Edge Lighting Solid Back Shade MR16 User manual

SAVE THESE INSTRUCTIONS!
S6-_
- This product is ETL listed for indoor dry locations.
Installation Instructions for Solid Back Shade MR16
1
904-S6-03
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: [phone]
Fax: [phone]
www.edgelighting.com
[email protected]
A
Install the Accessory Shade in Chopper type Fixtures
2: Place the MR16 lamp into the louver holder base.
3: Place a hexcell louver (Optional) or a glass lens (Optional) or
a combination of a hexcell louver and a glass lens on the
front of MR16 lamp.
4: Replace and tighten the louver holder cap to the louver
holder base.
LOUVER
HOLDER BASE
LOUVER
HOLDER CAP
1: Unscrew and remove the louver holder cap from the louver
holder base.
B
LOUVER HOLDER BASE
MR16 LAMP
HEXCELL LOUVER
OR GLASS LENS
LOUVER HOLDER CAP
1
2
3
4
MR16 LAMP
ACCESSORY SHADE
5
5: Push the lamp pins completely into the socket holes.
C
SOCKET
© 2015 Edge Lighting. All Rights Reserved.

2
Install the Accessory shade in Vespa type MR16 Sockets
D
1
1
SPRING
CLIP HEAD
SOCKET
1: Push the spring clip completely onto the center of the socket
groove until it snaps into place.
E
2
2
SHADE
SOCKET
SPRING CLIP
2: Squeeze the spring clip ends while inserting it into the
shade.
F
MR16 LAMP
SOCKET
ACCESSORY SHADE
3: Push the lamp pins completely into the socket holes.
4: Place a hexcell louver (Optional) or a glass lens (Optional) or
a combination of a hexcell louver and a glass lens on the
front of MR16 lamp.
5: Replace and tighten the louver holder cap to the louver
holder base.
3
HEXCELL LOUVER
AND/OR GLASS LENS
CAP
4
5