DURAVIT P3 Comforts 720151 User manual

P3 Comforts
Mounting instructions Shower tray made of DuraSolid A
Leben im Bad
Living bathrooms

P3 Comforts
# 720151
# 720152
# 720153
# 720154
# 720155
# 720156
# 720157
# 720158
# 720159
# 720160
# 720161
# 720162
# 720172
# 720173
# 720174
# 720175
# 720176
# 720177
# 720178
# 720179
# 720180
# 720181
# 720182
# 720183
2DU_M_P3 Comforts_16.04.01

Important Information
Installation
Cleaning and Care
4
6
10
3DU_M_P3 Comforts_16.04.01

Important information
Regarding the mounting instructions
The mounting instructions come included with the Duravit
shower tray and should be read carefully prior to installation.
Explanation of key words and symbols
Note! In the case of potential damage to property
Products are in compliance with following codes:
Uniform Plumbing Code
National Plumbing Code of America
International Plumbing Code
Products are in compliance with the following standards
CSA B45.5-11/IAPMO Z124-2011
Link to Installation information in this section
Target group and qualification
The shower tray must only be installed by licensed plumber.
Note!
Local installation regulations and county-specific
standards must be observed at all times.
Inspection (e.g. for scratches)
Indication of the length of time (e.g. 10 minutes)
Inspect to check for leaks and tightness
4DU_M_P3 Comforts_16.04.01

5DU_M_P3 Comforts_16.04.01
# 790262
# 720151 - # 720162
Waterproof membrane
(RedGard, Laticrete, others) Not supplied by Duravit.
Should be purchased separately.

6DU_M_P3 Comforts_16.04.01
Installation
Mark the drain opening. Cut drain flange about 1 7/8“ to fit against
the wall. Drill 8 pilot holes using 1/4“ drill bit,
about 5/8“ inside from the edge.
Cut opening for the drain flange. Place and secure drain flange to subfloor with
screws. (Screws are not supplied)
13
4 5
Put the plug in the drain. Apply first coat of
paintable waterproof membrane. Apply
membrane up the wall and in the corners, and
make sure to thoroughly coat the entire drain
flange. The membrane requires to be applied up
the wall a minimum 6“.
6
Inspect the shower tray for any damage that
may have occured during transport.
2

7DU_M_P3 Comforts_16.04.01
After first coat is dry, apply second coat. After appropriate setting time for membrane,
water test.
After water test, pull plug from the drain.
Confirm that the area under the shower tray is
clear and dry.
Install the wall tile.
79
10 11
Measure distance X between top of the shower
tray opening and the drain flange.
12
Make sure all corners and seams are thoroughly
coated.
8

8DU_M_P3 Comforts_16.04.01
Cut the drain throat from shower tray,
measurement X (step 12) plus 2 1/2“.
13
Apply mortar on the floor.
Place the shower tray in place. Check the leveling and install the drain. Install the cover.
File down the cut edge of the drain throat.
14
16 17
15
18

9DU_M_P3 Comforts_16.04.01
Use minimum 110 lbs to set the shower tray in
place.
19
Leave this set for minimum of 24 hours.
Apply silicon.
20 21

Cleaning and Care
Damage to the product as a
result of using the wrong cleaning
agent or cosmetics.
>Do not use concentrated acids or alkalis
(e.g. caustic soda/caustic potash/drain cleaner).
>Avoid contact with acetone; rinse the tub with clean
water immediately in case of contact.
>Avoid contact with nail polishes, lipsticks and all
hairdyes. Stains of this type can only be removed
by sanding.
>Do not use abrasive or hard sponges.
Failure to observe these instructions may damage
the surface. Complaints due to improper cleaning
and care will not be covered by the warranty.
Cleaning the shower tray
>Clean the surface with a soft damp cloth.
>Remove light soiling with warm water and some
standard detergent or vinegar-/lemon-based
cleaning agent.
>Remove heavy soiling with a magic cleaning eraser,
warm water and some standard detergent or
vinegar-/lemon-based cleaning agent.
Soiling is still visible after cleaning?
>Remove the soiling with a soft cloth and some
scouring agent.
A silky gloss effect has emerged on the surface?
>Rub the treated area with a Scotch Brite sponge or
1000 grade super fine sandpaper to restore the
matt appearance of the surface.
Rinsing and drying the shower tray
>Rinse the shower tray well with clean water after the
treatment.
>Dry the shower tray with a soft cloth.
10 DU_M_P3 Comforts_16.04.01
NOTICE

Duravit NYC
105 Madison Avenue
New York, NY 10016
Toll Free 888-DURAVIT
Phone [phone]
Fax [phone]
[email protected]vit.com
www.duravit.nyc
Duravit USA, Inc.
2205 Northmont Pkwy., Ste. 200
Duluth, GA 30096
Toll Free 888-DURAVIT
Phone [phone]
Fax [phone]
[email protected]vit.com
www.duravit.us
DU_M_P3 Comforts_ 16.04.1 We reserve the right to make technical improvements and enhance the appearance of the products shown.