Ecolink Z-Wave User manual

© 2013 Ecolink Intelligent Technology Inc. PN TLT-ZWAVE2 R1.02










© 2013 Ecolink Intelligent Technology Inc. PN TLT-ZWAVE2 R1.02





© 2013 Ecolink Intelligent Technology Inc. PN TLT-ZWAVE2 R1.02
Adhesive Tape:
Make sure that the desired mounting location on the door is clean and dry. The adhesive tape can withstand the temperature and humidity conditions of a typical garage.
However, it is recommended that the sensor be mounted when air or surface temperatures are not extreme. Installing the adhesive tape when the conditions are right
promotes a good long-lasting adhesive bond between the bracket and the surface of the door. Peel back the outer layer of one side of the adhesive tape, stick the tape to the
garage door and press firmly. Peel back the outer layer on the other side of the tape and press the mounting bracket firmly onto the adhesive tape.
Screws:
Place the mounting bracket in the desired position on the garage door. Use the mounting bracket as a template to mark the location of the screw holes with a pencil. Drill a small hole through each
of the marked locations. Use a screwdriver to fasten the mounting bracket to the door.

© 2013 Ecolink Intelligent Technology Inc. PN TLT-ZWAVE2 R1.02





© 2013 Ecolink Intelligent Technology Inc. PN TLT-ZWAVE2 R1.02