Dustbane Victory User manual

Dustbane Products Ltd., 25 Pickering Pl., Ottawa, ON K1G 5P4 •Tel: [phone] Fax: [phone] www.dustbane.ca
Victory Handheld Sprayer
Quick Guide
This guide is intended for quick consultation only and does not replace the user and maintenance manual.
Before using this machine, read the user maintenance manual contained in the machine’s packaging and
follow all the instructions.
CONTENTS: After unpacking, inspect the components for any damage or missing hardware pieces,
etc. The following components are included with your purchase:
CHARGING THE BATTERY
Snap it into the included
charger.
The lights on the left side
indicate the level of charge of the
battery.
The lights on the right side
indicate the amount of time
remaining for the battery to be
fully charged.
321 4
When the battery is nished
charging, snap it into place on
the sprayer.
FILLING THE TANK
To remove the solution tank
from your Victory Sprayer,
simply rotate the collar lock to
the “unlock” icon and pull the
ring back to release the locking
mechanism.
You can now pull the tank o the
unit.
Fill the tank with the desired
diluted solution. Apply label.
321 4
Re-attach the tank by aligning
the vertical rails of the sprayer
with the groove along the top of
the tank. Rotate the collar lock to
the “lock” icon.
Sprayer Unit
3 Setting Nozzle
Nozzle Wrench
Carrying Bag
Instruction Sheet
Battery & Charger
Cap for Tank
Tank Hose and Gasket Assembly

Dustbane Products Ltd., 25 Pickering Pl., Ottawa, ON K1G 5P4 •Tel: [phone] Fax: [phone] www.dustbane.ca
Click
FILLING THE TANK (CONT.)
Firmly press the tank into the
sprayer until you hear a“click”.
Rotate the collar lock to the “lock”
icon.
Push the electrostatic charge
switch to the “On”position.
Start spray application on the highest point of the surface on the
object being disinfected and quickly move to the lower areas.
Where possible, sprayer should be kept as level as possible and be
approximately 2 feet (24”) from the surface being treated.
CLEANING PROCEDURES
OPERATING SPRAYER
Leave the product on the surfaces
for the dwell time indicated on
the label. Wipe if indicated.
Rotating the nozzle clockwise, select the appropriate nozzle tip
according to the dwell time of the product used. If the dwell time
is less than 5 minutes, position nozzle to Setting 1 (red). If between
8-10 minutes, position nozzle to Setting 2 (green), and for 10
minutes, position the nozzle to Setting 3 (white).
SETTING UP NOZZLE
To clean or unclog the nozzle,
remove the nozzle using the
nozzle wrench provided and
rotating it in counter-clockwise
direction.
Soak nozzle in hot soapy water
for 10 minutes.
To reduce the chance of blockage we recommend that after every
few days of use spray a tank of water through the unit to rinse out
any residual chemical build up that may have occurred.
21 3
321
563-5 MINUTES
8-10 MINUTES
10+ MINUTES
ON
OFF 2 feet (24”)
10 MINUTES