DYNABREEZE FA-23082 Guide

USER MANUAL & WARRANTY 1
MODEL FA-23082
HEAVY DUTY 450mm
OSCILLATING
FLOOR FAN
T
WARNING:
Read and
understand
this manual
before use!

2DYNABREEZE INDUSTRIAL STRENGTH FAN
Congratulations on your purchase
of a DYNABREEZE fan.
Thank you for purchasing the Dynabreeze
Heavy Duty 450mm Industrial Strength Oscillating Floor Fan.
CAUTION: Please read through the instructions carefully before using the
product and ensure that the manual is kept in a safe place for future reference.
Before this product is used, it must be properly located and operated in
accordance with the product use and safety instructions.
WARNING: As with all machinery, there are certain hazards involved with
operation and use of this appliance. Following the safety precautions in this
User Manual and exercising respect and caution when using this appliance
will considerably lessen the risk of personal injury. However if these safety
precautions are overlooked or ignored, personal injury or damage to property
may result.

USER MANUAL & WARRANTY 3
• To avoid a hazard due to instability of the
appliance, it must be placed on an even
flat surface.
• Do not operate this appliance with
a damaged cord or plug or after the
appliance malfunctions, or has been
damaged in any manner.
• If the supply cord is damaged, it must be
replaced by the manufacturer or a qualified
electrician in order to avoid a hazard.
• Before each use, check for any damaged
parts, and replace or repair accordingly
before any further operation.
• Connect to properly grounded power
outlet only. No other appliance should be
plugged into the same outlet. Be sure that
the plug is fully inserted into the mains
power outlet.
• Do not run the power cord over carpeting
or other heat insulators. Do not cover the
cord. Keep cord away from trac areas,
and do not submerge in water.
• Switch o and unplug the appliance
before cleaning or making any repairs or
servicing.
• Keep safety guards/grills in place and don’t
operate the machine with them removed.
• Keep your hand clear of the rotating
blades at all times, never put your hands
or any other object inside the guard/grill
when the machine is switched on.
• Do not wear jewellery or loose clothing
that could be caught by the rotating
blades.
• Never leave the appliance running
unattended, turn the power o and don’t
leave the appliance until it comes to a
complete stop.
• Exercise caution and use reasonable
supervision when appliance is used near
children to ensure that they do not play
with the appliance.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for their
safety.
• Do not operate this appliance whilst under
the influence of drugs, alcohol or any
medication.
• Keep the fan upright when in operation.
• Do not stand on the appliance.
• Do not bend the blades for any reason.
• Keep the area around the fan clear and a
suitable distance from objects that may be
suctioned into the fan.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should be followed to reduce the
risk of fire, electric shock, and injury to persons or property. Please ensure that you read this
User Manual in its entirety before using this appliance.

4DYNABREEZE INDUSTRIAL STRENGTH FAN
A. Power Cord
B. Steel Fan Stand
C. Safety Grille
D. Fan Blades
E. Rubber Feet
F. On/O/Speed Control Dial
G. Electric Motor
PARTS IDENTIFICATION
A.
B.
C. D.
E.
F.
G.

USER MANUAL & WARRANTY 5
ELECTRICAL REQUIREMENTS &
SPECIFICATIONS
ELECTRICAL REQUIREMENTS
Australia
Voltage:
220V -
240V
Frequency:
50/60Hz
Power:
120W
WARNING: This appliance must be earthed.
IMPORTANT: The wires in this fans mains
lead are coloured in accordance with the
following code:
Green and Yellow: Earth
Blue: Neutral
Brown: Live
EXTENSION CABLES
If an extension cable is to be used, it is
recommended that a splash proof cable
connector be fitted and that this connector
be kept clear of any water.
Since the cable will produce a voltage
drop, it is essential that the wiring in the
cable conforms the following minimum
specifications:
0-25metre cable length = 1.5mm wire
25-50metre cable length = 2.5mm wire
SPECIFICATIONS
Diameter:
450mm
Speed:
1350 rpm
Air Delivery:
120 M3/min
USING YOUR DYNABREEZE FAN
UNPACKING AND FIRST USE
1. Unpack the unit from box that your
unit was purchased in and recycle the
packaging if possible.
2. Check that all the parts are included on
the unit and nothing is broken. If you
require assistance, please contact the
place of purchase.
3. Read and follow this manual and adhere
to all safety precautions.
4. Plug the power cable into a suitable
power outlet and switch on the power
outlet.
5. Turn On the fan by turning the speed
control dial from 0 (zero) to 1,2 or 3,
depending on the fan speed required.
6. Turn O the fan by turning the control dial
back to the 0 (zero) position, then turn o
at the mains power switch.
MAINTENANCE AND CARE
Before each use, check the unit for damage
to ensure the body and cable are completely
sound.
Periodically inject a few drops of grease into
the moving parts and ensure the bearings are
oiled.
Store this unit in a clean dry environment.

6DYNABREEZE INDUSTRIAL STRENGTH FAN
Tradeware Australia (ABN 41 127 959 791)
(Tradeware) oers the purchaser of this fan
(Purchaser) a warranty in respect of the Fan,
on the terms and conditions, and for the
duration, outlined below (Warranty).
In this Warranty, the term Fan means the
Dynabreeze Fan and any component of the
Fan manufactured or supplied by Tradeware.
Oer and duration of warranty
1. Tradeware warrants that the Fan will
be free, under normal application, use
and service conditions, from defects in
materials and workmanship aecting
normal use, for 3 years from the date of
purchase (Warranty Period).
2. Where the Fan malfunctions or becomes
inoperative during the Warranty
Period, due to a defect in materials
or workmanship, as determined by
Tradeware, then subject to further rights
conferred by the ACL on the Purchaser,
Tradeware will, in exercise of its sole
discretion, either:
2.1 repair the defective Fan; or
2.2 replace the defective Fan;
without charge to the Purchaser.
3. This Warranty does not extend to any
costs incurred by the Purchaser in
making a Warranty claim.
Exclusions and limitations
4. This Warranty will not apply to, or include
any defect, damage, fault, failure or
malfunction of the Fan, which Tradeware
reasonably determines to be due to:
4.1 normal wear and tear or exposure to
weather conditions over time;
4.2 accident, misuse, abuse, negligence,
vandalism, tampering, alteration or
modification;
4.3 non-observance of any of the
instructions supplied by Tradeware in the
user manual for the Fan, including those
concerning safety, use and maintenance;
4.4 repairs or maintenance of the Fan by a
person who is not a qualified electrician,
or if non-genuine or non-approved parts
have been fitted;
4.5 faulty power supply, power failure,
electrical spikes or surges, lightning,
flood, storm, hail, extreme heat, fire or
other occurrence outside the control of
Tradeware; or
4.6 use other than for any reasonable
purpose for which the Fan was
manufactured.
THREE YEAR WARRANTY
Our goods come with guarantees that cannot be excluded under the Australian Consumer
Law (ACL). You are entitled to a replacement or refund for a major failure and compensation
for any other reasonably foreseeable loss or damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable quality and the failure does not
amount to a major failure.
The benefits of this Warranty are in addition to other rights and remedies available at law in
respect of the Fan and shall not derogate from any applicable mandatory statutory provisions
or rights under the ACL.

USER MANUAL & WARRANTY 7
How to make a Warranty claim
5. To make a Warranty claim, the Purchaser
must return the Fan, in the first instance,
to its place of purchase within the
Warranty Period, together with proof of
purchase documentation which clearly
shows the date and place of purchase.
If the Purchaser wishes to dispute the
supplier’s decision, Warranty claims
can be made in writing to Tradeware at
the postal or email address specified in
clause 13 within the Warranty Period.
Such claims must include:
5.1 details of the alleged defect or fault;
5.2 evidence of the claim;
5.3 proof of purchase documentation
which clearly shows the date and place
of purchase.
The return of a Fan to Tradeware without the
prior written instructions of Tradeware will
not be accepted.
6. Without limiting any other clause in
this Warranty, Tradeware has the right
to reject any Warranty claim made by
a Purchaser pursuant to this Warranty
where:
6.1 the serial number of the Fan has been
altered, removed or made illegible;
6.2 the Purchaser is unable to provide
proof of purchase documentation in
accordance with clause 5 or evidence
that the terms of this Warranty have
otherwise been satisfied.
7. If the Fan is found to be working
satisfactorily on return to Tradeware or
upon investigation by Tradeware, the Fan
will be returned to the Purchaser.
8. Any replaced Fan or components of
a Fan shall become the property of
Tradeware.
9. Tradeware may deliver another type of
Fan or component of a Fan in fulfilling
its obligations under this Warranty,
in the event that it has discontinued
manufacturing or supplying the Fan or
relevant component at the time of the
Warranty claim, or where such fan or
component is superior to that originally
purchased.
Other conditions of Warranty
10. If the Purchaser acquired the Fan for the
purpose of resupply, then this Warranty
shall not apply to that Fan.
11. While Tradeware warrants that the Fan
will be free from defects in materials and
workmanship in the circumstances set
out in this Warranty, to the maximum
extent permitted by law Tradeware does
not warrant that the operation of the Fan
will be uninterrupted or error-free.
12. If any clause or part of a clause in this
Warranty is illegal, unenforceable or
invalid, it is to be read down where
possible, and otherwise treated as
removed from this Warranty, without
aecting the rest of this Warranty.
13. Tradeware’s contact details for the
sending of claims under this Warranty
are:
Tradeware
P: 1300 658 494
E: [e-mail]
45 Birralee Road, Regency Park
South Australia, Australia 5010
www.tradewaregroup.com.au

Tradeware
P: 1300 658 494
E: [e-mail]
45 Birralee Road, Regency Park
South Australia, Australia 5010
www.tradewaregroup.com.au