DURAVIT LM 7865 User manual

Light and Mirror # LM 7865
Mounting instructions
Leben im Bad
Living bathrooms
Instructions for use
The bathroom furniture range complies with the standards and guidelines applicable at the time of delivery and is designed for use in bathrooms.
Though designed for the wet environment, direct contact with water should be avoided, for example, when showering.
Mirrors require a GFCI 110 V 60 Hz power source. Flat plug will be supplied with mirror. Distance between sensor and reflecting surfaces => 3” (75 mm).
We reserve the right to make technical improvments and design modifications to the products illustrated.
3x S8
2x 6,5x61
1x 4,5x35 F51944

Important Information
Installation
4
6
2Lights and Mirror_LM7865/16.12.1

Important information
3Lights and Mirror_LM7865/16.12.1
Intended use
The mounting instructions come included with the Duravit
product and are aimed at people who carry out out the
electrical installation for the product. You must read through
the mounting instructions carefully and they must be available
at all times.
Target readership and quialifications
The electrical installation may only be carried out by qualified
electricians.
Furniture complies with applicable requirements of the
referenced standard(s):
Safety Household and Commercial Furnishings.
( UL962, 3rd ed. portable Luminaires CSA C22.2 No. 12 )
Icons and symbols
Symbol Meaning
This symbol highlights useful and important
information.
>Action required
Instructions for use
• The bathroom furniture range complies with the standards
and guidelines applicable at the time of delivery and is
designed for use in bathrooms.
• Direct contact with water should be avoided, for example,
when showering.
• Mirrors / Mirror cabinets require a GFCI 110V 60Hz power
source.
• Flat plug will be supplied with mirror / mirror cabinet.
Safety instructions
Danger to life
Contact with electricity may lead to an electric shock.
> Carry out the electrical installation in accordance with
the national and international directives and standards.
> Connect the electrics using a ground fault circuit
interrupter (GFCI) in wet rooms or other specially equipped
rooms.
> Disconnect electrical components from the power supply
before the installation.
> Prevent the power supply from being switched on
accidentally.
Penetration of foreign bodies and water
Foreign bodies or water in equipment lead to a short circuit
that may cause damage to the product.
Measuring mode
The control unit has a measuring mode. Once the measuring
mode is active, the light is switched on again automatically
90 seconds after it has been switched off.
The measuring mode may be triggered during an
installation under voltage by accidentally actuating
the touch LED/infrared switch continuously
> Actuate the touch LED/infraced switch for longer than
65 seconds to activate the measuring mode. Use a
relective object (paper) for the infrared switch.
The light flashes 6 times.
> Actuate the touch LED/infraced switch again for more
than 65 seconds to deactivate the measuring mode.
Use a reflective object (paper) for the infraced switch.
The light flashes 4 times.

4Lights and Mirror_LM7865/16.12.1
Installation
A 110V GFCI outlet is required.
Mark the holes to be drilled for
anchors.
Using 3/8“ drill bit, drill the
anchor holes that have been
marked.
The plastic anchors provided are
for concrete wall applications.
Thred the two mounting screws
into top two anchors.
Secure the L-bracket to wall with
the screw on the bottom.
Confirm that all screws are
securely attached.
Check leveling of the top two
screws.
Adjust leveling if required.
123 4
5
Plug the mirror into the outlet
and line up the top screws with
the inserts on the back of the
mirror. Push mirror onto wall
until screws are inserted
securely.
6 7 8

5Lights and Mirror_LM7865/16.12.1
Tighten the set screw to secure
mirror in place.
9

6Lights and Mirror_LM7865/16.12.1
Furniture complies with applicable requirements of the referenced standard(s):
Safety Household and Commercial Furnishings (UL 962, 3rd ed. Issued: 07/07/08, Revised: 08/05/13)
Portable Luminaires CSA C22.2 No. 12 - 1982 (R2004)
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical furnishing, basic precautions should always be followed, including the following:
Read all instructions before using this furnishing.
DANGER To reduce the risk of electric shock:
1. Always power down all circuits and disconnect before cleaning.
2. To reduce the risk of electric shock, this furnishing has a polarized plug
(one blade is wider than the other). This plug will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reserve the plug.
If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not change the plug in any way.
CAUTION:
To prevent electric shock, match wide blade of plug to wide slot, fully insert.
WARNING To reduce the risk of burns, fire, electric shock, or injury to persons:
1.Disconnect from power before putting on or taking off parts. A minimum of two people is required
to remove and replace cabinet doors.
2. Close supervision is necessary when this furnishing is used by, or near children, invalids, or
disabled persons.
3. Use this furnishing only for its intended use as described in these instructions. Do not use
attachments not recommended by the manufacture.
4. Never operate this furnishing if it has a damaged cord or plug, if it is not working properly,
if it has been dropped or damaged, or dropped into water.
Return the furnishing to a service center for examination and repair.
5. Never drop or insert any object into any opening.
6. Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
8. For loading always put heavier items at the bottom and not near the top in order to help
prevent the possibility of the furnishing tipping over.
MAXIMUM SHELF LOAD IN POUNDS ALLOWED: 6.61 lbs
9. To disconnect, power down all circuits.
10. Risk of Injury to Persons - do not place video equipment such as televisions or computer
monitors on furnishing.
11. For grounded products the following statement:
WARNING: Risk of Electric Shock - Connect this furnishing to a properly grounded outlet only.
GROUNDING INSTRUCTIONS
This product must be connected to a grounded metal, permanent wiring system, or an
equipment - grounding conductor must be run with the circuit conductors and connected
to the equipment grounding terminal or lead on the product. ( If provided with a 3 wire system )
ABOUT THE PRODUCT
Products requiring electricity are designed to be switched at the wall and hardwired to a
circuit provided by the customer. Product should be installed according to electrical code by
a qualified technician. Read important safety instructions carefully. Direct wetting should be avoided.
This products is intended for household/residential use only. We reserve the right to make technical
improvements and to enhance the appearance of the products shown.
SAVE THESE INSTRUCTIONS

Duravit NYC
105 Madison Avenue
New York, NY 10016
Toll Free 888-DURAVIT
Phone [phone]
Fax [phone]
[email protected]vit.com
www.duravit.nyc
Duravit USA, Inc.
2635 North Berkeley Lake Rd., Ste. 100
Duluth, GA 30096
Toll Free 888-DURAVIT
Phone [phone]
Fax [phone]
[email protected]vit.com
www.duravit.us
Best.-Nr. LM7865/16.12.1