Dyna-Glo RMC-LPC25DG Owner's manual

www.ghpgroupinc.com.
RMC-LPC25DG/DGD/DGP/DGP-01 & LPC25 (PROPANE, 25,000 BTU/hr)
RMC-LPC80DG/DGD/DGP/DGP-01 (PROPANE, 80,000 BTU/hr)
RMC-LPC80C/L/L-01 (PROPANE, 80,000 BTU/hr)
RMC-LPC200L/DG/DGP/DGP-01 (PROPANE, 200,000 BTU/hr)
CALIFORNIA PROPOSITION 65:
Fuels used in gas or oil fired appliances and the products of combustion of such fuels, contain chemicals known to
the State of California to cause cancer, birth defects or other reproductive harm. This product contains chemicals,
including lead and lead compounds, known to the State of California to cause cancer, birth defects or other
reproductive harm. Wash hands after handling.
4:30service department at 877-447-4768 pm CST, Monday – Friday
Questions, problems, missing parts? Before returning to your retailer, call our customer
8:30 a.m. –
or email us at [email protected]
www.ghpgroupinc.com
C US
GHP Group, Inc.
6440 W Howard St
Niles, IL 60714-3302
ANS Z83.7-2011 CSA 2.14-2011
Adequate ventilation must be provided.
Propane Construction Heater
IMLPCDG - HCQ

For Technical Support or Troubleshooting, Call: 1-877-447-4768 www.ghpgroupinc.com 2
Illustration RMC-LPC80 Series...................................................................
Illustration RMC-LPC25 Series....................................................................
Illustration RMC-LPC200 Series.................................................................
RMC-LPC25Series / RMC-LPC80 Series..................................
RMC-LPC200 Series...............
WARNING: CONSTRUCTION HEATERS ARE NOT FOR USE IN
GARAGES IN CANADA.
WARNING
: Using this heater in a residential garage requires that the heater is
positioned so that it is protected against any possible damage by a moving vehicle,
etc. It must be positioned so that the base of the heater is no less than 18 in (450 mm) above
surface. Do not place it on a chair, ladder, etc. Raising the heater will reduce BUT NOT
stored or accidentally spilled. If the smell of gasoline is present, DO NOT operate this heater
until the area has been properly ventilated.
WARNING: Fire, burn, inhalation and explosion hazard. Keep solid combustibles, such
as building materials, paper or cardboard, a safe distance away from the heater as
recommended by the instructions. Never use the heater in spaces which do or may
contain volatile or airborne combustibles or products such as gasoline, solvents, paint thinner,
dust particles or unknown chemicals.
WARNING: Not for home or recreational vehicle use.
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!

For Technical Support or Troubleshooting, Call: 1-877-447-4768 www.ghpgroupinc.com 3
The heater is designed for use as a construction heater in
accordance with ANSI Z83.7, CSA 2.14. Other standards
govern the use of fuel gases and heating products for
specific uses. Your local authority can advised you about
these. The primary purpose of construction heaters is to
provide temporary heating of building under construction,
alteration or repair. Properly used, the heater provides
safe economical heating. Products of combustion are
vented into the area being heated.
CLEARANCE TO COMBUSTIBLES:
LPC25 Series
LPC80 Series
LPC200 Series
The heater must be located at least 6 ft. (1.83 m) in the
U.S.; or (ii) 10 ft. (3 m) in Canada, from any propane gas
container.
Minimum MinimumMaximum Maximum
(lb/h)
0.7
(0.32 kg/h)
1.16
(0.53 kg/h)
2.32
(1.05 kg/h)
3.71
(1.68 kg/h)
2.32
(1.05 kg/h)
9.28
(4.21 kg/h)
11.7 x 12.87
(29.69 x 32.79 cm)
15.9 x 18.3
(40.41 x 46.99 cm)
15.9 x 26.2
(40.41 x 66.49 cm)
.196
(4.98 mm)
.196
(4.98 mm)
.196
(4.98 mm)
2 ft. (60 cm) 2 ft. (60 cm) 3 ft. (91 cm)
4 ft. (1.22 m) 5 ft. (1.52 m) 6 ft. (1.82 m)
(37.8 °C).
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!

For Technical Support or Troubleshooting, Call: 1-877-447-4768 www.ghpgroupinc.com 4
WARNING: Provide at least a 2½ square feet (.23
square meters) opening of fresh, outside air while
running heater. If proper fresh, outside air ventilation is
not provided, carbon monoxide poisoning can occur.
Provide proper fresh, outside air ventilation before
running heater.
WARNING: Provide at least a 6 square feet (.56
square meters) opening of fresh, outside air while
running heater. If proper fresh, outside air ventilation is
not provided, carbon monoxide poisoning can occur.
Provide proper fresh, outside air ventilation before
running heater.
(100 lb.)
Use this heater only with a propane vapor withdrawal
supply system. Installation must conform to local
codes or, in the absence of local codes, with the
standard for the Storage and Handling of Liquefied
Petroleum Gases ANSI/NFPA 58 and the Natural Gas
and Propane Installation Code CSA B149.1. Your local
library or fire department will have this booklet.
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
60 °F (15.56 °C)
40 °F (4.44 °C)
32 °F (0 °C)
20 °F (-6.67 °C)
10 °F (-12.22 °C)
0 °F (-17.78 °C)
2.5 ft2(.23 m2)
6 ft2(.56 m2)

For Technical Support or Troubleshooting, Call: 1-877-447-4768 www.ghpgroupinc.com 5
Contents
All Models: Unit, Manual, Hose and Regulator
Assembly
LPC80 and 200 Series Include:
Upper Shell, Lower Shell and Hardware Kit With
Screws (8)
All Models: Adjustable Wrench
LPC80 and LPC200 Series: Phillips head screwdriver
Tools Required for Assembly
Assembly Time: 10 minutes
Slide upper shell assembly up and off lower shell.
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!

For Technical Support or Troubleshooting, Call: 1-877-447-4768 www.ghpgroupinc.com 6
10
11. Check all connections for leaks. Apply mixture of liqud
soap and water to gas joints. Bubbles forming show a
leak that must be corrected before using the heater.
Turn propane supply valve on by turning tank valve
counterclockwise .
If flame burner goes out, wait 5 minutes then repeat
steps 4 and 5.
Turn propane supply valve off by turning fully
clockwise .
6.
()
()
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!

For Technical Support or Troubleshooting, Call: 1-877-447-4768 www.ghpgroupinc.com 7
RMC-LPC25/80/200 Propane Convection Heater
Fully open the valve on the propane cylinder counter
clockwise and wait 15 seconds before
proceeding to step 2.
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
gap is .196” (4.98 mm). Check
wire lead for damage.

For Technical Support or Troubleshooting, Call: 1-877-447-4768 www.ghpgroupinc.com 8
Store propane tank(s) in safe manner. Refer to Chapter
5 of Standard for Storage and handling of Liquefied
Petroleum Gases, ANSI/NFPA 58, and the Natural Gas
and Propane Installation Code CSA B149.1. Follow all
local codes. Always store propane tanks outdoors.
Warning: Use only original replacement parts. This Heater
must use design-specific parts. Do not substitute or use
generic parts. Improper replacement parts could cause
serious or fatal injuries.
This will also protect your warranty coverage for parts
replaced under warranty.
Parts warranty and non-warranty: Contact authorized dealers of
this product. If they can not supply original replacement part(s),
either contact your nearest Parts Central or GHP Group Inc.,
Technical Service Department at 1-877-447-4768.
When calling GHP Group Inc., have ready:
• your name
• your address
• how heater was malfunctioning
• serial number of heater
• model number of heater
• replacement part number
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!

For Technical Support or Troubleshooting, Call: 1-877-447-4768 www.ghpgroupinc.com 9
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
Replacement Parts for RMC-LPC25 Series
J
GS22-LPC25
KR10601-10-31
KR10601-15-31
Regulator & Hose Assy 10’ (3.05 m)
Regulator & Hose Assy 15’ (4.57 m)