Eago Dz962f8 User manual

1. Brass Elbow

5. White LED Light

2. ½”NPT Brass nut

6. Rain Shower head

4. Speaker

12. Steamer Cleaning Port

16. Flex Drain Assembly

24. Exhaust Fan

13. Massage Jet 14. Foldable Seat

22. Door Handles

25. Color LED Light

28. Hand Shower Pole 29. Faucet Valves

26. Metal Bracket

34. Door Rollers

Wall brackets: 4pcs

Panel screw hole cover: 12 Pcs

Brackets: 11pcs

3mm Hex Allen Wrench:1Pc

4x10mm Screws:33pcs

4x16mm Screws:7pcs

3.5x30 Screws:8pcs

4x25mm Screws:12pcs

Electrical junction box

Spirit Level

Install the Shower base

1. Carefully put the shower base on the floor in the final

position where shower will be when complete.

2. Put the Spirit Level on the shower base and check the

base for level in both directions as illustrated. If not use

a wrench to adjust the leveling feet to make sure the

shower base becomes level. (As illustrated in Drawing A)

3.5x30mm Self tapping Screws

Corner Aluminum Profile

4. Attach white metal brackets on the back side at top, middle and bottom of

panels with fold down seats to allow panels to be removed from inside

shower once shower is in place.

4mm Plastic washer

Speaker Wire Shower head hose

Fan Wire

Color LED Light

White LED Light

Hex Allen Wrench

6mm plastic washer

4mm Plastic washer

Shelf Bracket

Hand Shower

Pole

Hand shower Hose

Wall fitting for shower

hose

Metal bracket

Connect Wires

1. Put the top cover onto the steam shower carefully (illustrated in Drawing A)

2. Use a phillips screwdriver to fix the top cover to the shower assembly with 4x10mm screws and stainless steel brackets. Illustrated in Drawing B.

3. Locate the corresponding signs on each wire for the Fan, Lights, and Speaker and match them to the corresponding wires for the parts on the roof

and connect wires securely. Illustrated Below.

Install Accessories

1. Install the Glass Shelf as illustrated in Drawing A. first install the brackets to the wall Using 4x16mm screws, 4mm washers, 6mm Plastic Washers and

4mm nuts. Then attach the arms to the brackets and the glass shelf to the arms as Illustrated in Drawing B.

2. Install the hand shower pole as Illustrated in Drawing C. First install the brackets to the wall same as the glass shelf. and the pole attaches to the

brackets using setscrews to fasten securely.

3. Connect the hand shower hose to the wall connector and to the hand shower. Illustrated in Drawing D.

Bracket for fastening roof Panel

Roof Panel

Allen Wrench

Door Handle

Rubber Door Seal

Install Moveable doors

1. Hang the doors on the upper track (Illustrated in Drawing A) Then press the lower spring loaded wheels down to hook into the lower aluminum track.

(Illustrated in Drawing B) Note: there is an adjustment screw on the upper wheel assembly to adjust if there is a gap between the moveable doors or if the doors

are overly stiff in movement then adjust the upper wheels to correct fit of doors.

2. Install the door handles by putting the large phillips screw thru the hole in door and screw into one side of the handle. Attach the handle on the other side