Dynalink RTA1025W User manual

Netbay Internet – RTA1025W ADSL/ADSL2+ setup guide
Last updated: Page 1 of 5 28 Aug 2009
Ben L & Kein C
Dynalink RTA 1025W ADSL1/ADSL2+ setup guide
1. Start your browser (Internet Explorer, Mozilla Firefox, Google Chrome etc).
2. In the address bar, type in 192.168.1.1 and press “Enter”
3. WebAdmin login screen:
You will be prompted to enter username and password.
The default username is admin and the password is admin.
After you login successfully, the main screen will appear.

Netbay Internet – RTA1025W ADSL/ADSL2+ setup guide
Last updated: Page 2 of 5 28 Aug 2009
Ben L & Kein C
4. RTA1025W main screen:
Click on Quick Setup
5. Quick Setup screen:
Uncheck Auto Scan Internet Connection (PVC)
Ensure VPI is 8, VCI is 35
Click on Next

Netbay Internet – RTA1025W ADSL/ADSL2+ setup guide
Last updated: Page 3 of 5 28 Aug 2009
Ben L & Kein C
6. Configure Internet Connection – Connection Type screen:
Protocol: Select PPP Over Ethernet (PPPoE)
Encapsulation Type: Select LLC/SNAP
Click on Next
7. Configure Internet Connection – WAN IP Settings screen:
Select Obtain an IP address automatically
Check Enable NAT
Click Next

Netbay Internet – RTA1025W ADSL/ADSL2+ setup guide
Last updated: Page 4 of 5 28 Aug 2009
Ben L & Kein C
8. Configure Internet Connection PPP User Name and Password screen:
PPP User Name: if your username is johndoe
oADSL1 username: [email protected]
oADSL2+ username: [email protected]
PPP Password: Enter your password.
Session established by: Select Always On
Click on Next

Netbay Internet – RTA1025W ADSL/ADSL2+ setup guide
Last updated: Page 5 of 5 28 Aug 2009
Ben L & Kein C
9. Configure LAN side Settings screen:
Ensure the settings on your screen match the screen below.
Click on Next
10. Confirmation screen:
Click on Finish
11. The modem will save the new settings and reboot itself. Wait for a few minutes
and you will be on the internet.