SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
●Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
●Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
●All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
●Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
●Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
Page 2 of 3
ASSEMBLY INSTRUCTIONS
PREPARATION
Turn off the power at fuse or circuit box.
Turn on the power at fuse or circuit
box.
1. Install a bulb (not included).
See relamping label at socket
area or packaging for maximum
allowed wattage.
1
1
Bulb Type A
Max.60W
(not included)
2. Remove the rubber pads (CC)
and set screws (DD) from the
cover (A), then attach the cover
(A) to the fixture (B) , and secure
it with rubber pads (CC) and
set screws (DD).
2
DD
CC
A
B
3. Pull out the wires and grounding
wire from the post. Make wire
connections using the wire
connector (BB).
---The black wire from the fixture (B)
to the black wire from the post.
---The white wire from the fixture (B)
to the white wire from the post.
---The grounding wire from the fixture
(B) to the grounding wire from the
post.
1
3
BB
Post
4
A
B
AA
Post
4. Place the fixture (B) on the post,
and then secure it with the fitter
screws(AA).
CAUTION: With silicone
caulking compound, caulk
completely around where the
fitter meet with post surface
to prevent water from seeping
into the post.
