East West Furniture VANCOUVER DINING CHAIR VAC-C User manual

VANCOUVER DINING CHAIR WITH MICROFIBER UPHOLSTERED SEAT
- 1 -
ASSEMBLY INSTRUCTIONS
SKU: VAC-C
Description
Di
mension
: VANCOUVER DINING CHAIR WITH MICROFIBER UPHOLSTERED SEAT
: W. 17" 3 x D.19.9" x H. 37"
Cube Size : 39”x18.6”x12.4” NW: 28.6 LBS
GW: 37.4 LBS
175 Southbelt Industrial Dr
Houston, TX 77047
Email: inf[email protected]

VANCOUVER DINING CHAIR WITH MICROFIBER UPHOLSTERED SEAT
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and long lasting use. Please
take the time to read and follow the assembly instructions carefully.
Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment.
Please separate, identify, and count all parts and metal hardware. Compare with part list to be sure all parts are present.
If hardware is missing or you have difficulty assembling this product, please call for us.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being
scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you
have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Chair back 1 B Seat Frame
1
C-R
Front Leg
1
D U Stretcher 1
C-L 1
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED
Hardware bag
location

VANCOUVER DINING CHAIR WITH MICROFIBER UPHOLSTERED SEAT
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you
have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1
Bolt
(M6x60mm)
4
2
Bolt
(M6x50mm)
6
3
Lock Washer
(Ф6.5x9)
10
4
Flat Washer
(Ф6.5x19)
10
5
Allen Key
(4mm)
1 6
Screw
(M4x40mm)
2
STEP 1
Attach front legs (C-L) and (C-R) to the seat frame by bolts (1), washers (3) and (4) and slightly tighten
with Allen Key (5).
Then attach the U stretchers (D) to two front legs by the screw (6) using Philip driver as shown below:
C-L
C-R
D
B

VANCOUVER DINING CHAIR WITH MICROFIBER UPHOLSTERED SEAT
- 4 -
STEP 2
Attach the seat frame and U stretchers (D) from step 1 to the chair back (A) by using bolts (2) and
washers (3) and (4) then slightly tighten it with Allen Key (5) as shown below:
Note: DO NOT fully tighten any of the bolts, until the chair is assembled.
Put the chair on a flat level surface to make sure the chair is level and then tighten the all bolts.
STEP 3
5
23
4
X2