EdgeStar AVALLON User manual

EdgeStar, 8606 Wall St, Suite 1600, Austin, TX 78754
support.edgestar.com • [email protected] • edgestar.com
AVALLON Kickplate Replacement
Tools Needed
-Phillips Screwdriver
-12 MM Socket Driver or 12 MM Socket and a ratchet
NOTE: Empty contents of unit and disconnect from power source before attempting any repairs.
Step 1: Remove the front cabinet bracket
Lay the unit on its back
With a Phillips screwdriver, remove 5 of the 6 screws securing the cabinet bracket to the cabinet
Loosen the sixth screw and swing the bracket out of the way.
NOTE: If the 4 main silver screws are hard to remove with a screwdriver, a 12 MM socket can be used

EdgeStar, 8606 Wall St, Suite 1600, Austin, TX 78754
support.edgestar.com • [email protected] • edgestar.com
Step 2: Remove the kickplate mounting screws
With a Phillips screwdriver remove the 4 screws that secure the kick plate to the unit
Step 3: Remove the magnetic door sensor from the kickplate
Remove the screw from the wire clamp
Disconnect the electrical connectors from the back of the switch
Push the locking tabs in on the both sides of the switch to release it from the kickplate
Slide the sensor out through the top of the kickplate

EdgeStar, 8606 Wall St, Suite 1600, Austin, TX 78754
support.edgestar.com • [email protected] • edgestar.com
Step 4: Install the magnetic door sensor into the new kickplate
Slide the sensor in from the top of the kickplate until the locking tabs click and lock into place
Install the electrical connectors for the magnetic switch
Install the screw into the wire clamp
Step 5: Install the kickplate mounting screws
With a Phillips screwdriver install the 4 screws that secure the kick plate to the unit
Step 6: Install the front cabinet bracket
With a Phillips screwdriver, install the 5 screws securing the cabinet bracket to the cabinet
Tighten the screw that was left loose to swing the bracket out of the way

Procedure Completed!