EDIFIER W806BT User manual

W806BT
Headphones Bluetooth Stereo Headphone
Operating instructions

■ Overview
Before use the headphone, please carefully read this user manual and keep it for further reference.
Features
* Headband wireless headphone, fashionable and portable
* CSR technology with Bluetooth V4.0 for low power and high efficiency transmission
* Big capacity Li battery supports standby 800 hours and working 35 hours
* Φ40mm NdFeB unit for high resolution and graceful sound
* Ergonomic earlap design matches soft leather earcup and cushion for comfortable wear
* With automatically switching wire and wireless control
■ Specification
Bluetooth version
Bluetooth V4.0
Bluetooth protocols
HFP、HSP、A2DP、AVRCP
Effective distance
10m
Working time
35hrs
Standby time
About 800 hrs
Recharging input
DC 5.0V 500mA
Recharging time
3 hrs
Battery capacity
1400mAh Lithium ion Battery
Frequency response
20Hz-20KHz
Sensitivity(SPL)
100dB
Rated impedance
32 ohm
Audio input
Bluetooth, wired input
Note: Design and specifications are subject to change without notice.
■ Instruction
1. Illustration

1
Audio port
2
Volume increase/next track
3
Volume decrease/previous track
4
indicator
5
Multi-function key
6
microphone
7
Recharging port
Box content :Headphoneⅹ1 3.5mm audio cableⅹ1 USB charging cableⅹ1
User manualⅹ1
■ Operation
1. Recharging
During use, when you see red light flashing, it means the battery is low and you need to recharge the
headphone.
Red light on = Charging Red light off = fully charge
Recharging time: approx 3 hours.
Tips: W806BT headphone take a special design with short micro USB connect port based on the PCBA
requirement, it is normal that the some plug part exposing out when in charging.
Warning: The rechargeable batteries providing power for the product must be
properly disposed for recycling. Do not place the batteries into fire to prevent
explosion.
2. On/Off
Function
Operation
Indicator
ON
Pressand hold MFB key forabout 3 seconds
Blue light flashes
OFF
Pressand hold MFB key forabout 3 seconds
Red light flashes
Pair
Pressand hold MFB key forabout 5 seconds
Red and blue light flashing alternately
3. Pairing
(1) Power on the headphone, press and hold the multi-function key for about 5 seconds until red and
blue lights flash alternately, the headphone enter into pairing status.
(2) Enable Bluetooth function on your mobile phone and search for Bluetooth devices. Select “EDIFIER
W806BT” to pair and connect. When successfully connected, the blue light of the headphone flashes
slowly and the headphone has a prompt tone.

4. Function operation
Note:
(1) When use 3.5mm audio cable connecting, the headphone is in OFF status and the operation key
has no function.
(2) Enable voice function needs your mobile phone having voice function and in ON status.
(3) Remote play control (previous track/next track/pause/play) function need your mobile phone
supporting AVRCP protocol.
Function
Operation
Light/prompt tone
Music
Pause/play
Press multi-function key
-
Volume increase
Press volume increase key
Have a beep prompt tone in maximum
volume
Volume decrease
Press volume decrease key
-
Next track
Press and hold volume increase key
-
Previous track
Press and hold volume decrease
key
-
Call
Incoming
-
Have continuous beep prompt tone
Answer/end
Press multi-function key
Have a beep prompt tone
Reject
Press and hold multi-function key when
incoming a call
Have two beep prompt tone
Last number dial
press and hold multi-function key
Have extending beep prompt
tone
Enable voice function
Press multi-function key twice
-
Restore factory setting
Press and hold volume
increase/decrease key
Blue light quickly flashes three
times

■ Maintenance and repair
 During usage, please read the following suggestions which would help you follow the warranty terms and
make the product life longer.
 Keep the product dry and far from any damp places in order to avoid the affect on the product’s internal
circuit. You should avoid using the product during intense exercise or when you sweat too much.
 Do not place the product directly under the sun or where the temperature is high. High temperature will
shorten the electronic components’ life and damage batteries.
 Do not put the product at very cold places in order to prevent its internal circuit board from being
damaged.
Do not dismantle the product. Non-technician may damage the product.
 Do not drop, violently vibrate or strike the product with hard items in order to prevent its internal circuit
from being damaged.
Do not use strong chemical products or detergent to clean the headphone.
 Do not use any sharp items to scratch the product surface in order to prevent its casing from being
damaged. And its outlook from being affected.
 If the product cannot work properly, please send it to your qualified service organizations. The staff shall
help you with their whole heart.
■ FAQs
1. The red light flashes instead of the blue light.
Answer: It means the headphone battery has low power. You need to recharge the headphone.
2. The red light is off when charging.
Answer: a. Please ensure the connection between the charging device and the headphone works well.
b. The batteries wouldbe in the state of hibernate if the headphone isnot in use for a long time. It needs to be
recharged about 30 minutes. By then the red light will be on.
3. You cannot hear anything from the headphone.
Answer: a. Make sure the headphone is ON.
b. Make sure the headphone’s volume is correct.
c. Make sure the headphone is properly connected with your mobile.
d. Make sure if the headphone is too far away from your mobile or there is any interfere device nearby.
4. The call quality is not good.
Answer: a. Make sure if your mobile is in the area having strong signal.
b. The effective work range of the headphone is 10 meters. Make sure the headphone is within the effective work

range and there are no obstacles between the headphone and your mobile.
5. Why cannot the headphone pause, resume, go previous and next track when playing music.
Answer: These functions need the devices being paired with the headphone to support AVRCP protocol
(Audio/Video Remote Control Profile).
■ CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
A warning that batteries (battery pack or batteries installed)
shall notbe exposed to excessive heat such as sunshine,fire or the like.
1. “To prevent possible hearing damage, do not listen at high volume levels for long periods.”
2. “Fully understand user manual before use.”
3. “Ensure your player at low volume levels or power off before you leaving.”
Correct Disposal of this product. This marking indicates that this product should not be disposed with other
household disposal,recycleitresponsiblyto promotethesustainable reuse of material resources. To return
your used device, please usethereturnandcollectionsystemsor contacttheretailer where the product was
purchased. They can take this product for environmental safe recycling.

■ Warning!
 To guarantee your personal safety, please do not wearorkeepearphonesinthevicinity(closer than
10cm) of a pacemaker.
Do not insert plug into electric sockets.
 Supervise children when using the equipment, the product is not a toy.
Earphone listening at high volume levels – particularly, over extended periods of time – may damage
yourhearing.
Theoperationofswitchesonyourhi-fisystemor plugging in the earphones may cause clicks which at
highvolumesettingmayaffectyourhearing. Therefore, always set the volume control to minimum
before switching between different sources (tuner, turntable, CD player, etc.) or plugging in the
earphones.
 For traffic safety, do not use earphones while driving orcycling.
■ Customer Service
If any issues or needs when using the headphone, please feel free to CONTACT US via email:
[e-mail]. We’re always here ready to help, will get back to you in 12 hours.