall Fixings
Follow this step-by-step guide
IMPORTANT:
When drilling into walls always check there are no hidden wires or
pipes etc. Make sure that the screws and wall plugs being used are
suitable for supporting your unit. Consult a quali ed tradesperson
if you are unsure.
HINTS
1. General Rule; Always use a larger screw and wall plug if you are not sure.
2. Ensure you use the recommended drill bit to match the wall plug and hole size.
3. Ensure you drill the hole horizontally, do not force the drill or enlarge the hole.
4. Take extra care when drilling high walls, ceilings and ceramic tiles. Ensure the plug is tting below
the ceramic title to avoid splitting or cracking.
5. Ensure wall plugs are well tted and are a tight t in the drilled hole.
Types of Walls
You can use one of the
following types of wall plug if
your walls are made of brick,
breeze block, concrete, stone,
wood or plastic board.
1. STANDARD Wall Plug
General wall materials
2. GENERAL PURPOSE
Wall Plug
Aerated/Breeze block
3. SHIELD ANCHOR
Wall Plug
Heavy loads
6. HAMMER FIXING
Wall Plug
4. CAVITY FIXING
Wall Plug
5. CAVITY FIXING HEAVY
DUTY Wall Plug
These come in various sizes
and are made from plastic or
sometimes wood bre.
Generally aerated blocks
should not be used to support
heavy loads, use a specialist
tting in this case. For light
loads, a General Purpose Plug
can be used.
For use with heavier loads such
Satellite Dishes etc.
For use with walls stuck with
plaster board. The hammer
xing allows it to be xed to
the wall rather than the plaster
board. Always check the xing
is secure to the retaining wall.
For use with plaster board
partitions or hollow
wooden doors.
For use with plaster board
partitions or hollow
wooden doors.
CARE & MAINTENANCE
Safety
Always check the fitting and
location to ensure your safety
in and around the home.
Fitting
From time to time check the
fitting to ensure the wall plugs
or screws do not become loose.
.
15

Finally, we hope you enjoy your furniture for
many years to come and thanks again
for your purchase.
dunelm.com
Care and maintenance
Only clean using a damp cloth and mild detergent, do no use bleach or abrasive cleaners.
From time to time check that there are no loose screws on this unit.
This product should not be discarded with household waste. Take to your local authority waste
disposal centre.
.
16