East West Furniture HI-ET User manual

HILLSBORO ROUND NIGHT STAND END TABLE WITH DRAWER
-
1
-
ASSEMBLY INSTRUCTIONS
SKU: HI-ET
Description : HILLSBORO ROUND NIGHT STAND END TABLE WITH DRAWER
Product Di ension : 23.7”x20”x28”
Cube Size : 28”x22.2”x10.8”
NW: 33 LBS
GW: 38.5 LBS
175 Southbelt Industrial Dr,
Houston, TX 77047
Email:[e-mail]

HILLSBORO ROUND NIGHT STAND END TABLE WITH DRAWER
-
2
-
Thank you for purchasing our product. This product has been designed for easy asse bly and long lasting use. Please take the
ti e to read and follow the asse bly instructions carefully.
Be sure to check all packing aterial carefully for s all parts that ay have co e loose inside the carton during ship ent.
Please separate, identify, and count all parts and etal hardware. Co pare with the part list to be sure all parts are present.
If the hardware is issing or you have difficulty asse bling this product, please call for us.
IMPORTANT NOTE:
-Place all wooden parts on a clean and s ooth surface such as a rug or carpet to avoid the parts fro being
scratched.
-Re ove all wrapping aterial, including staples & packing straps, before you start to asse ble.
-DO NOT tighten all screws and bolts until co pletely asse bled.
-Keep all hardware parts out of reach of children.
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please
ake sure you have the following parts:
NO Description Qt Sketch NO Description Qt Sketch
A Table Top 1
B Legs 4
C Middle Shelf 1
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please
ake sure you have all of the following hardware:
NO Description Qt Sketch NO Description Qt Sketch
1 Long bolt
(M6x60 ) 8
2 Screw
(M4x40 ) 4
3 Plat washer
(Φ6.5xΦ19 ) 8
4 Lock washer
(Φ6.5xΦ9 ) 8
5 Allen key
(M4)
1
BEFORE ASSEMBLY
PART LIST
HARDWARE LIST
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

HILLSBORO ROUND NIGHT STAND END TABLE WITH DRAWER
-
3
-
Slowly pull out Drawer of Table top (A) out as shown below.
Attach two Legs (B) to the Top (A) with long bolts (1) and washers (3), (4). Tighten with Allen key (5)
STEP 1
STEP 2

HILLSBORO ROUND NIGHT STAND END TABLE WITH DRAWER
-
4
-
Attach shelf (C) to the legs (B) with screws (2),Attach two Legs (B) to the shelf (C) and Table top (A)
with Bolt (1) and washers (3), (4). Tighten with Allen key (5), Tighten shelf with the screw driver as
shown below.
Flip the chest, Turn the Drawer into the chest one by one as shown below, put on flat
ground. Co plete the asse bly.
STEP
4
Screw Driver is not
included in package
STEP
3